Generation of lossy mode resonances by deposition of high-refractive-index coatings on uncladded multimode optical fibers
Fecha
2010Autor
Versión
Acceso abierto / Sarbide irekia
Tipo
Artículo / Artikulua
Versión
Versión aceptada / Onetsi den bertsioa
Impacto
|
10.1088/2040-8978/12/9/095503
Resumen
A comparative study of lossy mode resonances generated by depositing two different materials
is presented. The two materials selected are indium tin oxide (ITO) and indium oxide. The two
materials present different dielectric dispersion, which leads to the generation of single-peak
lossy mode resonances with the ITO coated optical fibers and dual-peak lossy mode resonances
with the In2O3 coat ...
[++]
A comparative study of lossy mode resonances generated by depositing two different materials
is presented. The two materials selected are indium tin oxide (ITO) and indium oxide. The two
materials present different dielectric dispersion, which leads to the generation of single-peak
lossy mode resonances with the ITO coated optical fibers and dual-peak lossy mode resonances
with the In2O3 coated optical fibers. The obvious advantage of a dual-peak based measurement
in the sensors field is enhanced by a sensitivity increase observed in sensors based on In2O3 if
compared with those based on ITO. These characteristics are analyzed both theoretically and
experimentally. [--]
Materias
Optical fiber sensors,
Thin films,
Resonances,
ITO,
Indium oxide
Editor
IOP Publishing Ltd
Publicado en
Journal of Optics, v. 12 (9); [7 p.]
Departamento
Universidad Pública de Navarra. Departamento de Ingeniería Eléctrica y Electrónica /
Nafarroako Unibertsitate Publikoa. Ingeniaritza Elektrikoa eta Elektronikoa Saila
Versión del editor
Entidades Financiadoras
This work was supported in part by the Spanish Ministry of Education and Science-CICYT-FEDER TEC2009-09210 and TEC2007-67987-C02-02/MIC Research Grants.