Fernández Vallejo, Montserrat

person.page.identifierURI

https://academica-e.unavarra.es/handle/2454/49024

Last Name

Fernández Vallejo

First Name

Montserrat

person.page.departamento

Ingeniería Eléctrica y Electrónica

person.page.observainves

750618

person.page.upna

8522

Full item page

Search Results

Now showing 1 - 10 of 19

Open Access
Stabilization of dual-wavelength erbium doped ring fiber lasers by single-mode operation
(IEEE, 2010) Quintela, M. A.; Pérez Herrera, Rosa Ana; Canales, Irene; Fernández Vallejo, Montserrat; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
In this work, a novel single-longitudinal-mode (SLM) dual-wavelength laser configuration is proposed and demonstrated. This laser is based on ring resonators, and employs fiber Bragg gratings to select the operation wavelengths. It includes a short piece of highly doped Er-fiber that acts as the active medium. The stable SLM operation is guaranteed when the two lasing channels present similar output powers. This behavior is shown for different pump powers.
Open Access
L-band multiwavelength single-longitudinal mode fiber laser for sensing applications
(IEEE / OSA, 2012) Pérez Herrera, Rosa Ana; Ullán Nieto, Ángel; Leandro González, Daniel; Fernández Vallejo, Montserrat; Quintela, M. A.; Loayssa Lara, Alayn; López Higuera, José Miguel; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
In this work, a novel single-longitudinal-mode (SLM) four-wavelength laser configuration for sensing applications in the L-band is proposed and experimentally demonstrated. The sensor system presented here is based on ring resonators, and employs fiber Bragg gratings to select the operation wavelengths. The stable SLM operation is guaranteed when all the lasing channels present similar output powers. It is also experimentally demonstrated that when a SLMbehavior is achieved, lower output power fluctuations are obtained. Characterization of the lasing structure for temperature sensing is also shown.
Open Access
Suspended-core fiber Sagnac combined dual-random mirror Raman fiber laser
(Optical Society of America, 2011) Rodrigues Pinto, Ana Margarida; Bravo Acha, Mikel; Fernández Vallejo, Montserrat; López-Amo Sáinz, Manuel; Kobelke, J.; Schuster, K.; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
In the present work, a multiwavelength fiber laser based in the combination of a double-random mirror and a suspended-core Sagnac interferometer is presented. The double-random mirror acts by itself as a random laser, presenting a 30dB SNR, as result of multiple Rayleigh scattering events produced in the dispersion compensating fibers by the Raman amplification. The suspended-core fiber Sagnac interferometer provides the multi peak channeled spectrum, which can be tuned by changing the length of the fiber. The result of this combination is a stable multiwavelength peak laser with a minimum of ~25dB SNR, which is highly sensitive to polarization induced variations.
Open Access
Remote (250 km) fiber Bragg grating multiplexing system
(MDPI, 2011) Fernández Vallejo, Montserrat; Rota Rodrigo, Sergio; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
We propose and demonstrate two ultra-long range fiber Bragg grating (FBG) sensor interrogation systems. In the first approach four FBGs are located 200 km from the monitoring station and a signal to noise ratio of 20 dB is obtained. The second improved version is able to detect the four multiplexed FBGs placed 250 km away, offering a signal to noise ratio of 6-8 dB. Consequently, this last system represents the longest range FBG sensor system reported so far that includes fiber sensor multiplexing capability. Both simple systems are based on a wavelength swept laser to scan the reflection spectra of the FBGs, and they are composed by two identical-lengths optical paths: the first one intended to launch the amplified laser signal by means of Raman amplification and the other one is employed to guide the reflection signal to the reception system.
Open Access
Multiplexing of six micro-displacement suspended-core Sagnac interferometer sensors with a Raman-Erbium fiber laser
(Optical Society of America, 2013) Bravo Acha, Mikel; Fernández Vallejo, Montserrat; Echapare Zabaleta, Mikel; López-Amo Sáinz, Manuel; Kobelke, J.; Schuster, K.; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
This work experimentally demonstrates a long-range optical fiber sensing network for the multiplexing of fiber sensors based on photonic crystal fibers. Specifically, six photonic crystal fiber sensors which are based on a Sagnac interferometer that includes a suspended-core fiber have been used. These sensors offer a high sensitivity for microdisplacement measurements. The fiber sensor network presents a ladder structure and its operation mode is based on a fiber ring laser which combines Raman and Erbium doped fiber amplification. Thus, we show the first demonstration of photonic crystal fiber sensors for remote measurement applications up to 75 km.
Open Access
Advanced graphene-based transparent conductive electrodes for photovoltaic applications
(MDPI, 2019) Fernández, Susana; Boscá, Alberto; Pedrós, Jorge; Inés Ortigosa, Andrea; Fernández Vallejo, Montserrat; Arnedo Gil, Israel; González, José Pablo; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
New architectures of transparent conductive electrodes (TCEs) incorporating graphene monolayers in different configurations have been explored with the aim to improve the performance of silicon-heterojunction (SHJ) cell front transparent contacts. In SHJ technology, front electrodes play an important additional role as anti-reflectance (AR) coatings. In this work, different transparent-conductive-oxide (TCO) thin films have been combined with graphene monolayers in different configurations, yielding advanced transparent electrodes specifically designed to minimize surface reflection over a wide range of wavelengths and angles of incidence and to improve electrical performance. A preliminary analysis reveals a strong dependence of the optoelectronic properties of the TCEs on (i) the order in which the different thin films are deposited or the graphene is transferred and (ii) the specific TCO material used. The results shows a clear electrical improvement when three graphene monolayers are placed on top on 80-nm-thick ITO thin film. This optimum TCE presents sheet resistances as low as 55 Ω/sq and an average conductance as high as 13.12 mS. In addition, the spectral reflectance of this TCE also shows an important reduction in its weighted reflectance value of 2-3%. Hence, the work undergone so far clearly suggests the possibility to noticeably improve transparent electrodes with this approach and therefore to further enhance silicon-heterojunction cell performance. These results achieved so far clearly open the possibility to noticeably improve TCEs and therefore to further enhance SHJ contact-technology performance.
Open Access
Resilient amplified double ring optical networks to multiplex optical fibre sensors
(IEEE / OSA, 2009) Fernández Vallejo, Montserrat; Pérez Herrera, Rosa Ana; Elosúa Aguado, César; Díaz Lucas, Silvia; Urquhart, Paul; Bariáin Aisa, Cándido; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
We report the experimental demonstration of two configurations of an amplified optical fibre double ring network for the multiplexing of sensors. The networks are designed to be inherently resilient to fibre failures because they enable simultaneous interrogation of all the optical fibre sensors using both rings. The first design demonstrates the feasibility of the so called 'dedicated protection' and the second one 'shared protection' for fibre optic intensity sensors. Raman amplification is used to overcome the losses of the couplers used in the rings, providing power transparency. The first network uses Raman amplification in both constituent rings but in the second one Raman pumping is activated only when a fibre failure occurs. We demonstrate how the topology allows the received powers from the sensors to be equalized.
Open Access
Robust fiber-optic sensor networks
(Springer, 2012) Pérez Herrera, Rosa Ana; Fernández Vallejo, Montserrat; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
The ability to operate despite failure will become increasingly important as the use of optical sensor networks grows, and the amount of sensing information to be handled by a sensor network is increasing, especially for safety and security applications. In this review, the four categories of protection to allow service to be reestablished after a failure (dedicated/shared and line/path) are thoroughly discussed. This paper also presents an overview of the most representative robust fiber-optic sensor systems, discussing their schemes, pros and cons.
Open Access
Optical fiber networks for remote fiber optic sensors
(MDPI, 2012) Fernández Vallejo, Montserrat; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
This paper presents an overview of optical fiber sensor networks for remote sensing. Firstly, the state of the art of remote fiber sensor systems has been considered. We have summarized the great evolution of these systems in recent years; this progress confirms that fiber-optic remote sensing is a promising technology with a wide field of practical applications. Afterwards, the most representative remote fiber-optic sensor systems are briefly explained, discussing their schemes, challenges, pros and cons. Finally, a synopsis of the main factors to take into consideration in the design of a remote sensor system is gathered.
Open Access
Comparative study of ring and random cavities for fiber lasers
(Optical Society of America, 2014) Fernández Vallejo, Montserrat; Rota Rodrigo, Sergio; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
An experimental comparison of three fiber laser structures with the same Raman gain medium is presented in order to establish the main pros and cons of each basic scheme. The first fiber laser is based on a hybrid ring–random fiber laser, the second one is a pure ring fiber laser, and the last one is a random fiber laser. Several aspects have been taken into account in the study. First, from the optical point of view, the parameters of interest compared are output power, lasing threshold, slope efficiency, power fluctuations, and the longitudinal modes have been analyzed. Second, the possible utilization of fiber lasers in digital modulated optical communication systems is also studied.