Open Access
Enhanced tolerance to pulse extinction ratio in Brillouin optical time domain analysis sensors by dithering of the optical source
(SPIE, 2015) Iribas Pardo, Haritz; Urricelqui Polvorinos, Javier; Sagüés García, Mikel; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
We demonstrate the relaxation of the stringent requirements placed on the pulse extinction ratio in long-range Brillouin optical time-domain analysis sensors (BOTDA) by modulating the wavelength of the laser source that is used to generate both pump and probe waves. This modulation makes the counter-propagating pulse pedestal and probe waves to become correlated only at certain locations in the fiber, thus reducing the gain experienced by the probe wave, which is precisely the process that limits the performance in long-range BOTDAs. Proof-of-concept experimental results in a 20-km sensing link demonstrate a 6-dB reduction of the required modulator extinction ratio.
Open Access
Development and implementation of standardized interfaces for an Android based telemonitoring server
(2011) Urricelqui Polvorinos, Javier; Serrano Arriezu, Luis Javier; Gerbovics, Ferenc; Escuela Técnica Superior de Ingenieros Industriales y de Telecomunicación; Telekomunikazio eta Industria Ingeniarien Goi Mailako Eskola Teknikoa; University of Applied Sciences Technikum Wien (Austria); Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
El tema de este proyecto fin de carrera es el desarrollo e implementación de interfaces estandarizadas para un servidor de telemonitorización basado en Android complementario al dispositivo HDH. El sistema de telemonitorización conocido como Health Data Hub (HDH) ha sido desarrollado por un grupo de estudiantes de Máster en la University of Applied Sciences Technikum Wien, obteniendo como resultado un dispositivo tipo muñequera capaz de medir datos médicos mediante sensores, recibir datos de parámetros vitales por parte de dispositivos para el cuidado de la salud, además del reenvío de datos como mensajes de alarma y diversas actualizaciones a distintos servidores mediante interfaces estandarizadas. Por lo que el principal objetivo de este proyecto es el desarrollo e implementación de interfaces estandarizadas para un servidor de telemonitorización basado en Android, capaz de gestionar los datos enviados por los dispositivos enmarcados en este proyecto según el estándar HL7 v2.6. El dispositivo HDH es capaz de medir parámetros vitales, generar actualizaciones automáticas y mensajes de alarma para enviarlos posteriormente al Android server mientras el paciente realiza su vida cotidiana. De esta manera, el usuario del Android server puede disponer de información relativa al usuario del HDH. El conjunto de dispositivos que se encuentran en el marco del proyecto HDH son el servidor HDH, el cliente HDH, el servidor Android y el dispositivo HDH. El servidor Android desarrollado durante este proyecto, consiste en una solución esencial de este entorno. El Android server está realizado sobre la plataforma Android, lo cual permite ofrecer nuevas funcionalidades y servicios que dotan de gran potencial al proyecto permitiendo llevar a cabo los objetivos propuestos. Además, Android se define como código abierto, lo cual permite al desarrollador una fácil integración a otros entornos y provee herramientas que permiten que el desarrollo de la aplicación sea más atractivo para el programador. Este proyecto ha sido desarrollado en colaboración con Amagoia Tellechea, estudiante de la Universidad Pública de Navarra y estudiante de intercambio Erasmus en la University of Applied Sciences Technikum Wien. Las tareas asignadas para el desarrollo de la aplicación Android server fueron proporcionadas a ambos estudiantes, por lo que se trabajó conjuntamente en el desarrollo de la aplicación desde sus inicios hasta las últimas soluciones adoptadas para su desarrollo.
Open Access
Phasorial differential pulse-width pair technique for long-range Brillouin optical time-domain analysis sensors
(Optical Society of America, 2014) Urricelqui Polvorinos, Javier; Sagüés García, Mikel; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
We introduce a novel phasorial differential pulse width pair (PDPP) method for Brillouin optical time domain analysis (BOTDA) sensors that combines spatial resolution enhancement with increased tolerance to non local effects. It is based on the subtraction of the complex time domain traces supplied by a sensor configuration that uses a phase modulated probe wave and RF demodulation. The fundamentals of the technique are first described theoretically and using numerical simulation of the propagating waves. Then, proof of concept experiments demonstrate the measurement of the Brillouin frequency shift distribution over 50 km. The system is shown to withstand large variations of the pump power generated by its interaction with a powerful probe wave along the fiber; hence, highlighting the potential of the PDPP technique to increase the detected signal to noise ratio in long range BOTDA. Moreover, the PDPP is also shown to increase the measurement contrast by allowing the use of relatively long duration pulses while retaining 1 m spatial resolution.
Open Access
Dynamic BOTDA measurements using Brillouin phase-shift
(SPIE, 2012) Urricelqui Polvorinos, Javier; Zornoza Indart, Ander; Sagüés García, Mikel; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
We demonstrate a novel dynamic BOTDA sensor based, for the first time to our knowledge, on the use of the Brillouin phase-shift instead of the conventional Brillouin gain. This provides the advantage of measurements that are largely immune to variations in fiber attenuation or changes in pump pulse power. Furthermore, the optical detection deployed can lead to an enhanced precision or measurement time and to the broadening of the measurement range. Proof of concept experiments demonstrate 1.66 kHz measurement rate with 1 m resolution over a 160 m sensing fiber length.
Open Access
Gain dependence of measured spectra in coherent Brillouin optical time-domain analysis sensors
(SPIE, 2016) Mariñelarena Ollacarizqueta, Jon; Urricelqui Polvorinos, Javier; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
We report on the effects of large pump pulse powers on Brillouin optical time-domain analysis (BOTDA) sensors based on phase-modulated probe wave and coherent detection. It is found that the large Brillouin gain that comes from the use of high power pulses induces a narrowing of the RF phase-shift spectrum that is measured in these sensors. This narrowing leads to a Brillouin frequency shift measurement error when the sensor is configured for dynamic measurements. However, the effect has been found to be less significant than that observed in dynamic slope-assisted BOTDA sensors based on amplitude.
Open Access
Phase-shift based BOTDA measurements tolerant to non-local effects
(SPIE, 2013) Urricelqui Polvorinos, Javier; Sagüés García, Mikel; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
We demonstrate a BOTDA sensor based on the use of the Brillouin phase shift that performs measurements tolerant to non local effects. This technique raises opportunities to increase the distance covered by these sensors and the maximum optical power of the probe wave injected to the fiber. As a result, the system has the potential to increase the SNR achieved at the last meters of the fiber. Proof-of-concept experiments demonstrate unaltered measurements of the phase shift spectrum in a 20Km long fiber for large frequency-dependent distortions of the pump pulse.
Open Access
Enhancement of the dynamic range in slope-assisted coherent brillouin optical time-domain analysis sensors
(IEEE, 2017) Mariñelarena Ollacarizqueta, Jon; Urricelqui Polvorinos, Javier; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
We present two techniques that provide an extension of the dynamic range of coherent Brillouin optical time-domain analysis (BOTDA) sensors for dynamic measurements. This type of BOTDA sensors rely on self-heterodyne detection of a phase-modulated probe wave and the dynamic range for fast measurements is limited to the linear region of the RF phase-shift spectrum measured. The first method for range extension that we introduce is based on launching pump pulses containing multiple frequency components. This makes the Brillouin spectra generated by each component to overlap, providing a wider linear region of the detected RF phase-shift spectrum and allowing to measure larger Brillouin frequency shift variations. The second method relies on shortening the length of the pump pulses, which leads to the broadening of the detected RF spectra. The theoretical fundamentals of both range enhancing techniques are presented. Moreover, we experimentally demonstrate that they provide a threefold to fourfold enhancement in the dynamic range. Finally, the factors limiting their performance are determined: for the multi-frequency pump pulse technique, it is the worsening of Kerr non-linear effects due to the simultaneous propagation of multiple spectral components in the fiber, and, for the pulse-shortening method, it is the signal-to-noise ratio penalty linked to the reduction of the magnitude of the Brillouin interaction.
Open Access
Structural health monitoring of solar trackers using distributed fiber optic sensors
(SPIE, 2019) Mariñelarena Ollacarizqueta, Jon; Mompó Roselló, Juan José; Zurita Gabasa, Jesús; Urricelqui Polvorinos, Javier; Júdez Colorado, Aitor; López-Amo Sáinz, Manuel; Jiménez Romero, Sergio; Achaerandio, Álvaro; Loayssa Lara, Alayn; Institute of Smart Cities - ISC; Gobierno de Navarra / Nafarroako Gobernua, 0011-1365-2017-000122; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
We demonstrate the application of a novel type of distributed fiber optic sensors (DFOSs) to dynamically monitor the effects of wind on solar tracker structures used in photovoltaic power stations. This DFOS is based on the stimulated Brillouin scattering nonlinear optical effect in optical fiber, which can be used to measure the distribution of strain and temperature along a given structure. However, contrary to existing solutions, the sensor provides dynamic real-time measurements with hundreds or even thousands of full simultaneous measurements for all positions in the fiber each second. Moreover, high-precision and high spatial resolution are obtained. This so-called dynamic Brillouin optical time-domain analysis (D-BOTDA) sensor provides real-time monitoring of the bending and torsion of the structure of solar trackers in response to wind load. This helps the solar tracker manufacturer asses and improve the mechanical designs so as to introduce corrective measures and develop cost-effective components that properly withstand the effects of wind at any given location. We experimentally demonstrate the application of a D-BOTDA sensing system to measure distributed bending and, for the first time to our knowledge, also distributed torsion along the stressed beam of the solar tracker. For this purpose, we have developed a procedure to instrument the torsion beam with two optical sensing fibers that are fixed helically wound along the beam in opposite directions, so that any common-mode thermal or bending effects are removed. We initially performed tests in a laboratory facility in which sections of the torsion beam could be subjected to controlled moments. Static and dynamic loads were applied and the measured deformations were compared to those obtained with fiber Bragg gratings, which just provide point measurements of strain. In both cases, full agreement was demonstrated. Finally, the system was installed in an operational solar park.
Open Access
Overcoming non-local effects and Brillouin threshold limitations in Brillouin optical time domain sensors
(IEEE, 2015) Ruiz Lombera, Rubén; Urricelqui Polvorinos, Javier; Sagüés García, Mikel; Mirapeix, Jesús; López Higuera, José Miguel; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
We demonstrate, for the first time to our knowledge, a Brillouin optical time domain analysis (BOTDA) sensor that is able to operate with a probe power larger than the Brillouin threshold of the deployed sensing fiber and that is free from detrimental non-local effects. The technique is based on a dual-probe-sideband setup in which an optical frequency modulation of the probe waves along the fiber is introduced. This makes the optical frequency of the Brillouin interactions induced by each probe wave on the pump to vary along the fiber so that two broadband Brillouin gain and loss spectra that perfectly compensate are created. As a consequence, the pulse spectral components remain undistorted avoiding non-local effects. Therefore, a very large probe power can be injected, which improves the signal-to-noise ratio in detection for long-range BOTDA. Moreover, the probe power can even exceed the Brillouin threshold limit due to their frequency modulation, which reduces the effective amplification of spontaneous Brillouin scattering in the fiber. Experiments demonstrate the technique in a 50-km sensing link in which 8 dBm of probe power is injected.
Open Access
Second-order non-local effects mitigation in BOTDA sensors by tracking the BFS profile
(SPIE, 2017) Mompó Roselló, Juan José; Iribas Pardo, Haritz; Urricelqui Polvorinos, Javier; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
We demonstrate a technique to mitigate the residual second-order non-local effects in Brillouin optical time-domain analysis (BOTDA) sensors in which the Brillouin frequency shift (BFS) profile is not uniform along the fiber. It is based on adding a wavelength modulation to the probe wave that makes it track the average BFS found along its way. Using this method we are able to inject a total probe wave power of 15 dBm in a 120-km sensing fiber link, which, to the best of our knowledge, is the highest probe power ever demonstrated in a long-range BOTDA sensing fiber link. The enhancement in the detected signal-to-noise ratio brought by the use of such power provides 2-MHz BFS measurement precision at the end of the 120-km sensing link with 3-m spatial resolution, all without the need to resort to additional means such as the use of coding or Raman gain.