# Person: Gimena Ramos, Faustino

Loading...

## Email Address

## Birth Date

## Research Projects

## Organizational Units

## Job Title

## Last Name

Gimena Ramos

## First Name

Faustino

## person.page.departamento

Ingeniería

## person.page.instituteName

IS-FOOD. Research Institute on Innovation & Sustainable Development in Food Chain

## ORCID

0000-0001-7912-9082

## person.page.upna

485

## Name

9 results Back to results

### Filters

#### Author

#### Date

#### Has files

#### Item Type

### Settings

Sort By

Results per page

## Search Results

Now showing 1 - 9 of 9

Publication Open Access Geomorphological instantaneous unit hydrograph model with distributed rainfall(Elsevier, 2019) Goñi Garatea, Mikel; López Rodríguez, José Javier; Gimena Ramos, Faustino; Ingeniería; IngeniaritzaShow more Two variants of the Instantaneous Unit Hydrograph model based on a Geomorphological association of linear Reservoirs (IUHGR), incorporating the Spatial Variability of Rainfall (SVR), have been developed. The proposed models are based on the Geomorphological Reservoirs (GR) scheme consisting of a cascade of linear reservoirs aggregating sub-watersheds. The model, in its first version, was formulated so that it incorporated a spatial variability pattern of rainfall associated with a certain frequency and oriented towards its application in the field of hydrological design. This model was considered to be stationary in the time (GRSVR(s)) for being linked to some design conditions. The second version of the model is applicable to the simulation of real events, where there is a dynamic (GRSVR(m)) spatial distribution of rainfall that varies in time, as in the case of the movement of rainstorms. Both models permit the input of relevant information on the spatial variability of the rainfall, taken from different rain gauge records, without losing the simplicity of the GR model with a single parameter, which represents the hydrological time response of the watershed. The models have been calibrated and validated with the data from one gauged watershed in northern Spain. The analysis conducted in both cases showed that the models which contemplated the spatial variability of the rainfall, GRSVR(s) and GRSVR(m), were capable of simulating rainfall variability effects in the surface runoff hydrograph better than the GR model, which averages the precipitation values recorded in the different rain gauges.Show more Publication Open Access Pohlke theorem: demonstration and graphical solution(Springer, 2017) Gimena Ramos, Faustino; Gimena Ramos, Lázaro; Goñi Garatea, Mikel; Gonzaga Vélez, Pedro; Proyectos e Ingeniería Rural; Landa Ingeniaritza eta ProiektuakShow more It is known that the axonometric defined by Pohlke, is geometrically known as a means of representing the figures of space using a cylindrical projec-tion and proportions. His theorem says that the three unit vectors orthogonal axes of the basis in the space can be transformed into three arbitrary vectors with com-mon origin located in the frame plane. Another way of expressing this theorem is given in three segments mismatched and incidents at one point in a plane, there is a trirectangular unitary thriedra in the space that can be transformed in these three segments. This paper presents a graphical procedure to demonstrate a solution of Pohlke¿s theorem. To do this, we start from previous work by the authors on the axonometric perspective. Graphic constructions that allow a single joint invariant description of relationships between an orthogonal axonometric oblique axono-metric system and systems associated thereby. At a same time of the geometric lo-cus generated by the diagonal magnitude positioned at any direction in the plane of the picture. This magnitude is the square root of the sum of the squares of the projection of the three segments representing axonometric on arbitrary magnitude.Show more Publication Open Access Formulation and solution of curved beams with elastic supports(Mechanical Engineering Faculty, University of Slavonski Brod, 2018) Sarría Pueyo, Fernando; Gimena Ramos, Faustino; Gonzaga Vélez, Pedro; Goñi Garatea, Mikel; Gimena Ramos, Lázaro; Ingeniería; IngeniaritzaShow more This article presents the general system of differential equations that governs the behaviour of a curved beam, which can be solved by either numerical or analytical methods. The obtained solution represents the matricial expression of transference. The stiffness matrix is derived directly rearranging the transfer matrix. Through twelve equations are shown the elastic conditions of the support in both ends of the curved piece. By joining the twelve equations of the stiffness matrix expression with the twelve equations of support conditions, we determined a unique system of equations associated to the curved beam with elastic supports. Establishing the elastic conditions has always been a problem, since previous traditional models do not look at the whole system, of twenty four equations, with all the unknowns and all the functions. Two examples of pieces with elastic supports are developed to show the applicability of the proposed method.Show more Publication Embargo Application of the elastic curve equation for the verification of structures assimilable to continuous beams(World Scientific Publishing, 2024) Gimena Ramos, Faustino; Gonzaga Vélez, Pedro; Goñi Garatea, Mikel; Valdenebro García, José Vicente; Senosiain Carasusan, María Aranzazu; Ingeniería; Ingeniaritza; Institute of Smart Cities - ISC; Institute on Innovation and Sustainable Development in Food Chain - ISFOODShow more This paper analyzes the beam under isolated and uniform loads, extending this calculation towards the structural type of the continuous beam, by means of a single expression of the elastic curve. A general expression of the bending is proposed, deduced by integrating the different differential equations of the elastica, associated to each section between discontinuities produced by the loads. In this paper, support reactions are incorporated into the load system. Therefore, the continuous beam is understood as a bar made up of sections aligned between discontinuities. With this, the isostatic beam, the hyperstatic beam and the continuous beam can be treated by means of the same integrated expression of the displacement, also called the Macaulay method. Equivalent notations are provided to the expression of bending for the cases of traction-compression and torsion, obtained through the same reasoning and sequence of operations. The formulation of elastic type and the associated operations shown allow us to cover the analysis of the generic structural form, which we can define as the beam of any number of spans, or continuous beam of >n spans. The load system is also generalized, being able to contemplate loads of a different nature and form of distribution, both static and mobile. The examples that have been developed always provide analytical results of solicitation and deformation. They intend to explain the systematic path followed from the approach of the structural problem to its mathematical modelling, and the resolution procedure developed to obtain useful values for the structural verification. In these examples, an increasing degree of complexity and generalization has been followed. The expressions obtained are validated by comparing them with those that are usual in the structural literature for the same or similar problems.Show more Publication Open Access Alternative approach to the buckling phenomenon by means of a second order incremental analysis(Springer Nature, 2023) Gimena Ramos, Faustino; Goñi Garatea, Mikel; Gonzaga Vélez, Pedro; Valdenebro García, José Vicente; Ingeniería; IngeniaritzaShow more This article addresses the problem of determining the solicitation and deformation of beams with geometric imperfection, also called real beams under a compression action. This calculation is performed by applying the Finite Transfer Method numerical procedure under first-order effects with the entire compression action applied instantaneously and applying the action gradually under second-order effects. The results obtained by this procedure for real sinusoidal or parabolic beams are presented and compared. To verify the potential of the numerical procedure, the first and second-order effects of a beam with variable section are presented. New analytical formulations of the bending moment and the transverse deformation in the beam with sinusoidal imperfection subjected to compression are also obtained, under first and second-order analysis. The maximum failure load of the beams is determined based on their initial deformation. The results of solicitation and deformation of the real beam under compression are compared, applying the analytical expressions obtained and the numerical procedure cited. The beams under study are profiles with different geometric characteristics, which shows that it is possible to obtain maximum failure load results by varying the relationships between lengths, areas and slenderness. The increase in second-order bending moments causes the failure that originates in the beam, making it clear that this approach reproduces the buckling phenomenon. The article demonstrates that through the Finite Transfer Method the calculation of first and second-order effects can be addressed in beams of any type of directrix and of constant or variable section.Show more Publication Open Access Curved beam through matrices associated with support conditions(2020) Gimena Ramos, Faustino; Gonzaga Vélez, Pedro; Valdenebro García, José Vicente; Goñi Garatea, Mikel; Reyes-Rubiano, Lorena Silvana; Ingeniería; IngeniaritzaShow more Publication Open Access Geometric locus associated with thriedra axonometric projections. Intrinsic curve associated with the ellipse generated(Springer, 2017) Gonzaga Vélez, Pedro; Gimena Ramos, Faustino; Gimena Ramos, Lázaro; Goñi Garatea, Mikel; Proyectos e Ingeniería Rural; Landa Ingeniaritza eta ProiektuakShow more In previous work on the axonometric perspective, the authors presented some graphic constructions that allowed a single and joint invariant description of the relations between an orthogonal axonometric system, its related orthogonal views, and oblique axonometric systems associated with it. Continuing this work and using only the items drawn on the frame plane, in this communication we start from the three segments, representing trirectangular unitary thriedra, joined in the origin and defining an axonometric perspective. Each is projected onto any direc-tion and the square root of the summa of the squares of these projections is deter-mined. We call this magnitude, orthoedro diagonal whose sides would be formed by the three projections axonometric unit segments. If the diagonal size is built from the origin of coordinates and onto the direction used, this describes a locus here called intrinsic curve associated with the ellipse. When the starting three segments represent an orthogonal axonometric perspective, the intrinsic curve as-sociated with the ellipse is a circle.Show more Publication Open Access Caracterización del modelo HEC-HMS en la cuenca de río Arga en Pamplona y su aplicación a cinco avenidas significativas(Universidad Católica de la Santísima Concepción (Chile), 2012) López Rodríguez, José Javier; González Moreno, Miguel Ángel; Scaini, Anna; Goñi Garatea, Mikel; Valdenebro García, José Vicente; Gimena Ramos, Faustino; Proyectos e Ingeniería Rural; Landa Ingeniaritza eta ProiektuakShow more Pamplona es una ciudad que es atravesada por el río Arga a lo largo de una llanura aluvial, que es susceptible de inundaciones cuando se producen avenidas de cierta magnitud. Ante esta situación es importante contar con un modelo hidrológico que permita simular los caudales del río que atraviesa el núcleo urbano, a partir de los datos de los distintos pluviómetros existentes en la cuenca, y que sirva para alimentar a modelos hidráulicos que permitan definir las zonas inundables asociadas a distintos niveles de probabilidad. Con esta finalidad, se ha montado y caracterizado el modelo HEC-HMS de la cuenca del río Arga en Pamplona, y posteriormente, se ha aplicado a las cinco avenidas más significativas de los últimos años, de las que se disponen de los mínimos datos de caudal y precipitación necesarios. HEC-HMS es un modelo lluviaescorrentía que se basa en estructurar la cuenca origen en subcuencas asociadas a los cauces de la red fluvial. El flujo base en los hidrogramas observados se ha estimado mediante el filtro de Eckhardt. Después de realizar un análisis de sensibilidad de los parámetros inciertos del modelo, en el que se ha observado que el más sensible es el CN, se ha aplicado el modelo con los datos de las series de precipitación de las estaciones automáticas, y con los datos de las automáticas más las manuales, en este segundo caso los resultados han mejorado significativamente obteniéndose resultados satisfactorios.Show more Publication Open Access Analysis of the effect of climate change on the characteristics of rainfall in Igeldo-Gipuzkoa (Spain)(MDPI, 2023) López Rodríguez, José Javier; Ayuso-Muñoz, José Luis; Goñi Garatea, Mikel; Gimena Ramos, Faustino; Ingeniería; IngeniaritzaShow more In recent years, numerous studies have been carried out on changes in the temperature and precipitation regimes and in the frequency of the extreme events that are a result of climate change. While there is evidence of an increase in temperature at a global level, this globality does not seem to occur with precipitation. The Igeldo weather station (San Sebastian) has one of the longest recorded rainfall intensity series in Spain and can be considered as representative of the Cantabrian coast. This circumstance makes it the ideal place to analyse the trend of the pluviometric regime of this area, and this was precisely the objective of this study. A total of 165 series of pluviometric parameters were obtained to characterise the pluviometric regime. The Mann–Kendall and Spearman tests were applied to evaluate the trends of the different parameters, and the Pettitt test was applied to detect the existence of change points. In all the series, it was proven that there were no significant trends or change points. Significant increasing trends were only detected in the series of maximum winter precipitation. In general terms, it can be concluded that the precipitation regime in Igeldo is quite stationary in the context of climate change.Show more