Open Access
Investigation on the working point of slope-assisted dynamic Brillouin distributed fiber sensing
(SPIE, 2019) Feng, Cheng; Mariñelarena Ollacarizqueta, Jon; Schneider, Thomas; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
In this paper, an investigation on the working point of slope-assisted dynamic distributed Brillouin sensing is presented. A comparison has been carried out between the sensing performances achieved at the inflection point and the 3 dB point of the Brillouin gain spectrum. Besides the intrinsic 13.1% frequency-to-amplitude sensitivity enhancement and a higher signal level, the dynamic sensing at the inflection point can achieve a doubled in maximum and in average a 36.8% wider dynamic range with much better working point symmetry. Simulations with strain signals also demonstrate that, compared to the 3 dB point, the average error at the inflection point can be significantly reduced to only 27.7%. As shown in this work, by a simple shift of the working point from the 3 dB to the inflection point, slope-assisted dynamic sensing can be well enhanced.
Open Access
In-field torsion measurements on solar trackers using fiber optic sensors
(Optica, 2020) Leandro González, Daniel; Bravo Acha, Mikel; Júdez Colorado, Aitor; Mariñelarena Ollacarizqueta, Jon; Falcone Lanas, Francisco; Loayssa Lara, Alayn; López-Amo Sáinz, Manuel; Jiménez, S.; Achaerandio, Álvaro; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Gobierno de Navarra / Nafarroako Gobernua
In-field torsion measurements on solar trackers using fiber Bragg gratings are presented. 45 FBG sensors have been deployed in an operational solar energy plant to study the mechanical response of the structure to wind.
Open Access
Linearly-configured BOCDA system with large modulation amplitude using dual-probe wave
(Optical Society of America, 2018) Mariñelarena Ollacarizqueta, Jon; Kim, Yong Hyun; Loayssa Lara, Alayn; Song, Kwang Yong; Institute for Advanced Materials and Mathematics - INAMAT2; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
We present and experimentally demonstrated a linearly-configured Brillouin optical correlation domain analysis (LC-BOCDA) system that allows large modulation amplitude (Δf) based on a dual probe wave and the control of correlation-order. The adoption of dual probe and the control of correlation-order can suppress the effects of two main origins of the noise - the Brillouin loss of the pump and the beat noise between the pump and probe waves. We experimentally confirm that Δf and the number of resolving points, N, can be increase to 1.8 times without significant noise.
Open Access
Pulse coding linearization for Brillouin optical time-domain analysis sensors
(Optical Society of America, 2018) Mariñelarena Ollacarizqueta, Jon; Iribas Pardo, Haritz; Loayssa Lara, Alayn; Institute of Smart Cities - ISC
We introduce a simple method to extend the performance of pulse coding techniques in their application to Brillouin optical time-domain analysis sensors (BOTDA). It is based on applying a simple logarithmic processing on the detected probe wave that compensates the deviation from linearity of the sensor response for long code lengths. The technique ensures that the accumulated effect of a sequence of pulses is equal to the linear addition of the effects of the individual components, which is the essential condition to ensure a correct decoding of the probe gain measurement. We experimentally demonstrate the compensation of the Brillouin frequency shift error induced by the accumulated gain nonlinearity. Furthermore, a proof-of-concept 80 km sensing link within a total 200 km fiber loop demonstrated a better than 2 MHz precision with 2 m spatial resolution.
Open Access
Medida de torsión en seguidores solares con sensores de fibra óptica
(SEDOPTICA, 2021) Leandro González, Daniel; Bravo Acha, Mikel; López-Amo Sáinz, Manuel; Loayssa Lara, Alayn; Júdez Colorado, Aitor; Mariñelarena Ollacarizqueta, Jon; Falcone Lanas, Francisco; Jiménez Romero, Sergio; Moriana García, Iñaki; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación; Gobierno de Navarra / Nafarroako Gobernua WINDSOLAR (0011-1365-2017-000122)
En este trabajo se ha monitorizado la torsión sufrida por una estructura de seguidores solares empleando sensores de fibra óptica. Estas medidas de campo se han obtenido con una red de sensores formada por 45 redes de difracción de Bragg en una huerta solar activa. Estos resultados, correlados con la velocidad y dirección del viento permitirían aumentar la eficiencia de los seguidores y ayudar a entender y prevenir efectos negativos relacionados con inestabilidades aeroelásticas.
Open Access
Zuntz optikoan oinarritutako sentsoreen prestazioen muga-efektu berria, egituren egoera monitorizatzea helburu
(Udako Euskal Unibertsitatea, 2017) Iribas Pardo, Haritz; Mariñelarena Ollacarizqueta, Jon; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
Brillouin denbora-eremu optikoaren analisian (BOTDA) oinarritutako sentsoreak estruktura handien (120 km luzerako estrukturak) deformazioa eta tenperatura neurtzeko gaitasuna dute, metro bateko bereizmen espazialarekin. Lan honetan, sentsorearen merkatu-prezioa handitu gabe bereizmen espazial txikiagoa lortzeko beharrezkoa litzatekeen teknika erabiltzeak dituen efektu kaltegarriak aztertu egin dira. Izan ere, pultsu azkar bat sortzeko beharrezkoak diren Mach-Zehnder modulagailu elektrooptikoek iraungitze-ratio (ER) txikia dute. Horiek horrela, aztertu egin da pultsatutako seinalea sortzeko sorgailuak duen ERaren eragina BOTDA sentsoreen prestazioetan, akats handiak sortzen direla ondorioztatuz.
Open Access
Effects of pump pulse extinction ratio in Brillouin optical time-domain analysis sensors
(Optical Society of America, 2017) Iribas Pardo, Haritz; Mariñelarena Ollacarizqueta, Jon; Feng, Cheng; Urricelqui Polvorinos, Javier; Schneider, Thomas; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
We report on two previously unknown non-local effects that have been found to impair Brillouin optical time-domain analysis (BOTDA) sensors that deploy limited extinction ratio (ER) pump pulses. The first one originates in the increased depletion of the pedestal of the pump pulses by the amplified probe wave, which in turn entails a reduced amplification of the probe and a measurement distortion. The second effect is due to the interplay between the transient response of the erbium-doped fiber amplifiers (EDFA) that are normally deployed to amplify the pump and the pedestal of the pump pulses. The EDFA amplification modifies the pedestal that follows the pulses in such a way that it also leads to a distortion of the measured gain spectra after normalization. Both effects are shown to lead to non-local effects in the measurements that have similar characteristics to those induced by pump pulse depletion. In fact, the total depletion factor for calculations of the Brillouin frequency shift (BFS) error in BOTDA sensors is shown to be the addition of the depletion factors linked to the pump pulse as well as the pedestal. A theoretical model is developed to analyze both effects by numerical simulation. Furthermore, the effects are investigated experimentally in long-range BOTDA sensors. The pedestal depletion effect is shown to severely constrain the probe power as well as the minimum ER of the pulses that can be deployed in BOTDA sensors. For instance, it is shown that, in a long-range dual-probe BOTDA, an ER higher that 32-dB, which is above that provided by standard electro-optic modulators (EOM), is necessary to be able to deploy a probe power of -3 dBm, which is the theoretical limit for that type of sensors. Even more severe can be the limitation due to the depletion effect induced by the EDFA transient response. It is found that the impairments brought by this effect are independent of the probe power, hence setting an ultimate limit for the BOTDA sensor performance. Experimentally, a long-range BOTDA deploying a 26-dB ER EOM and a conventional EDFA is shown to exhibit a BFS error higher than 1 MHz even for very small probe power.
Open Access
Structural health monitoring of solar trackers using distributed fiber optic sensors
(SPIE, 2019) Mariñelarena Ollacarizqueta, Jon; Mompó Roselló, Juan José; Zurita Gabasa, Jesús; Urricelqui Polvorinos, Javier; Júdez Colorado, Aitor; López-Amo Sáinz, Manuel; Jiménez Romero, Sergio; Achaerandio, Álvaro; Loayssa Lara, Alayn; Institute of Smart Cities - ISC; Gobierno de Navarra / Nafarroako Gobernua, 0011-1365-2017-000122; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
We demonstrate the application of a novel type of distributed fiber optic sensors (DFOSs) to dynamically monitor the effects of wind on solar tracker structures used in photovoltaic power stations. This DFOS is based on the stimulated Brillouin scattering nonlinear optical effect in optical fiber, which can be used to measure the distribution of strain and temperature along a given structure. However, contrary to existing solutions, the sensor provides dynamic real-time measurements with hundreds or even thousands of full simultaneous measurements for all positions in the fiber each second. Moreover, high-precision and high spatial resolution are obtained. This so-called dynamic Brillouin optical time-domain analysis (D-BOTDA) sensor provides real-time monitoring of the bending and torsion of the structure of solar trackers in response to wind load. This helps the solar tracker manufacturer asses and improve the mechanical designs so as to introduce corrective measures and develop cost-effective components that properly withstand the effects of wind at any given location. We experimentally demonstrate the application of a D-BOTDA sensing system to measure distributed bending and, for the first time to our knowledge, also distributed torsion along the stressed beam of the solar tracker. For this purpose, we have developed a procedure to instrument the torsion beam with two optical sensing fibers that are fixed helically wound along the beam in opposite directions, so that any common-mode thermal or bending effects are removed. We initially performed tests in a laboratory facility in which sections of the torsion beam could be subjected to controlled moments. Static and dynamic loads were applied and the measured deformations were compared to those obtained with fiber Bragg gratings, which just provide point measurements of strain. In both cases, full agreement was demonstrated. Finally, the system was installed in an operational solar park.
Open Access
Non-local effects in Brillouin optical time-domain analysis sensors
(MDPI, 2017) Iribas Pardo, Haritz; Urricelqui Polvorinos, Javier; Mompó Roselló, Juan José; Mariñelarena Ollacarizqueta, Jon; Loayssa Lara, Alayn; Institute of Smart Cities - ISC; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
Brillouin optical time-domain analysis (BOTDA) sensors have great potential to provide distributed measurements of temperature and strain over large structures with high spatial resolution and measurement precision. However, their performance ultimately depends on the amount of probe and pump pulse power that can be injected into the sensing fiber, which determines the signal-to-noise ratio of the detected measurement signal. The probe wave power is constrained by the generation of noise induced by spontaneous Brillouin scattering and at lower power by the so-called non-local effects. In this work, we focus on the latter. We review the physical origins of non-local effects and analyze the performance impairments that they bring. In addition, we discuss the different methods that have been proposed to counteract these effects comparing their relative merits and ultimate performance. Particularly, we focus on a technique that we have devised to compensate non-local effects which is based on introducing an optical frequency modulation or dithering to the probe wave. This method is shown to provide a comprehensive solution to most of the impairments associated with non-local effects and also to enable some side benefits, such as amplification of the pump pulses to compensate the attenuation of the fiber.
Open Access
Contributions to the development of Brillouin distributed sensors for structural health monitoring
(2019) Mariñelarena Ollacarizqueta, Jon; Loayssa Lara, Alayn; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa; Gobierno de Navarra / Nafarroako Gobernua
The main objectives of this thesis is to contribute to the enhancement of the performance of distributed optical ber sensors (DOFS) based on stimulated Brillouin scattering (SBS) by analyzing their limitations and proposing solutions to overcome their current constraints. The dissertation has been focused on improving different aspects of dynamic and static Brillouin optical time-domain analysis (BOTDA) and Brillouin optical coherent-domain analysis (BOCDA) sensors. Moreover, this research work has tried to contribute to reduce the existing gap between the investigation of DOFS and their industrial applications, demonstrating the capability of these sensors to provide efficient and valuable measurements in real application scenarios. In particular, the objectives of this dissertation are: -Enhance the signal-to-noise ratio (SNR) constraints faced by of BOTDA sensors by proposing alternative setups or post-processing solutions to achieve better performance. -Analyze and study the dynamic self-heterodyne detection BOTDA sensor recently presented by our research group to try to improve its performance by proposing solutions to their constraints and alternative setups. -Research on the limitations of a particular single-ended access BOCDA sensor setup with the aim of enhancing its performance. -Design, develop and implement novel measuring systems to deploy the investigated DOFS in real applications and demonstrate their capabilities.