Person:
Gómez Laso, Miguel Ángel

Profile Picture

Email Address

Birth Date

Research Projects

Organizational Units

Job Title

Last Name

Gómez Laso

First Name

Miguel Ángel

person.page.departamento

ORCID

0000-0003-1371-0610

person.page.upna

2553

Name

Filters

2022 - 20242
Reset filters

Settings

Author: Santiago Arriazu, David × Subject: Bandpass filter ×

Search Results

Now showing 1 - 2 of 2
  • Thumbnail Image
    PublicationOpen Access
    W-band filtering antenna based on a slot array and stacked coupled resonators using gap waveguide technology
    (IEEE, 2024) Santiago Arriazu, David; Fang, Mu; Zaman, Ashraf Uz; Gómez Laso, Miguel Ángel; Lopetegui Beregaña, José María; Arregui Padilla, Iván; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza; Institute of Smart Cities - ISC
    This letter proposes a new design approach for filtering antennas. The novel matching reflection coefficient based method allows the integration of filters and antennas without compromising the frequency behavior of either of these components. Moreover, this integration is done avoiding the need of lengthy optimization processes and provides a high degree of flexibility in the types of antennas that can be used. In order to validate it, two examples are provided. In both cases, a 4 th -order Chebyshev bandpass filter at 101.5 GHz implemented in stacked groove gap waveguide (GGW) configuration is used, firstly along with a single aperture antenna and, subsequently, with a slotted ridge gap waveguide (RGW) array. This second example has been manufactured to demonstrate the usefulness of the new design methodology. Excellent measured performance has been obtained for a filtering antenna at W-band for the first time.
  • Thumbnail Image
    PublicationOpen Access
    Robust design of 3D-printed W-band bandpass filters using gap waveguide technology
    (Springer, 2022) Santiago Arriazu, David; Tamayo-Domínguez, Adrián; Gómez Laso, Miguel Ángel; Lopetegui Beregaña, José María; Fernández-González, José Manuel; Martínez, Ramón; Arregui Padilla, Iván; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    In this paper, a W-band 3D-printed bandpass filter is proposed. The use of higher-order TE10n modes in groove gap waveguide (GGW) technology is evaluated in order to alleviate the manufacturing requirements. In addition to the use of higher-order modes, the coupling between them is analyzed in detail to improve the overall fabrication robustness of the component. This allows the implementation of narrow-band filters operating at millimeter-wave frequency bands (or above), which usually demand complex manufacturing techniques to provide the high accuracy required for this kind of devices. In order to show the applicability of the proposed method, a narrow-band 5th-order Chebyshev bandpass filter centered at 94 GHz, which can be easily fabricated by state-of-the-art stereolithographic (SLA) 3D-printing techniques followed by silver coating, is shown. Excellent measured performance has been obtained.