Sagüés García, Mikel

Loading...
Profile Picture

Email Address

Birth Date

Job Title

Last Name

Sagüés García

First Name

Mikel

person.page.departamento

Ingeniería Eléctrica, Electrónica y de Comunicación

person.page.instituteName

ISC. Institute of Smart Cities

person.page.observainves

person.page.upna

Name

Search Results

Now showing 1 - 10 of 13
  • PublicationOpen Access
    Dynamic BOTDA measurements based on Brillouin phase-shift and RF demodulation
    (Optical Society of America, 2012) Urricelqui Polvorinos, Javier; Zornoza Indart, Ander; Sagüés García, Mikel; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    We demonstrate a novel dynamic BOTDA sensor based, for the first time to our knowledge, on the use of the Brillouin phase shift in addition to the conventional Brillouin gain. This provides the advantage of measurements that are largely immune to variations in fiber attenuation or changes in pump pulse power. Furthermore, the optical detection deployed leads to an enhanced precision or measurement time and to the broadening of the measurement range. Proof of concept experiments demonstrate 1.66 kHz measurement rate with 1 m resolution over a 160 m sensing fiber length. Moreover, a measurement range of 2560 µε with a precision of 20 µε is successfully proved.
  • PublicationOpen Access
    Brilloun optical time domain analysis sensor assisted by a Brillouin distributed amplifier
    (SPIE, 2015) Urricelqui Polvorinos, Javier; Sagüés García, Mikel; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    We demonstrate the extension of the measurement range of Brillouin optical time-domain analysis (BOTDA) sensors using a distributed Brillouin amplifier (DBA). The technique is based on injecting a DBA pump wave in the fiber to generate an additional Brillouin interaction that amplifies the BOTDA pump pulses. Furthermore, the differential pulse-width pair method is used to counteract the detrimental effects of the DBA amplification on the temporal shape of the pulses. Experimental proof-of-concept results in a 50-km fiber link demonstrate full compensation of the fiber’s attenuation with no penalty on the signal-to-noise ratio of the detected probe wave.
  • PublicationOpen Access
    Polarization diversity scheme for BOTDA sensors based on a double orthogonal pump interaction
    (IEEE, 2015) Urricelqui Polvorinos, Javier; López Fernandino, Felipe; Sagüés García, Mikel; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    We introduce a Brillouin optical time domain analysis (BOTDA) sensor deploying a novel polarization diversity technique based on the use of two orthogonal pump pulses which simultaneously interact with a phase modulated probe wave. The orthogonallity of the two pump pulses guarantees that two complementary Brillouin interactions take place at each position of the fiber, so that polarization independent measurements are performed throughout the fiber even if no averaging is applied. This feature can be exploited in dynamic distributed BOTDA sensors to reduce the measurement time, as no extra averaging is required to compensate the polarization dependence of Brillouin interaction. Proof of concept experiments demonstrate the feasibility of the technique by employing a completely passive scheme to generate the orthogonal pump pulses. Furthermore, the technique is stable and easy to implement, making it a perfect candidate for practical sensor implementations.
  • PublicationOpen Access
    Brillouin distributed sensing assisted by Brillouin amplification of pump pulses
    (IEEE, 2014) Urricelqui Polvorinos, Javier; Sagüés García, Mikel; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    We demonstrate, for the first time to our knowledge, the extension of the measurement range of Brillouin distributed sensors (BDS) by using a distributed Brillouin amplifier (DBA) to compensate the attenuation of the sensor's pump pulses. The technique is based on injecting an extra DBA pump wave in the fiber to generate an additional Brillouin interaction to that used for sensing. Moreover, the bandwidth of the DBA is tailored to fit that of the pump pulses by deploying a wavelength modulation of the DBA pump that is synchronized to the pump. Experimental proof of concept results demonstrate a fivefold enhancement of the measurement range of a BDS, from 10.36 km to more than 50 km in this particular case. Moreover, it is found that the use of the DBA does not introduce any significant penalty in the detection signal to noise ratio, highlighting the potential of the technique to provide much larger sensing lengths.
  • PublicationOpen Access
    Synthesis of Brillouin frequency shift profiles to compensate non-local effects and Brillouin induced noise in BOTDA sensors
    (Optical Society of America, 2014) Urricelqui Polvorinos, Javier; Sagüés García, Mikel; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    We present a novel technique for Brillouin optical time domain analysis (BOTDA) sensors that simultaneously compensates non local effects and reduces Brillouin noise. The technique relies on the wavelength modulation of the optical source to modify the Brillouin interaction between probe and pump waves during their propagation. The resulting Brillouin distribution mimics the wavelength modulation, creating a virtual Brillouin frequency shift profile along the sensing fiber. The fundamentals of the technique are first described theoretically and using numerical simulations. Then, proof of concept experiments demonstrate the capabilities of the system to reduce large variations of the pump power resulting from the interaction with high probe powers and to decrease the Brillouin induced noise enhancing the signal to noise ratio (SNR) of the system. Furthermore, we show, for the first time to our knowledge, measurements of the Brillouin distribution using an injected optical power higher than the Brillouin threshold of the fiber.
  • PublicationOpen Access
    Brillouin optical time-domain analysis sensor assisted by Brillouin distributed amplification of pump pulses
    (Optical Society of America, 2015) Urricelqui Polvorinos, Javier; Sagüés García, Mikel; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    We demonstrate the extension of the measurement range of Brillouin optical time-domain analysis (BOTDA) sensors using a distributed Brillouin amplifier (DBA). The technique is based on injecting a DBA pump wave in the fiber to generate an additional Brillouin interaction that amplifies the BOTDA pump pulses and compensates optical fiber attenuation. This amplification does not introduce any significant noise to the BOTDA’s probe wave due to the inherent directionality of the Brillouin gain. Additionally, we deploy a differential pulse-width pair measurement method to avoid measurement errors due to the interplay between the self-phase modulation effect and the changes in the temporal shape of the pulses induced by the transient behavior of Brillouin gain. Experimental proof-of-concept results in a 50-km fiber link demonstrate full compensa- tion of the fiber’s attenuation with no penalty on the signal-to-noise ratio of the detected signal.
  • PublicationOpen Access
    Phasorial differential pulse-width pair technique for long-range Brillouin optical time-domain analysis sensors
    (Optical Society of America, 2014) Urricelqui Polvorinos, Javier; Sagüés García, Mikel; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    We introduce a novel phasorial differential pulse width pair (PDPP) method for Brillouin optical time domain analysis (BOTDA) sensors that combines spatial resolution enhancement with increased tolerance to non local effects. It is based on the subtraction of the complex time domain traces supplied by a sensor configuration that uses a phase modulated probe wave and RF demodulation. The fundamentals of the technique are first described theoretically and using numerical simulation of the propagating waves. Then, proof of concept experiments demonstrate the measurement of the Brillouin frequency shift distribution over 50 km. The system is shown to withstand large variations of the pump power generated by its interaction with a powerful probe wave along the fiber; hence, highlighting the potential of the PDPP technique to increase the detected signal to noise ratio in long range BOTDA. Moreover, the PDPP is also shown to increase the measurement contrast by allowing the use of relatively long duration pulses while retaining 1 m spatial resolution.
  • PublicationOpen Access
    BOTDA measurements tolerant to non-local effects by using a phase-modulated probe wave and RF demodulation
    (Optical Society of America, 2013) Urricelqui Polvorinos, Javier; Sagüés García, Mikel; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    We demonstrate a Brillouin optical time domain analysis sensor based on a phase modulated probe wave and RF demodulation that provides measurements tolerant to frequency dependent variations of the pump pulse power induced by non local effects. The tolerance to non local effects is based on the special characteristics of the detection process, which provides an RF phase shift signal that is largely independent of the Brillouin gain magnitude. Proof of concept experiments performed over a 20 km long fiber demonstrate that the measured RF phase shift spectrum remains unaltered for large frequency dependent deformations of the pump pulse power. Therefore, it allows the use of a higher optical power of the probe wave, which leads to an enhancement of the detected signal to noise ratio. This can be used to extend the sensing distance, to improve the accuracy of the Brillouin frequency shift measurements, and to reduce the measurement time.
  • PublicationOpen Access
    Overcoming non-local effects and Brillouin threshold limitations in Brillouin distributed sensors
    (SPIE, 2015) Urricelqui Polvorinos, Javier; Ruiz Lombera, Rubén; Sagüés García, Mikel; Mirapeix, Jesús; López Higuera, José Miguel; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
    We demonstrate, for the first time to our knowledge, a Brillouin optical time domain analysis sensor that is able to operate with a probe power larger than the Brillouin threshold of the deployed sensing fiber and that is free from detrimental non-local effects. The technique is based on a dual-probe-sideband setup in which a frequency modulation of the probes waves along the fiber is introduced. This makes the frequency of maximum interaction between pump and probes to vary along the fiber, thus mitigating the pump pulse depletion and making it possible to use very large probe power, which brings an improved signal-to-noise ratio in detection.
  • PublicationOpen Access
    Enhanced tolerance to pulse extinction ratio in Brillouin optical time domain analysis sensors by dithering of the optical source
    (SPIE, 2015) Iribas Pardo, Haritz; Urricelqui Polvorinos, Javier; Sagüés García, Mikel; Loayssa Lara, Alayn; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    We demonstrate the relaxation of the stringent requirements placed on the pulse extinction ratio in long-range Brillouin optical time-domain analysis sensors (BOTDA) by modulating the wavelength of the laser source that is used to generate both pump and probe waves. This modulation makes the counter-propagating pulse pedestal and probe waves to become correlated only at certain locations in the fiber, thus reducing the gain experienced by the probe wave, which is precisely the process that limits the performance in long-range BOTDAs. Proof-of-concept experimental results in a 20-km sensing link demonstrate a 6-dB reduction of the required modulator extinction ratio.