Person:
Marroyo Palomo, Luis

Loading...
Profile Picture

Email Address

Birth Date

Research Projects

Organizational Units

Job Title

Last Name

Marroyo Palomo

First Name

Luis

person.page.departamento

Ingeniería Eléctrica, Electrónica y de Comunicación

person.page.instituteName

ISC. Institute of Smart Cities

ORCID

0000-0002-8344-8374

person.page.upna

495

Name

Search Results

Now showing 1 - 10 of 12
  • PublicationOpen Access
    Analysis of a CIS based PV generator versus a multicrystalline generator under outdoor long-term exposure
    (IEEE, 2021) Parra Laita, Íñigo de la; Guerra Menjívar, Moisés Roberto; Marcos Álvarez, Javier; García Solano, Miguel; Marroyo Palomo, Luis; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación
    The worldwide growth of the PV market has been almost exponential during the last years. Together with conventional crystalline (c-Si) PV modules, “new” commercially available PV technologies such as copper indium selenide (CIS) based solar cells have appeared achieving a similar efficiency comparable to c-Si at similar production cost. In addition to the use of cheaper materials, CIS solar cells manufacturers claim some enhancements such as lower temperature coefficient or higher absorption of diffuse light that achieve to reduce the cost of electrical energy. Although several papers deal with this topic, little is known about real comparisons between CIS technology and conventional crystalline at a PV generator level with real test conditions. This paper analyses the in-field performance and degradation of a commercially available CIS solar based PV generator compared to a conventional c-Si one during four years of operation attributing the differences observed to the possible factors that can influence in both technologies.
  • PublicationOpen Access
    Outdoor performance of a CdTe based PV generator during 5 years of operation
    (IEEE, 2022) Guerra Menjívar, Moisés Roberto; Parra Laita, Íñigo de la; Marcos Álvarez, Javier; García Solano, Miguel; Marroyo Palomo, Luis; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
    Together with the huge growth of the traditional crystalline silicon (Si-x) PV manufacturers, other thin-film solar cells have also emerged such as cadmium telluride (CdTe) manufacturers. They are characterized by the fact that they were created to reduce costs and by the scarcity of silicon, from which the rest of the modules are made. Despite they need more space to generate the same amount of energy as crystalline modules, their price is supposed to be much lower, and argue that they have a better performance at high temperatures. However, real comparisons between the outdoor performance of CdTe and Si-x modules have been scarcely addressed in the literature. This paper provides a comparison under real operating conditions of a CdTe photovoltaic generator versus a conventional silicon generator during 5 years of operation in a mid-latitude area, identifying the causes of the differences observed.
  • PublicationOpen Access
    Control strategies to smooth short-term power fluctuations in large photovoltaic plants using battery storage systems
    (MDPI, 2014) Marcos Álvarez, Javier; Parra Laita, Íñigo de la; García Solano, Miguel; Marroyo Palomo, Luis; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
    The variations in irradiance produced by changes in cloud cover can cause rapid fluctuations in the power generated by large photovoltaic (PV) plants. As the PV power share in the grid increases, such fluctuations may adversely affect power quality and reliability. Thus, energy storage systems (ESS) are necessary in order to smooth power fluctuations below the maximum allowable. This article first proposes a new control strategy (step-control), to improve the results in relation to two state-of-the-art strategies, ramp-rate control and moving average. It also presents a method to quantify the storage capacity requirements according to the three different smoothing strategies and for different PV plant sizes. Finally, simulations shows that, although the moving-average (MA) strategy requires the smallest capacity, it presents more losses (2–3 times more) and produces a much higher number of cycles over the ESS (around 10 times more), making it unsuitable with storage technologies as lithium-ion. The step-control shown as a better option in scenery with exigent ramp restrictions (around 2%/min) and distributed generation against the ramp-rate control in all ESS key aspects: 20% less of capacity, up to 30% less of losses and a 40% less of ageing. All the simulations were based on real PV production data, taken every 5 s in the course of one year (2012) from a number of systems with power outputs ranging from 550 kW to 40 MW.
  • PublicationOpen Access
    Influence of control in cycling degradation when batteries perform PV ramp-rate control
    (IEEE, 2023) González Moreno, Alejandro; Marcos Álvarez, Javier; Parra Laita, Íñigo de la; Marroyo Palomo, Luis; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    This work studies the importance of the correct selection of control parameters in order to avoid unnecessary cycling in batteries when they perform PV smoothing. The classic ramp-rate control method (CRRC) is studied as smoothing technique and the key role of the state of charge (SOC) control is analyzed for a real 38.5 MW PV plant, particularly the influence of proportional gain (K). Depending on K, battery cycling degradation (CyD), power requirements, SOC limits and throughout energy performance were discussed. According to the results, the correct tuning could prolong battery lifespan by reducing cycling degradation up to 80% (depending on the fluctuation restrictions and K) and avoiding unnecessary energy losses, power requirements and undesirable SOC operation levels. Finally, a simple general rule is proposed to set K value when CRRC is used and its applicability is tested by simulating two additional PV plants with rated power of 1.1 and 75.6 MW.
  • PublicationOpen Access
    Compensation of forecast error in large PV plants with battery storage: associated strategies
    (2017) Marcos Álvarez, Javier; Parra Laita, Íñigo de la; Muñoz Escribano, Mikel; García Solano, Miguel; Marroyo Palomo, Luis; Ingeniaritza Elektrikoa eta Elektronikoa; Institute of Smart Cities - ISC; Ingeniería Eléctrica y Electrónica
    As penetration rates of utility-scale photovoltaics (PV) increases, large PV plants will participate in the daily wholesale electricity market in the same way that wind farms. Then, PV plant owner can receive some kind of economic penalty depending on the forecast deviation. This opens the way to use a battery energy storage system (BESS) to compensate the prediction errors. Taking advance of the several 1-hour intra-diary market sessions, the PV plant owner can correct the prediction for the next hours. Hence, a 1-hour BESS SOC control can be implemented to avoid large energy requirements. Here we present two novel strategies which allow a large PV-BESS plant to fulfil the programme referred.
  • PublicationOpen Access
    A PV ramp-rate control strategy to extend battery lifespan using forecasting
    (Elsevier, 2022) González Moreno, Alejandro; Marcos Álvarez, Javier; Parra Laita, Íñigo de la; Marroyo Palomo, Luis; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    This study analyses and presents a new ramp-rate control algorithm for smoothing PV power fluctuations, designed to address three fundamental objectives: to reduce battery cycling, to meet minimum storage requirements and to be able to operate, without ramp-rate violations, with real publicly-available forecasting. The algorithm was compared to three benchmark methods and, as a performance limit, also to a hypothetical perfect prediction. Different performance variables were analyzed for all the strategies within a restricted ramp-rate constraint (2%/min): minimum storage requirement, battery power distributions, throughput energy, state of charge (SOC) distributions, degradation (calendar and cycling), expected battery lifespan and levelized cost of energy (LCOE). The proposal proves to be the most cost-effective smoothing technique and the simulation results show that its performance is comparable to the obtained with the use of an assumed perfect prediction.
  • PublicationOpen Access
    Control method to coordinate inverters and batteries for power ramp-rate control in large PV plants: minimizing energy losses and battery charging stress
    (Elsevier, 2023) González Moreno, Alejandro; Marcos Álvarez, Javier; Parra Laita, Íñigo de la; Marroyo Palomo, Luis; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    This work presents a novel control method for multi-megawatt photovoltaic (PV) plants that is able to regulate each plant inverter and the battery system to mitigate PV power fluctuations. The proposed control method makes it possible to implement different PV ramp-rate control strategies based on the use of batteries and the limitation of inverters during positive fluctuations, which have been conceptually proposed in the specialized bibliography, but have omitted how to perform the coordination between PV generators. The dynamic model and the tuning of the control parameters are presented and the method is used to correctly implement different inverter-limitation strategies using 5-second data from a real 45 MWp PV plant. Furthermore, a new control strategy is proposed. This strategy reduces curtailment losses to negligible values and takes into account and addresses the intrinsic asymmetry in the battery charging and discharging capability, an issue that has been overlooked in the specialized bibliography. The results show that the proposed control method can effectively control each of the multiple inverters in order to obtain the desired PV plant operation to regulate the battery charging power, even during highly fluctuating scenarios.
  • PublicationOpen Access
    The potential of forecasting in reducing the LCOE in PV plants under ramp-rate restrictions
    (Elsevier, 2019) Cirés Buey, Eulalia; Marcos Álvarez, Javier; Parra Laita, Íñigo de la; García Solano, Miguel; Marroyo Palomo, Luis; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
    An increasing number of grid codes are requiring the limitation of the PV output power fluctuation over a given time scale. Batteries represent the most obvious solution to smooth power fluctuations, with the corresponding negative impact on the PV energy cost. However, short-term forecasting is currently being proposed as a tool to reduce battery capacity requirements or even completely remove it. Although these solutions decrease or avoid the battery cost, it also entails some energy curtailment losses which obviously raise the final cost of PV energy. This energy losses, currently unknown, are independent of the forecasting accuracy and represent the minimal additional cost in the hypothetical case of a perfect prediction. Thus, this paper compares Levelized Cost of Energy (LCOE) of three ramp-rate control strategies in order to determine which would give the lowest cost: battery-based, ideal short-term forecasting, or a combination of both. Results show that curtailment losses would be small enough to make battery-less strategy an appropriate choice, so it is worthwhile improving short-term forecasting in view of the potential LCOE savings. Database is taken from high resolution measurements recorded for over a year at 8 PV plants ranging from 1 to 46 MWp.
  • PublicationOpen Access
    Inverter-based PV ramp-rate limitation strategies: minimizing energy losses
    (IEEE, 2022) González Moreno, Alejandro; Marcos Álvarez, Javier; Parra Laita, Íñigo de la; Marroyo Palomo, Luis; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    This work analyzes the reduction of power generation in strategies that regulate the PV ramp-rate by using inverter limitation. Although the operating principle implies some energy production losses, not all these losses are necessary. Three different strategies were simulated using experimental 5-second data collected throughout a year at a 38.6 MW PV plant, and their energy losses were obtained for different ramprate levels. An improvement in one of these strategies is proposed and evaluated. The main findings suggest that the proposed modification has the potential to drastically reduce annual production losses to insignificant levels. Regardless of the ramp-rate constrain, simulation results evidenced energy losses bellow 1%.
  • PublicationOpen Access
    On the calculation of the STC power of PV generators by using typical monitoring system data
    (2017) Muñoz Escribano, Mikel; Parra Laita, Íñigo de la; García Solano, Miguel; Marcos Álvarez, Javier; Marroyo Palomo, Luis; Ingeniaritza Elektrikoa eta Elektronikoa; Institute of Smart Cities - ISC; Ingeniería Eléctrica y Electrónica
    The properly in-field characterization of the power at Standard Test Conditions, PSTC, of PV generators is becoming increasingly important in order to evaluate their performance and its evolution in time. Within the state of art, the PSTC characterization procedures of PV arrays are mainly based on I-V curve measurements or PDC measurements performed by precision wattmeters. Those characterizations are usually carried out during discrete measurement campaigns, which does not allow a continuous tracking of the PSTC evolution. In this paper a new PSTC characterization procedure is proposed which is based on the DC power measurements performed by the own PV inverters connected to the PV arrays. This procedure enables an automatic and continuous calculation of the PSTC, which allows to observe its evolution and to detect possible anomalous trends, premature degradations, etc. The procedure has been validated in several PV generators of the large-scale Amareleja PV Plant (45.6 MWp). As showed in this paper, by using several day data and applying the adequate filters, a high accuracy in the PSTC calculation can be achieved, a similar accuracy to that obtained by using precision wattmeter measurements.