Person:
Carlosena García, Alfonso

Profile Picture

Email Address

Birth Date

Research Projects

Organizational Units

Job Title

Last Name

Carlosena García

First Name

Alfonso

person.page.departamento

ORCID

0000-0002-7146-4043

person.page.upna

370

Name

Filters

2021 - 20235
Reset filters

Settings

Author: Martincorena Arraiza, Maite × Item Type: Publication ×

Search Results

Now showing 1 - 5 of 5
  • Thumbnail Image
    PublicationOpen Access
    Micropower class AB low-pass analog filter based on the super-source follower
    (IEEE, 2022) Martincorena Arraiza, Maite; Cruz Blas, Carlos Aristóteles de la; López Martín, Antonio; Carlosena García, Alfonso; Institute of Smart Cities - ISC
    An improved class AB version of the super source follower is used to implement a compact and power-efficient second order analog low-pass filter. The proposed circuit achieves a 41% power reduction as well as an improvement in linearity and pass band gain with respect to its class A counterpart. Measurement results of a test chip prototype fabricated in a 180 nm CMOS technology show a power consumption ranging from 50.3 μW to 85.27 μW for cutoff frequencies from 600 kHz to 890 kHz, with a supply voltage of ±0.75 V. A third order intermodulation distortion of −35.34 dB (for an input signal of 0.4 mV pp and 350 kHz) and a THD of −69.7 dB (for an input signal of 0.4 mV pp and 100 kHz) are measured, which results in an improvement with respect to the conventional class A version of 13.98 dB and 43.6 dB, respectively. The silicon area is 0.0592 mm 2 (using external capacitors).
  • Thumbnail Image
    PublicationOpen Access
    AC coupled amplifier with a resistance multiplier technique for ultra-low frequency operation
    (Elsevier, 2022) Martincorena Arraiza, Maite; Cruz Blas, Carlos Aristóteles de la; Carlosena García, Alfonso; López Martín, Antonio; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    This paper proposes a novel, tunable AC coupled capacitive feedback amplifier, exhibiting an ultra-low high pass corner frequency. This is accomplished by actively boosting the output resistive value of a MOS transistor in weak inversion. The circuit is based on a more general architecture, recently proposed by the authors, and is analyzed in terms of its capability to achieve ultra-low frequency operation, its DC performance, and noise. The proposed technique is demonstrated via measurement results from a fabricated test chip prototype using a standard 0.18 µm CMOS technology. The proposed amplifier provides a tunable high pass corner frequency from 20 mHz to 475 mHz, consuming 4.71 μW and a total area of 0.069 mm2.
  • Thumbnail Image
    PublicationOpen Access
    A family of alternating current amplifiers for ultra-low frequency operation
    (Wiley, 2021) Martincorena Arraiza, Maite; Carlosena García, Alfonso; Cruz Blas, Carlos Aristóteles de la; Beloso Legarra, Javier; López Martín, Antonio; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    A family of capacitively coupled alternating current (AC) amplifiers featuring ultra-low (below 1 Hz) corner frequency is presented. This is achieved by using high-gain devices which actively boost feedback resistance and thus reduce corner frequency. This procedure is often termed, though with a different purpose, as 'bootstrapping'. The proposed architectures are very general and admit several possible practical implementations. To demonstrate their usefulness, the circuits are implemented with two operational amplifiers (OA), but other active devices such as operational transconductance amplifiers (OTAs) can be alternatively used. All circuits have been theoretically analyzed, extensively simulated and measured, exhibiting high-pass cutoff frequencies as low as 30 mHz.
  • Thumbnail Image
    PublicationOpen Access
    Very-low frequency capacitively coupled AC amplifier with a current feedback operational amplifier
    (Wiley, 2023) Beloso Legarra, Javier; Cruz Blas, Carlos Aristóteles de la; Carlosena García, Alfonso; Martincorena Arraiza, Maite; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    In this paper, we propose the idea of using transimpedance amplifiers, in lieu of operational amplifiers (OAs) or transconductance amplifiers (OTAs) to design capacitively coupled AC amplifiers. The idea is demonstrated with a current feedback operational amplifier (CFOA) as an active element, which is actually an architecture consisting of voltage buffers and current copiers (mirrors). This last characteristic is further exploited to make the corner frequency of the AC amplifier tunable by means of bootstrapping low-valued resistors with the output buffer. It is particularly suited to achieve very-low corner frequencies as needed in applications such as bio- or seismic signals. The idea is demonstrated with simulations and experimental results with a discrete implementation.
  • Thumbnail Image
    PublicationOpen Access
    AC amplifiers with ultra-low corner frequency by using bootstrapping
    (Institution of Engineering and Technology, 2021) Martincorena Arraiza, Maite; Carlosena García, Alfonso; Cruz Blas, Carlos Aristóteles de la; López Martín, Antonio; Ingeniería Eléctrica y Electrónica; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
    A novel architecture for an AC (i.e. high-pass) amplifier is proposed allowing a drastic reduction of the cutoff frequency to the sub-Hertz range. It builds upon the classic AC configuration with a high gain amplifier and a parallel RC circuit in the feedback loop, by increasing the feedback resistance through bootstrapping. Resistance multiplying factors higher than four orders of magnitude are easily achievable. The basic principle can be applied to several practical implementations, though in this letter it is demonstrate with measurement results of an op-amp based discrete implementation.