Díaz Lucas, Silvia

Loading...
Profile Picture

Email Address

Birth Date

Job Title

Last Name

Díaz Lucas

First Name

Silvia

person.page.departamento

Ingeniería Eléctrica, Electrónica y de Comunicación

person.page.instituteName

ISC. Institute of Smart Cities

person.page.observainves

person.page.upna

Name

Search Results

Now showing 1 - 2 of 2
  • PublicationOpen Access
    46-km-long Raman amplified hybrid double-bus network with point and distributed Brillouin sensors
    (IEEE, 2012) Fernández Vallejo, Montserrat; Olier Aguado, David; Zornoza Indart, Ander; Pérez Herrera, Rosa Ana; Díaz Lucas, Silvia; Elosúa Aguado, César; Bariáin Aisa, Cándido; Loayssa Lara, Alayn; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
    We experimentally demonstrate a 46-km hybrid network that combine point and distributed Brillouin sensors. The proposed sensor network multiplexes low-cost intensity point sensors based on fiber-optic tapers, which are able to measure vibrations in the 0.01 to 50 Hz frequency range. The sensor network with a double-bus is a low noise configuration, which offers a higher optical signal to noise ratio and dynamic range than a single-bus. Thus, the number of sensors to be multiplexed could increase or we could reach further distances. The system also deploys remote distributed Raman amplification to extend the sensing range.
  • PublicationOpen Access
    Stable multi-wavelength erbium fiber ring laser with optical feedback for remote sensing
    (IEEE / OSA, 2015) Díaz Lucas, Silvia; Leandro González, Daniel; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
    In this work, we demonstrate a stable fiber sensing system for remote temperature measurements, where the sensing element is an array of four fiber Bragg gratings (FBGs) and sensor interrogation is achieved with a multi-wavelength erbium fiber ring laser. By introducing a feedback fiber loop in a fiber ring cavity, four laser emission lines were obtained simultaneously in single-longitudinal mode operation (SLM). The power instability obtained was lower than 0.5 dB with an optical signal-to-noise ratio (OSNR) higher than 50 dB for all the emitted wavelengths. The application of this system for remote temperature measurements has been demonstrated even though the SLM regime cannot be preserved.