Open Access
Aluminum coated fiber optic sensor for enhancing flow rate measurement
(SPIE, 2023) Rodríguez Rodríguez, Armando; Urroz Unzueta, José Carlos; Diéguez Elizondo, Pedro; Bravo Acha, Mikel; López-Amo Sáinz, Manuel; López Rodríguez, José Javier; Ingeniería; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
A water flow and velocity aluminum-coated Fiber Bragg Grating sensor system for open channels was designed, simulated and tested. The sensing head was designed, ruggedized and customized to measure velocities at different depths, in order to calculate the discharge in open channels. This paper shows, for the first time to our knowledge, the simulation of such kind of fiber sensors in open channels.
Open Access
Torsion sensor using a high-birefringence nine-hole optical fiber
(IEEE, 2025-07-03) Rodríguez Rodríguez, Armando; Vento Álvarez, José Raúl; Galarza Galarza, Marko; Vanegas Tenezaca, Evelyn Dayanara; Schuster, Kay; Bravo Acha, Mikel; López-Amo Sáinz, Manuel; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza; Institute of Smart Cities - ISC; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
This article presents a novel high-birefringence fiber-based torsion sensor based on a microstructured optical fiber with nine holes and seven cores microstructured holes and cores optical fiber (MHCF) embedded into a Sagnac interferometer (SI). A segment of this fiber is inserted into a symmetric SMF-MMF-MHCF-MMF-SMF arrangement, which provides efficient coupling to the multiple cores of the birefringent fiber and, consequently, multimode interference (MMI). Fast Fourier transform (FFT) spectral data analysis is employed to enhance measurement stability and reduce dependence on optical source variations. The sensor demonstrates a linear response to torsion angles between −50◦ and +50◦ , with a 16-mrad/◦ sensitivity. The high sensitivity and good linearity of the sensor are enhanced through the application of machine learning (ML) techniques.
Open Access
In-field torsion measurements on solar trackers using fiber optic sensors
(Optica, 2020) Leandro González, Daniel; Bravo Acha, Mikel; Júdez Colorado, Aitor; Mariñelarena Ollacarizqueta, Jon; Falcone Lanas, Francisco; Loayssa Lara, Alayn; López-Amo Sáinz, Manuel; Jiménez, S.; Achaerandio, Álvaro; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Gobierno de Navarra / Nafarroako Gobernua
In-field torsion measurements on solar trackers using fiber Bragg gratings are presented. 45 FBG sensors have been deployed in an operational solar energy plant to study the mechanical response of the structure to wind.
Open Access
Optical fiber sensors for asphalt structures monitoring
(Optica Publishing Group, 2016) Bravo Acha, Mikel; Rota Rodrigo, Sergio; Leandro González, Daniel; Loayssa Lara, Alayn; Urricelqui Polvorinos, Javier; Bravo Acha, A.; Bravo Navas, M.; Mitxelena, J. R.; Martínez Mazo, J. J.; López-Amo Sáinz, Manuel; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
A novel optical fiber installation method was explored for asphalt monitoring. Glassfiber polymer encapsulated SMF was installed in the intermediate and surface layers in order to study the strain sensitivity with a distributed strain interrogator.
Open Access
Multicore fiber sensors for strain measurement towards traffic monitoring
(SPIE, 2023) Sánchez González, Arturo; Pradas Martínez, Javier; Corera Orzanco, Íñigo; Bravo Acha, Mikel; Leandro González, Daniel; Dauliat, Romain; Jamier, Raphael; Roy, Philippe; Pérez Herrera, Rosa Ana; López-Amo Sáinz, Manuel; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa, PJUPNA06-2022
In this work, two new interferometric sensors based on multicore optical fibers for the measurement of strain with the ultimate goal of traffic monitoring are presented. The operating principle of each sensor relied on the monitoring of the phase shift difference accumulated between the supermodes of the structure of the multicore segment in a full round trip. The strain characterization for both sensors resulted in a linear response, with sensitivities of -4.073·10-3 rad/με and - 4.389·10-3 rad/με for the aligned and V-shaped cases respectively, and one-hour instabilities below 4.6·10-3 rad with a 95% confidence level. These results suggest its feasibility in applications requiring high sensitivities over very wide strain ranges, such as heavy-vehicle traffic monitoring. To corroborate the hypothesis, both sensors were integrated into the pavement and their response to the traffic was analyzed.
Open Access
Concrete beam bending test monitorization using a high strain fiber optic sensor
(IEEE / OSA, 2012) Bravo Acha, Mikel; Sáenz, J.; Bravo Navas, M.; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
In this work the development of an 'eight-shape' fiber optic sensor for high strain measurement is experimentally demonstrated. This strain sensor is interrogated using a commercial optical time domain reflectometer through a dual configuration that is able to measure backscattering and the transmission of an intensity pulse while reducing unwanted cladding-mode coupling effects. An 'in field' concrete beam bending test was also performed in order to compare the proposed low-cost intensity bending sensor with the mature fiber Bragg grating technology.
Open Access
Micro-drilled optical fiber for enhanced laser strain sensors
(SPIE, 2019) Pérez Herrera, Rosa Ana; Bravo Acha, Mikel; Roldán Varona, Pablo; Leandro González, Daniel; Rodríguez Cobo, Luis; López Higuera, José Miguel; López-Amo Sáinz, Manuel; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación
In this work, we present an experimental measurement of temperature and strain sensitivities of a micro-drilled optical fiber (MDOF). The MDOF consisted of a quasi-randomly distributed reflector along a single mode fiber (SMF). A fiber cavity laser based on MDOF was experimentally studied, attaining a single-wavelength laser emission centered at 1568.6nm. The output power level obtained from this single-laser oscillation when pumped at 140mW was around - 9.6dBm, and an optical signal to noise ratio (OSNR) of around 45dB was measured. Although temperature sensitivities of fiber Bragg gratings used as sensors are similar to our MDOF, strain sensitivity is enhanced around one order of magnitude when the MDOF was used.
Open Access
Compact optical fiber lasers and optical fiber sensors assisted by femtosecond laser inscription of plane-by-plane FBGs
(Optica, 2020) Roldán Varona, Pablo; Pallarés Aldeiturriaga, D.; Rodríguez Cobo, Luis; Pérez Herrera, Rosa Ana; Bravo Acha, Mikel; López-Amo Sáinz, Manuel; López Higuera, José Miguel; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación
Development of a high temperature sensor based on optical fiber l aser generated from a cavity of reduced dimensions (43 mm) in Er-doped fiber. The mirror FBGs have been inscribed with femtosecond laser using the slit beam technique (Pl-b-Pl).
Open Access
Reinforced concrete structural corrosion monitoring using Hi-Bi photonic crystal fibres in a fiber loop structure
(SPIE, 2014-06-02) Bravo Acha, Mikel; McCague, Colum; Fabian, Matthias; Jaroszewicz, Leszek R.; Mergo, Paweł; Sun, Tong; Grattan, Kenneth T. V.; López-Amo Sáinz, Manuel; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza
A novel sensing approach has been developed for in-situ corrosion monitoring of steel reinforced concrete structures, using an interferometric Sagnac sensor system based on a Hi-Bi photonic crystal fibre (PCF). To do so an accurate fibre alignment procedure has been implemented in order to improve the performance of the sensor system embedded into the concrete structure when it is subjected to an accelerated corrosion test. The positive results obtained have confirmed the effectiveness of such a sensor system for applications in structural health monitoring.
Open Access
Remote-time division multiplexing of bending sensors using a broadband light source
(Hindawi Publishing Corporation, 2012) Bravo Acha, Mikel; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
This work experimentally demonstrates a remote sensing network which interrogates bending sensors using time-division multiplexing techniques and a broadband light source. The bending sensors are located 50 km away from the monitoring station. They are based on a simple tie displacement sensor and offer high-resolution measurements of displacement.