Buscar
Mostrando ítems 1-10 de 18
Second-order nonlocal effects mitigation in Brillouin optical time-domain analysis sensors by tracking the Brillouin frequency shift profile of the fiber
(IEEE, 2017)
Artículo / Artikulua,
We report on an additional limitation that has been found in Brillouin optical time-domain analysis (BOTDA) sensors due to the so-called second-order nonlocal effects (NLE). Second-order NLE appear in BOTDA setups that ...
Compensation of nonlocal effects induced by the extinction ratio of pump pulses in Brillouin optical time-domain analysis sensors
(Optical Society of America, 2019)
Artículo / Artikulua,
We demonstrate a technique to compensate the nonlocal effects that appear in Brillouin optical time-domain analysis sensors when pump pulses with limited extinction ratio are deployed. These recently discovered nonlocal ...
Virtual FBGs using saturable absorbers for sensing with fiber lasers
(MDPI, 2018)
info:eu-repo/semantics/article,
The spectral narrowing of Fiber Bragg Gratings (FBGs) introduced by unpumped Er-doped fiber (EDF) was analyzed for fiber lasers (FL). Owing to spatial hole burning (SHB), the spectral response of a virtual FBG can be ...
Synthesis of Brillouin frequency shift profiles to compensate non-local effects and Brillouin induced noise in BOTDA sensors
(Optical Society of America, 2014)
Artículo / Artikulua,
We present a novel technique for Brillouin optical time domain analysis (BOTDA) sensors that simultaneously compensates non local effects and reduces Brillouin noise. The technique relies on the wavelength modulation of ...
Humidity sensor based on Bragg gratings developed on the end facet of an optical fiber by sputtering of one single material
(MDPI, 2017)
Artículo / Artikulua,
The refractive index of sputtered indium oxide nanocoatings has been altered just by changing the sputtering parameters, such as pressure. These induced changes have been exploited for the generation of a grating on the ...
Mode transition in complex refractive index coated single-mode–multimode–single-mode structure
(Optical Society of America, 2013)
Artículo / Artikulua,
By coating a single-mode–multimode–single-mode (SMS)
structure with a high refractive index thin-film it is possible to obtain a
transition of modes for specific combinations of thin-film thickness, thinfilm
refractive ...
Refractometric sensors based on multimode interference in a thin-film coated singlemode– multimode–single-mode structure with reflection configuration
(Optical Society of America, 2014)
Artículo / Artikulua,
Thin-film coated single-mode–multimode–single-mode (SMS) structures have been analyzed both theoretically
and experimentally with the aim of detecting different refractive indices. By adequate selection
of the thickness ...
46-km-long Raman amplified hybrid double-bus network with point and distributed Brillouin sensors
(IEEE, 2012)
info:eu-repo/semantics/article,
We experimentally demonstrate a 46-km hybrid network that combine point and distributed Brillouin sensors. The proposed sensor network multiplexes low-cost intensity point sensors based on fiber-optic tapers, which are ...
Dynamic BOTDA measurements based on Brillouin phase-shift and RF demodulation
(Optical Society of America, 2012)
Artículo / Artikulua,
We demonstrate a novel dynamic BOTDA sensor based, for the first time to our knowledge, on the use of the Brillouin phase shift in addition to the conventional Brillouin gain. This provides the advantage of measurements ...
Brillouin optical time-domain analysis sensor with pump pulse amplification
(Optical Society of America, 2016)
Artículo / Artikulua,
We demonstrate a simple technique to provide conventional Brillouin optical time-domain analysis sensors with mitigation for pump pulse attenuation. The technique is based on operating the sensor in loss configuration so ...