Buscar
Mostrando ítems 1-10 de 53
Revisión sobre nitruraciones láser de aleaciones de titanio
(CENIM, 2010)
Artículo / Artikulua,
Una técnica comúnmente utilizada para la mejora de la resistencia a desgaste de las aleaciones de titanio es la nitruración de la superficie, utilizando la deposición física o química de vapor, la implantación iónica o el ...
Análisis de la influencia del tratamiento térmico de envejecimiento en la modificación de las propiedades mecánicas de la aleación AA6060 procesada por ECAE
(CENIM, 2011)
Artículo / Artikulua,
En el presente trabajo se ha realizado un estudio de la modificación de las propiedades mecánicas de la aleación de aluminio AA6060 F, al ser deformada mediante deformación plástica severa empleando el proceso de extrusión ...
Revisión y estado del arte de la corrosividad del etanol y sus mezclas con gasolina
(CENIM, 2011)
Artículo / Artikulua,
Actualmente, el etanol se presenta como una fuente importante de combustible renovable para el sector de la automoción.
Se sabe que los carburantes tradicionales, como la gasolina, no han causado problemas de corrosión, ...
Kinematic design of a new four degree-of-freedom parallel robot for knee rehabilitation
(ASME, 2018)
Artículo / Artikulua,
Rehabilitation robots are increasingly being developed in order to be used by injured people to perform exercise and training. As these exercises do not need wide range movements, some parallel robots with lower mobility ...
Experimental study and optimization of thermoelectric-driven autonomous sensors for the chimney of a biomass power plant
(2014)
Artículo / Artikulua,
In the work discussed in this paper a thermoelectric generator was developed to harness waste heat from the exhaust gas of a boiler in a biomass power plant and thus generate electric power to operate a flowmeter installed ...
Computational study on the thermal influence of the components of a thermoelectric ice maker on the ice production
(Springer USTMSIEEE, 2012)
Artículo / Artikulua,
The main objective of this paper is to study the thermal resistances of two components of a thermoelectric ice maker installed in a no-frost refrigerator, in order to optimize the ice production. This study is conducted ...
Improvement of a thermoelectric and vapour compression hybrid refrigerator
(Elsevier, 2012)
Artículo / Artikulua,
This paper presents the improvement in the performance of a domestic hybrid refrigerator that combines vapour compression technology for the cooler and freezer compartments, and thermoelectric technology for a new compartment. ...
Experimental and computational study on thermoelectric generators using thermosyphons with phase change as heat exchangers
(Elsevier, 2017)
Artículo / Artikulua,
An important issue in thermoelectric generators is the thermal design of the heat exchangers since it can improve their performance by increasing the heat absorbed or dissipated by the thermoelectric modules. Due to its ...
Thermoelectric generators for waste heat harvesting: a computational and experimental approach
(Elsevier, 2017)
Artículo / Artikulua,
Waste heat generation has a widespread presence into daily applications, however, due to the low-temperature grade which presents, its exploitation with the most common technologies is complicated.
Thermoelectricity ...
Net thermoelectric power generation improvement through heat transfer optimization
(Elsevier, 2017)
Artículo / Artikulua,
Thermoelectric generation contributes to obtain a more sustainable energetic system giving its potential to harvest waste heat and convert it into electric power. In the present study a computational optimal net generation ...