Buscar
Mostrando ítems 1-10 de 11
Thermoelectric generators for waste heat harvesting: a computational and experimental approach
(Elsevier, 2017)
Artículo / Artikulua,
Waste heat generation has a widespread presence into daily applications, however, due to the low-temperature grade which presents, its exploitation with the most common technologies is complicated.
Thermoelectricity ...
Net thermoelectric power generation improvement through heat transfer optimization
(Elsevier, 2017)
Artículo / Artikulua,
Thermoelectric generation contributes to obtain a more sustainable energetic system giving its potential to harvest waste heat and convert it into electric power. In the present study a computational optimal net generation ...
Experimental and computational study on thermoelectric generators using thermosyphons with phase change as heat exchangers
(Elsevier, 2017)
Artículo / Artikulua,
An important issue in thermoelectric generators is the thermal design of the heat exchangers since it can improve their performance by increasing the heat absorbed or dissipated by the thermoelectric modules. Due to its ...
Determination of the symbolic base inertial parameters of planar mechanisms
(Elsevier, 2017)
Artículo / Artikulua,
The inertial information of a planar mechanical system is characterised using 4 inertial parameters per
solid. Due to the kinematic constraints, this parametrisation turns out be redundant. In order to reduce
the ...
Effect of the temperature in the mechanical properties of austenite, ferrite and sigma phases of duplex stainless steels using hardness, microhardness and nanoindentation techniques
(MDPI, 2017)
Artículo / Artikulua,
The aim of this work is to study the hardness of the ferrite, austenite and sigma phases of a UNS S32760 superduplex stainless steel submitted to different thermal treatments, thus leading to different percentages of the ...
Design and mechanical properties analysis of AA5083 ultrafine grained cams
(MDPI, 2017)
Artículo / Artikulua,
This present research work deals with the development of ultrafine grained cams obtained from previously ECAP (Equal Channel Angular Pressing)-processed material and manufactured by isothermal forging. The design and the ...
Analysis of fatigue and wear behaviour in ultrafine grained connecting rods
(MDPI, 2017)
Artículo / Artikulua,
Over the last few years there has been an increasing interest in the study and development
of processes that make it possible to obtain ultra-fine grained materials. Although there exists
a large number of published works ...
Analytical modelling of energy density and optimization of the EDM machining parameters of Inconel 600
(MDPI, 2017)
Artículo / Artikulua,
In this present research work, a new modelling of energy density in EDM (Electrical Discharge Machining) is proposed. Energy density can be defined as the amount of energy needed to get a unit volume of material removed, ...
CO2 emissions reduction and energy efficiency improvements in paper making drying process control by sensors
(MDPI, 2017)
Artículo / Artikulua,
The drying process of paper has many production parameters that can influence both the energy consumed and the characteristics of paper produced. It was found that most of the previous studies conducted on this process ...
Experimental bench for hemodynamic study of coronary artery with serial stenoses: fractional flow reserve assessment
(Taylor & Francis, 2017)
info:eu-repo/semantics/article,
The aim of this study was to develop an experimental hemodynamic bench to elucidate the influences of such geometrical parameters on the FFR assessment. As a first approach, the present work was focused on the influence ...