Open Access
Stabilization of dual-wavelength erbium doped ring fiber lasers by single-mode operation
(IEEE, 2010) Quintela, M. A.; Pérez Herrera, Rosa Ana; Canales, Irene; Fernández Vallejo, Montserrat; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
In this work, a novel single-longitudinal-mode (SLM) dual-wavelength laser configuration is proposed and demonstrated. This laser is based on ring resonators, and employs fiber Bragg gratings to select the operation wavelengths. It includes a short piece of highly doped Er-fiber that acts as the active medium. The stable SLM operation is guaranteed when the two lasing channels present similar output powers. This behavior is shown for different pump powers.
Open Access
L-band multiwavelength single-longitudinal mode fiber laser for sensing applications
(IEEE / OSA, 2012) Pérez Herrera, Rosa Ana; Ullán Nieto, Ángel; Leandro González, Daniel; Fernández Vallejo, Montserrat; Quintela, M. A.; Loayssa Lara, Alayn; López Higuera, José Miguel; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
In this work, a novel single-longitudinal-mode (SLM) four-wavelength laser configuration for sensing applications in the L-band is proposed and experimentally demonstrated. The sensor system presented here is based on ring resonators, and employs fiber Bragg gratings to select the operation wavelengths. The stable SLM operation is guaranteed when all the lasing channels present similar output powers. It is also experimentally demonstrated that when a SLMbehavior is achieved, lower output power fluctuations are obtained. Characterization of the lasing structure for temperature sensing is also shown.
Open Access
Low noise dual-wavelength erbium fiber laser in single-longitudinal-mode operation
(Springer, 2012) Rota Rodrigo, Sergio; Pérez Herrera, Rosa Ana; Fernández Vallejo, Montserrat; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
A new stable dual-wavelength fiber-ring laser based on erbium-doped fiber amplification is reported. The laser is based on ring resonators and employs fiber Bragg gratings to select the operation wavelengths. The topology of the laser has a significant influence in its performance: allowing an independent control of the losses for both lasing wavelengths and achieving a low noise configuration. As a result, it is experimentally demonstrated that both emission lines work in single-longitudinal-mode operation and the topology offers a better stability and higher optical signalto-noise ratios than similar configurations.
Open Access
46-km-long Raman amplified hybrid double-bus network with point and distributed Brillouin sensors
(IEEE, 2012) Fernández Vallejo, Montserrat; Olier Aguado, David; Zornoza Indart, Ander; Pérez Herrera, Rosa Ana; Díaz Lucas, Silvia; Elosúa Aguado, César; Bariáin Aisa, Cándido; Loayssa Lara, Alayn; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
We experimentally demonstrate a 46-km hybrid network that combine point and distributed Brillouin sensors. The proposed sensor network multiplexes low-cost intensity point sensors based on fiber-optic tapers, which are able to measure vibrations in the 0.01 to 50 Hz frequency range. The sensor network with a double-bus is a low noise configuration, which offers a higher optical signal to noise ratio and dynamic range than a single-bus. Thus, the number of sensors to be multiplexed could increase or we could reach further distances. The system also deploys remote distributed Raman amplification to extend the sensing range.
Open Access
Robust fiber-optic sensor networks
(Springer, 2012) Pérez Herrera, Rosa Ana; Fernández Vallejo, Montserrat; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
The ability to operate despite failure will become increasingly important as the use of optical sensor networks grows, and the amount of sensing information to be handled by a sensor network is increasing, especially for safety and security applications. In this review, the four categories of protection to allow service to be reestablished after a failure (dedicated/shared and line/path) are thoroughly discussed. This paper also presents an overview of the most representative robust fiber-optic sensor systems, discussing their schemes, pros and cons.
Open Access
Resilient amplified double ring optical networks to multiplex optical fibre sensors
(IEEE / OSA, 2009) Fernández Vallejo, Montserrat; Pérez Herrera, Rosa Ana; Elosúa Aguado, César; Díaz Lucas, Silvia; Urquhart, Paul; Bariáin Aisa, Cándido; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
We report the experimental demonstration of two configurations of an amplified optical fibre double ring network for the multiplexing of sensors. The networks are designed to be inherently resilient to fibre failures because they enable simultaneous interrogation of all the optical fibre sensors using both rings. The first design demonstrates the feasibility of the so called 'dedicated protection' and the second one 'shared protection' for fibre optic intensity sensors. Raman amplification is used to overcome the losses of the couplers used in the rings, providing power transparency. The first network uses Raman amplification in both constituent rings but in the second one Raman pumping is activated only when a fibre failure occurs. We demonstrate how the topology allows the received powers from the sensors to be equalized.
Open Access
Random fiber lasers: application to fiber optic sensors networks
(IEEE, 2017) López-Amo Sáinz, Manuel; Leandro González, Daniel; Miguel Soto, Verónica de; Bravo Acha, Mikel; Fernández Vallejo, Montserrat; Pérez Herrera, Rosa Ana; Ingeniaritza Elektrikoa eta Elektronikoa; Institute of Smart Cities - ISC; Ingeniería Eléctrica y Electrónica
Recently, random mirrors have been proposed as a method to create fiber laser cavities. This kind of cavity is based on cooperative Rayleigh scattering, which is generated along a fiber due to the material inhomogeneities presented in that fiber. In this work, basics of Random fiber lasers and different demonstrated lasing sensors systems for interrogating arrays of optical fiber sensors are shown. These systems use different kinds of amplification and cavities schemes and can interrogate optical fiber sensors located up to 225 km away.
Open Access
Stability comparison of two ring resonator structures for multiwavelength fiber lasers using highly doped Er-fibers
(IEEE / OSA, 2009) Pérez Herrera, Rosa Ana; Quintela, M. A.; Fernández Vallejo, Montserrat; Quintela, Antonio; López-Amo Sáinz, Manuel; López Higuera, José Miguel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
An experimental comparison of stability between two different fiber laser topologies is carried out. The lasers are based on ring resonators that include highly-doped Er-fibers. Both topologies use fiber Bragg grating reflectors in order to select the emission wavelengths. The experimental results confirms that the novel topology based on fiber optic circulators arranged in an hybrid serial-parallel configuration offers a better stability and higher optical signal to noise ratios (OSNR) than the simpler based on a parallel configuration.