Show simple item record

dc.creatorUrtasun Erburu, Andonies_ES
dc.creatorBarrios Rípodas, Ernestoes_ES
dc.creatorSanchis Gúrpide, Pabloes_ES
dc.creatorMarroyo Palomo, Luises_ES
dc.date.accessioned2018-11-08T16:31:25Z
dc.date.available2018-11-08T16:31:25Z
dc.date.issued2015
dc.identifier.citationA. Urtasun, E. L. Barrios, P. Sanchis and L. Marroyo, "Frequency-Based Energy-Management Strategy for Stand-Alone Systems With Distributed Battery Storage," in IEEE Transactions on Power Electronics, vol. 30, no. 9, pp. 4794-4808, Sept. 2015. doi: 10.1109/TPEL.2014.2364861en
dc.identifier.issn0885-8993 (Print)
dc.identifier.issn1941-0107 (Electronic)
dc.identifier.urihttps://hdl.handle.net/2454/31356
dc.description.abstractDistributed generation is an attractive solution for stand-alone AC supply systems. In such systems, the installation of two or more energy-storage units is recommended for system redundancy and may also be required when there is a consumption increase following installation. However, energy management with multiple energy-storage units has been but vaguely analyzed in the literature and the few studies made are based on communication cables with a central supervisor. This paper proposes an energy management strategy for a multiple-battery system which makes it possible to avoid the use of communication cables, rendering the system more cost-effective and reliable. The strategy modifies the conventional droop method so that the power becomes unbalanced, allowing for the regulation of one or more battery voltages or currents, as required. Furthermore, whenever the frequency is high, the PV inverters reduce their power in order to prevent the battery from overcharge or high charging currents. On the other hand, whenever the frequency is low, then either the non-critical loads are regulated or the system stops in order to prevent the battery from over-discharge or high discharging currents. Simulation and experimental validation are performed for a system with two battery inverters, two PV inverters and a number of loads.en
dc.description.sponsorshipThis work was supported in part by the Spanish Ministry of Economy and Competitiveness under Grant DPI2013-42853-R, and by the Public University of Navarre through a doctoral scholarship.en
dc.format.mimetypeapplication/pdfen
dc.language.isoengen
dc.publisherIEEEen
dc.relation.ispartofIEEE Transactions on Power Electronics, vol. 30, no.9, pp. 4794-4808en
dc.rights© 2015 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting/republishing this material for advertising or promotional purposes, creating new collective works, for resale or redistribution to servers or lists, or reuse of any copyrighted component of this work in other work.en
dc.subjectBatteriesen
dc.subjectDistributed generationen
dc.subjectDroop controlen
dc.subjectEnergy managementen
dc.subjectHybrid systemen
dc.subjectPhotovoltaic poweren
dc.subjectStand-alone systemen
dc.titleFrequency-based energy management strategy for stand-alone systems with distributed battery storageen
dc.typeArtículo / Artikuluaes
dc.typeinfo:eu-repo/semantics/articleen
dc.contributor.departmentUniversidad Pública de Navarra. Departamento de Ingeniería Eléctrica y Electrónicaes_ES
dc.contributor.departmentNafarroako Unibertsitate Publikoa. Ingeniaritza Elektriko eta Elektronikoa Sailaeu
dc.rights.accessRightsAcceso abierto / Sarbide irekiaes
dc.rights.accessRightsinfo:eu-repo/semantics/openAccessen
dc.identifier.doi10.1109/TPEL.2014.2364861
dc.relation.projectIDinfo:eu-repo/grantAgreement/ES/1PE/DPI2013-42853-Ren
dc.relation.publisherversionhttps://doi.org/10.1109/TPEL.2014.2364861
dc.type.versionVersión aceptada / Onetsi den bertsioaes
dc.type.versioninfo:eu-repo/semantics/acceptedVersionen
dc.contributor.funderUniversidad Pública de Navarra / Nafarroako Unibertsitate Publikoaes


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record