Simulator of a LIDAR sensor for a wind turbine control application
Consultable a partir de
2025-02-01
Fecha
2020Autor
Versión
Acceso embargado 5 años / 5 urteko bahitura
Tipo
Trabajo Fin de Grado/Gradu Amaierako Lana
Impacto
|
nodoi-noplumx
|
Resumen
El presente Trabajo Fin de Grado tiene como objetivo el diseño de un simulador de un
sensor LIDAR colocado sobre la nacelle. Para llevar a cabo dicha tarea, se seguirán los
siguientes pasos:
− Estudio bibliográfico de las distintas fuentes de error inherentes al empleo de este tipo
de sensor LIDAR. Identificación del origen de los errores y análisis sobre su modelado.
− Generación de campos ...
[++]
El presente Trabajo Fin de Grado tiene como objetivo el diseño de un simulador de un
sensor LIDAR colocado sobre la nacelle. Para llevar a cabo dicha tarea, se seguirán los
siguientes pasos:
− Estudio bibliográfico de las distintas fuentes de error inherentes al empleo de este tipo
de sensor LIDAR. Identificación del origen de los errores y análisis sobre su modelado.
− Generación de campos de vientos turbulentos mediante el empleo de TurbSim.
− Diseño del simulador, en Simulink, con el objetivo de implementar los modelos de las
distintas fuentes de error mencionadas. El simulador es compatible con FAST
permitiendo la simulación en tiempo real para el control de un aerogenerador.
− Evaluación de los resultados e identificación de las fuentes de error más relevantes que
separan la señal del viento efectivo.
− Introducción de objetivos para el proceso de reconstrucción de la señal medida. [--]
The following Final Degree Project has been devoted to the design of a realistic simulator
of a nacelle mounted LIDAR sensor. In order to accomplish this objective, the following steps
have been followed:
− Bibliographic study of the sources of error derived from the use of this type of LIDAR
sensor. Identification of the origin of the errors and extraction of some ideas for their
modeling.
...
[++]
The following Final Degree Project has been devoted to the design of a realistic simulator
of a nacelle mounted LIDAR sensor. In order to accomplish this objective, the following steps
have been followed:
− Bibliographic study of the sources of error derived from the use of this type of LIDAR
sensor. Identification of the origin of the errors and extraction of some ideas for their
modeling.
− Generation of synthetic wind turbulent fields by means of TurbSim.
− Simulator design, in Simulink, by the implementation of the mentioned sources of error
models. The simulator is compatible with FAST enabling its application on a real time
wind turbine control simulation.
− Evaluation of the results and identification of the most relevant sources of error
depending on the deviation from the effective wind introduced.
− Presentation of some guidelines for the reconstruction process of the measured signal. [--]
Materias
Sensor LIDAR,
Simulador,
FAST,
Control de aerogeneradores,
LIDAR sensor,
Simulator,
FAST,
Wind turbine control
Titulación
Graduado o Graduada en Ingeniería en Tecnologías Industriales por la Universidad Pública de Navarra /
Industria Teknologietako Ingeniaritzan Graduatua Nafarroako Unibertsitate Publikoan