Torrez Herrera, Jonathan Josué

Profile Picture

Email Address

person.page.identifierURI

https://academica-e.unavarra.es/handle/2454/50094

Birth Date

Job Title

Last Name

Torrez Herrera

First Name

Jonathan Josué

person.page.departamento

Ciencias

person.page.instituteName

ORCID

person.page.observainves

751465

person.page.upna

811673

Name

Filters

2021 - 20222
Reset filters

Settings

Author: Gil Bravo, Antonio × Subject: Dry reforming of methane ×

Search Results

Now showing 1 - 2 of 2
  • Thumbnail Image
    PublicationOpen Access
    A comparative study of the catalytic performance of nickel supported on a hibonite-type La-hexaaluminate synthesized from aluminum saline slags in the dry reforming of methane
    (Elsevier, 2022) Torrez Herrera, Jonathan Josué; Korili, Sophia A.; Gil Bravo, Antonio; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Ciencias; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    In this work, a hibonite-type Ni/La-hexaaluminate (Ni/LHA) synthesized from an industrial waste is used and compared as catalyst in the dry reforming of methane (DRM) at 973 K. The structure, catalytic behavior, and stability during a run time of at least 50 h of three Nicatalysts obtained from two commercial supports and two preparation methods were used for comparison. An aluminum solution (9.40 g/L) obtained from an aluminum saline slag waste by acid extraction was used to synthesize the hexaaluminate by mixing with a stoichiometric amount of lanthanum nitrate and methanol/Peg400/PegMn400 under hydrothermal conditions at 493 K for 16 h. The Ni/LHA catalyst (10 wt% NiO) was obtained by impregnation of the synthesized support, calcined previously at 1473 K for 2 h. The resulting solids were characterized by several techniques as: X-ray diffraction (XRD), N2 adsorption at 77 K, temperature-programmed reduction (TPR), scanning electron microscopy (SEM) and transmission electron microscopy (HR-TEM). In order to compare the catalytic behavior and properties of the Ni/LHA catalyst, three Ni catalysts obtained from two commercial supports (g-Al2O3 and SiO2) and two preparation methods (wet impregnation (I) and precipitation-deposition (PD)) were synthesized. Analysis of the TPR patterns for the catalysts allowed the type of metal support interaction and NiO species to be determined, with a weak interaction with the support being observed in Ni/LHA and NieI/ SiO2. The NiO species observed, with crystallite sizes between 9.7 and 40.4 nm, confirm the X-ray structural analyses. The Ni/LHA catalyst was found to be active and very stable in the DRM reaction after 50 h. The catalytic behavior was evaluated from the CO2 and CH4 conversions, as well as the H2/CO selectivity, with values of 99% over almost all the time range evaluated. The behavior of this catalyst is comparable to that of NieI/Al2O3 and NiPD/SiO2. The results found indicating that the strong interaction of nickel with the support favors the stability of the catalysts in the DRM reaction.
  • Thumbnail Image
    PublicationOpen Access
    Structure and activity of nickel supported on hibonite-type La-hexaaluminates synthesized from aluminum saline slags for the dry reforming of methane
    (Elsevier, 2021) Torrez Herrera, Jonathan Josué; Korili, Sophia A.; Gil Bravo, Antonio; Institute for Advanced Materials and Mathematics - INAMAT2; Ciencias; Zientziak; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    This work describes the procedures followed to obtain four hibonite-type La-hexaaluminates (La-HA) using aluminum saline slag waste as the aluminum source. Briefly, an acid-extracted aluminum solution (8.9 gAl/L) was used to synthesize the hexaaluminate by mixing with a stoichiometric amount of lanthanum nitrate and 2-propanol/polyethylene glycol/methanol/1-hexanol/glucose depending on the hydrothermal conditions of the synthesis. The results showed the formation of pure-phase hexaaluminate at 1473 K in all cases, with differences in the textural properties between the materials. The solids obtained were used as supports for nickel catalysts (10 wt.%) for the dry reforming of methane (DRM) at 973 K. The supports and catalysts were characterized by X-ray diffraction (XRD), N2 adsorption at 77 K, X-ray fluorescence (XRF), temperature-programmed reduction (TPR), scanning electron microscopy (SEM) and transmission electron microscopy (HR-TEM). An effect of the textural properties, dispersión of the metallic phase and nickel-support interaction on the performance of the catalyst was found. Our results also show a new application of a catalyst synthesized from an industrial waste such as aluminum saline slags.