Rota Rodrigo, Sergio

person.page.identifierURI

https://academica-e.unavarra.es/handle/2454/49901

Last Name

Rota Rodrigo

First Name

Sergio

person.page.departamento

Ingeniería Eléctrica y Electrónica

person.page.observainves

1174830

person.page.upna

810890

Full item page

Search Results

Now showing 1 - 10 of 18

Open Access
Low noise dual-wavelength erbium fiber laser in single-longitudinal-mode operation
(Springer, 2012) Rota Rodrigo, Sergio; Pérez Herrera, Rosa Ana; Fernández Vallejo, Montserrat; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
A new stable dual-wavelength fiber-ring laser based on erbium-doped fiber amplification is reported. The laser is based on ring resonators and employs fiber Bragg gratings to select the operation wavelengths. The topology of the laser has a significant influence in its performance: allowing an independent control of the losses for both lasing wavelengths and achieving a low noise configuration. As a result, it is experimentally demonstrated that both emission lines work in single-longitudinal-mode operation and the topology offers a better stability and higher optical signalto-noise ratios than similar configurations.
Open Access
Compound lasing fiber optic ring resonators for sensor sensitivity enhancement
(IEEE / OSA, 2015) Rota Rodrigo, Sergio; González Herráez, Miguel; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
In this work, a new method for increasing simultaneously the sensitivity and interrogation stability of fiberoptic intensity sensors is presented. The configuration is based on a double-coupler ring resonator. On one side, the attenuation sensitivity of the sensor is enhanced by placing it inside a ring resonator. On the other side, the stability of the interrogation method is widely improved by creating an external lasing ring resonator with matched spectral response. The combination of the wavelength selective response of the ring resonator and optical amplification from Er-doped fiber amplifier is used to create different fiber lasers. The resulting lasers present an impressive sensitivity enhancement and a dynamic range increment up to 15 dB. Simultaneously, the instability of the system is reduced to ±0.05 dB. In comparison with systems based on tunable laser interrogation, our method is >100 times more stable and also simpler, as no wavelength tunable elements are required.
Open Access
Simultaneous strain and temperature measure based on a single suspended core photonic crystal fiber
(SPIE, 2014-06-02) Rota Rodrigo, Sergio; López-Amo Sáinz, Manuel; Kobelke, J.; Schuster, K.; Santos, José Luís; Frazão, Orlando; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
In this work a simultaneous strain and temperature sensor based on a suspended core fiber is proposed. The sensor comprises a 3mm suspended core PCF between SMFs and is based on the combination of two multimodal interferences with different frequency fringe patterns. The interference of the both signal has different sensitivity responses to strain and temperature. Thought a low-pass frequency filtering of the detected spectrum, the wavelength shift of the two interferences can be measured allowing the discrimination of strain and temperature simultaneously. The resolutions of this sensor are 0.45 ºC and 4.02 με.
Open Access
Simultaneous measurement of humidity and vibration based on a microwire sensor system using Fast Fourier Transform technique
(IEEE, 2016) Rota Rodrigo, Sergio; López Aldaba, Aitor; Pérez Herrera, Rosa Ana; López Bautista, María del Carmen; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
This paper presents a new sensor system for vibration and relative humidity measurements based on its interaction with the evanescent field of a microwire. The interrogation of the sensing head is carried out by monitoring the fast Fourier transform (FFT) phase of one of the FFT peaks of the microwire transmission signal. This technique is not dependent of the signal amplitude and also eludes the requisite of tracking the wavelength evolution in the spectrum, which can be a handicap when there are multiple interference frequency components with different sensitivities. The point sensor is able to measure a wide humidity range (20%-70% relative humidity) with a maximum sensitivity reached of 0.14πrad/% relative humidity. This microwire sensor is also operated within a frequency range from 320 to 1300 Hz with a sensitivity of around 0.0051 nm -1 /Hz. Finally, due to the system uses an optical interrogator as unique active element, the system presents a cost-effective feature.
Open Access
Single-longitudinal mode laser structure based on a very narrow filtering technique
(Optical Society of America, 2013) Rodríguez Cobo, Luis; Quintela, M. A.; Rota Rodrigo, Sergio; López-Amo Sáinz, Manuel; López Higuera, José Miguel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
A narrow filtering technique based on the spectral overlapping of two uniform FBGs and applied to obtain a Single Longitudinal Mode (SLM) laser is proposed and demonstrated in this work. The two FBGs are spectrally detuned to reduce their coincident reflection response narrowing the equivalent filter bandwidth. A proof-of-concept linear laser has been built and tested exhibiting SLM operation even with temperature and strain variations.
Open Access
SnO2-MOF-Fabry-Pérot humidity optical sensor system based on Fast Fourier transform technique
(SPIE, 2016) López Aldaba, Aitor; López Torres, Diego; Ascorbe Muruzabal, Joaquín; Rota Rodrigo, Sergio; Elosúa Aguado, César; López-Amo Sáinz, Manuel; Arregui San Martín, Francisco Javier; Corres Sanz, Jesús María; Auguste, Jean-Louis; Jamier, Raphael; Roy, Philippe; Ingeniaritza Elektrikoa eta Elektronikoa; Institute of Smart Cities - ISC; Ingeniería Eléctrica y Electrónica
In this paper, a new sensor system for relative humidity measurements based on a SnO2 sputtering deposition on a microstructured optical fiber (MOF) low-finesse Fabry-Pérot (FP) sensing head is presented and characterized. The interrogation of the sensing head is carried out by monitoring the Fast Fourier Transform phase variations of the FP interference frequency. This method is low-sensitive to signal amplitude variations and also avoids the necessity of tracking the evolution of peaks and valleys in the spectrum. The sensor is operated within a wide humidity range (20%-90% relative humidity) with a maximum sensitivity achieved of 0.14rad/%. The measurement method uses a commercial optical interrogator as the only active element, this compact solution allows real time analysis of the data.
Open Access
Comparative study of ring and random cavities for fiber lasers
(Optical Society of America, 2014) Fernández Vallejo, Montserrat; Rota Rodrigo, Sergio; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
An experimental comparison of three fiber laser structures with the same Raman gain medium is presented in order to establish the main pros and cons of each basic scheme. The first fiber laser is based on a hybrid ring–random fiber laser, the second one is a pure ring fiber laser, and the last one is a random fiber laser. Several aspects have been taken into account in the study. First, from the optical point of view, the parameters of interest compared are output power, lasing threshold, slope efficiency, power fluctuations, and the longitudinal modes have been analyzed. Second, the possible utilization of fiber lasers in digital modulated optical communication systems is also studied.
Open Access
Compound lasing fiber optic ring resonators for sensing
(SPIE, 2014-06-02) Rota Rodrigo, Sergio; González Herráez, Miguel; López-Amo Sáinz, Manuel; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza
In this work, we present a new method for increasing simultaneously the sensitivity and interrogation stability of fiberoptic intensity sensors. The configuration is based on a double-coupler ring resonator. On one side, the attenuation sensitivity of the sensor is enhanced by placing it inside a ring resonator. On the other side, the stability of the interrogation method is rendered close to perfect by creating an external lasing ring resonator with matched spectral response. The resulting lasers allow the stable interrogation of the sensors with an impressive sensitivity enhancement. In our experiments, the dynamic range of the intensity sensor (and consequently its sensitivity) is increased 15 dB by using this laser-based interrogation system. Simultaneously, the instability of the system is reduced to ±0.05 dB. In comparison with systems based on external interrogation, our method is >100 times more stable and also simpler, as no wavelength tunable elements are required.
Open Access
Optical fiber sensors for asphalt structures monitoring
(Optica Publishing Group, 2016) Bravo Acha, Mikel; Rota Rodrigo, Sergio; Leandro González, Daniel; Loayssa Lara, Alayn; Urricelqui Polvorinos, Javier; Bravo Acha, A.; Bravo Navas, M.; Mitxelena, J. R.; Martínez Mazo, J. J.; López-Amo Sáinz, Manuel; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
A novel optical fiber installation method was explored for asphalt monitoring. Glassfiber polymer encapsulated SMF was installed in the intermediate and surface layers in order to study the strain sensitivity with a distributed strain interrogator.
Open Access
Remote (250 km) fiber Bragg grating multiplexing system
(MDPI, 2011) Fernández Vallejo, Montserrat; Rota Rodrigo, Sergio; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
We propose and demonstrate two ultra-long range fiber Bragg grating (FBG) sensor interrogation systems. In the first approach four FBGs are located 200 km from the monitoring station and a signal to noise ratio of 20 dB is obtained. The second improved version is able to detect the four multiplexed FBGs placed 250 km away, offering a signal to noise ratio of 6-8 dB. Consequently, this last system represents the longest range FBG sensor system reported so far that includes fiber sensor multiplexing capability. Both simple systems are based on a wavelength swept laser to scan the reflection spectra of the FBGs, and they are composed by two identical-lengths optical paths: the first one intended to launch the amplified laser signal by means of Raman amplification and the other one is employed to guide the reflection signal to the reception system.