Open Access
Performance comparison between washcoated and packed-bed monolithic reactors for the low-temperature Fischer-Tropsch synthesis
(Elsevier, 2021) Ibáñez Borde, María; Sanz Iturralde, Oihane; Egaña, Ane; Reyero Zaragoza, Inés; Bimbela Serrano, Fernando; Gandía Pascual, Luis; Montes, Mario; Institute for Advanced Materials and Mathematics - INAMAT2; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
Washcoating and packing of Co-Re catalyst particles have been employed as structuring methods of parallel channel monoliths used in the low-temperature Fischer-Tropsch synthesis (FTS). These methods were compared with regard to catalyst hold-up, heat transfer properties and pressure drop. Reactors output was assessed in terms of CO conversion, CH4 selectivity and productivity of C5+ hydrocarbons. Washcoating led to much lower pressure drops, but also resulted in considerably lower catalyst inventory. As for the reactors performance (volumetric and per catalyst mass C5+ productivities), the washcoated monoliths were more effective than the packed-bed ones. This has been attributed to their more favorable hydrodynamic behavior that facilitates the drainage of the reaction products (liquids and waxes) through the central hollow of the channels thus reducing the extra-pellet diffusional limitations. For both catalyst configurations, it has been found that the productivity of C5+ per catalyst mass unit increases as the characteristic diffusion length increases within the range of values considered in this study (below 150 µm). This indicates that a moderate level of internal mass transport restrictions is beneficial for the low-temperature FTS, which has been explained in terms of the effects of diffusional limitations on the H2/CO molar ratio, and that of this ratio on the FTS kinetics. The possible influence of thermal effects on these results has been numerically and experimentally discarded.
Open Access
Effect of oxygen addition, reaction temperature and thermal treatments on syngas production from biogas combined reforming using Rh/alumina catalysts
(Elsevier, 2019) Navarro Puyuelo, Andrea; Reyero Zaragoza, Inés; Moral Larrasoaña, Ainara; Bimbela Serrano, Fernando; Bañares, Miguel A.; Gandía Pascual, Luis; Ciencias; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2
Dry reforming and partial oxidation of biogas were studied using 0.5 wt.% Rh/Al2O3 catalysts, both inhouse prepared and commercial. The effects of O2 addition on syngas yield and biogas conversion were studied at 700 C using different O2/CH4 ratios in the gas feeding stream: 0 (dry reforming), 0.12, 0.25, 0.45 and 0.50. The highest CH4 conversion, H2 yield and H2/CO molar ratio were obtained with an O2/CH4 ratio of 0.45, even though simultaneous valorization of both CH4 and CO2 could be best attained when the O2/CH4 ratio was 0.12. Increased biogas conversions and syngas yields were obtained by increasing reaction temperatures between 650 and 750 C. A detrimental influence on catalytic activity could be observed when the catalyst was subjected to calcination. Increasing the hold time of the thermal conditioning of the catalyst under inert flow altered Rh dispersion, though had no significant impact on catalyst performance in the dry reforming of methane at 700 C and 150 N L CH4/(gcat h). Characterization of spent samples after reaction by Raman spectroscopy revealed the presence of carbonaceous deposits of different nature, especially on the commercial(named as Rh com) and calcined (Rh calc) catalysts, though oxygen addition in the biogas feed significantly reduced the amount of these deposits. The Rh catalysts that had not been calcined after impregnation (Rh prep) did not present any noticeable characteristic peaks in the G and D bands. In particular, scanning transmission electron microscopy (STEM) images of the spent Rh prep sample revealed the presence of very highly dispersed Rh nanoparticles after reaction, of particle sizes of about 1 nm, and no noticeable C deposits. Combined oxy-CO2 reforming of biogas using highly dispersed and low metal-loading Rh/Al2O3 catalysts with low O2 dosage in the reactor feed can be used to effectively transform biogas into syngas.
Open Access
Rutas y retos para la valorización de biogás
(Universidad Libre (Colombia), 2017) Navarro Puyuelo, Andrea; Reyero Zaragoza, Inés; Moral Larrasoaña, Ainara; Bimbela Serrano, Fernando; Gandía Pascual, Luis; Química Aplicada; Kimika Aplikatua
Las tecnologías de digestión anaerobia para procesar corrientes residuales (fracción orgánica de residuos de vertedero, lodos de estaciones depuradoras de aguas residuales, purines, etc.) han originado un incremento de la producción de biogás. El biogás está compuesto principalmente por metano y dióxido de carbono, aunque contiene otros componentes minoritarios e impurezas que obligan a efectuar tratamientos para su purificación y acondicionamiento. Existen diversas alternativas para el aprovechamiento y la valorización de este gas, como son: su utilización directa en la generación de energía calorífica y/o eléctrica, su conversión a biometano, y la producción de gas de síntesis (H2+CO), que posteriormente permite producir combustibles líquidos y/o compuestos químicos de interés como el metanol. En este trabajo se presenta una revisión general de las alternativas de valorización de biogás, con énfasis en los procesos de reformado catalítico, tales como el reformado seco o con vapor de agua y procesos de reformado combinado incluyendo la oxidación parcial.

Bimbela Serrano, Fernando

Email Address

person.page.identifierURI

Birth Date

Job Title

Last Name

First Name

person.page.departamento

person.page.instituteName

ORCID

person.page.observainves

person.page.upna

Name

Filters

Author

Subject

Date

Has files

Item Type

Type

Settings

Sort By

Results per page

Search Results