Design of a groove gap waveguide to microstrip inline transition
Fecha
2019Autor
Versión
Acceso abierto / Sarbide irekia
Tipo
Contribución a congreso / Biltzarrerako ekarpena
Versión
Versión aceptada / Onetsi den bertsioa
Impacto
|
nodoi-noplumx
|
Resumen
In this paper the design of an inline transition between microstrip and groove gap waveguide operating at Wband is presented. The transition consists of two sections: a
tapered microstrip line and a Chebyshev transformer. The simplicity of this design makes this transition appropriate for MMIC packaging at millimeter frequencies and above. Experimental validation has been carried out in theW-ban ...
[++]
In this paper the design of an inline transition between microstrip and groove gap waveguide operating at Wband is presented. The transition consists of two sections: a
tapered microstrip line and a Chebyshev transformer. The simplicity of this design makes this transition appropriate for MMIC packaging at millimeter frequencies and above. Experimental validation has been carried out in theW-band. Good performance has been achieved: return loss better than 10 dB and mean insertion loss lower than 2 dB. [--]
Materias
Groove gap waveguide,
Transition,
Microstrip
Editor
IEEE
Publicado en
13th European Conference on Antennas and Propagation, EuCAP 2019 March 2019, Article number 8740046
Departamento
Universidad Pública de Navarra. Departamento de Ingeniería Eléctrica, Electrónica y de Comunicación /
Nafarroako Unibertsitate Publikoa. Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza Saila /
Universidad Pública de Navarra/Nafarroako Unibertsitate Publikoa. Institute of Smart Cities - ISC
Entidades Financiadoras
The authors would like to thank financial support by the Spanish MINECO, Project No. TEC2013-47753-C3-1-R and Project No. TEC2016-76997-C3-1-R.