Open Access
Linear fiber laser configurations for optical concentration sensing in liquid solutions
(MDPI, 2024) Soares, Liliana; Pérez Herrera, Rosa Ana; Novais, Susana; Ferreira, António; Silva, Susana; Frazão, Orlando; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza; Institute of Smart Cities - ISC
In this study, different configurations based on linear fiber lasers were proposed and experimentally demonstrated to measure the concentration of liquid solutions. Samples of paracetamol liquid solutions with different concentrations, in the range from 52.61 to 201.33 g/kg, were used as a case-study. The optical gain was provided by a commercial bidirectional Erbium-Doped Fiber Amplifier (EDFA) and the linear cavity was obtained using two commercial Fiber Bragg Gratings (FBGs). The main difference of each configuration was the coupling ratio of the optical coupler used to extract the system signal. The sensing head corresponded to a Single-Mode Fiber (SMF) tip that worked as an intensity sensor. The results reveal that, despite the optical coupler used (50:50, 60:40, 70:30 or 80:20), all the configurations reached the laser condition, however, the concentration sensing was only possible using a laser drive current near to the threshold value. The configurations using a 70:30 and an 80:20 optical coupler allowed paracetamol concentration measurements with a higher sensitivity of (−3.00 ± 0.24) pW/(g/kg) to be performed. In terms of resolution, the highest value obtained was 1.75 g/kg, when it was extracted at 20% of the output power to the linear cavity fiber laser configuration.
Open Access
Study of in-line capillary fiber sensor for uniaxial transverse deformation
(IEEE, 2024-08-06) Sánchez González, Arturo; Leandro González, Daniel; Dauliat, Romain; Jamier, Raphael; Roy, Philippe; Pérez Herrera, Rosa Ana; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza; Institute of Smart Cities - ISC; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa, PJUPNA06-2022
This research explores the impact of cyclic uniaxial transverse deformation on an in-line hollow-core fiber etalon. The structure consists of a 6 mm long section of capillary fiber spliced between two standard single-mode fibers. The optical response of the structure is theoretically analyzed in spectral and transformed domains, evidencing Fabry-Perot and antiresonant interferometric mechanisms. A validation of the theoretical behavior is carried out both through simulation and experimentation. The performance of the structure for uniaxial transverse deformation is subsequently evaluated by tracking the phase of the main component in the transformed domain. The relevance of measuring in the time domain is discussed, demonstrating improved accuracy over wavelength shift and inverse spatial domain methods. Several sensors with different internal diameters underwent cycles of transverse deformation, revealing robust linear trends in every case. On average, the structure demonstrated elastic behavior under deformations up to 42 μm, with a mean sensitivity of 0.174 rad/μm, and mechanical breakage taking place at 58 μm. The results confirmed the suitability of the sensor to withstand uniaxial micro-displacements or pressures, with smaller inner diameter capillary fibers showing the best performance.
Open Access
High frequency vibration sensor using a fiber laser with a multicore fiber interferometer
(IEEE, 2024) Correa Serrano, Ángel Ignacio; Galarza Galarza, Marko; Dauliat, Romain; Jamier, Raphael; Roy, Philippe; López-Amo Sáinz, Manuel; Pérez Herrera, Rosa Ana; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza; Institute of Smart Cities - ISC
We present an interferometric vibration sensor that uses three-core fibers. The transducer is constructed by splicing a segment 20 mm long of a multicore optical fiber (MCF) to a single-mode optical fiber (SMF). The end of the MCF segment is cut off and painted using silver metallic paint. The sensor head is operated in reflection mode. The structure is placed on a polyvinyl chloride (PVC) plate, which is excited with a wide range of frequency signals. The vibrations induce cyclic bending in the MCF segment, resulting in periodic oscillations of the reflected interference spectrum. This device is demonstrated to be suitable to measure vibrations in a frequency range of the order of 300 kHz detecting deformations as small as 0.40μm .
Open Access
Liquid level sensor based on dynamic Fabry–Perot interferometers in processed capillary fiber
(Springer Nature, 2021) Roldán Varona, Pablo; Pérez Herrera, Rosa Ana; Rodríguez Cobo, Luis; Reyes González, Luis; López-Amo Sáinz, Manuel; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
In this work, a novel optical fiber sensor capable of measuring both the liquid level and its refractive index is designed, manufactured and demonstrated through simulations and experimentally. For this, a silica capillary hollow-core fiber is used. The fiber, with a sensing length of 1.55 mm, has been processed with a femtosecond laser, so that it incorporates four holes in its structure. In this way, the liquid enters the air core, and it is possible to perform the sensing through the Fabry–Perot cavities that the liquid generates. The detection mode is in reflection. With a resolution of 4 μm (liquid level), it is in the state of the art of this type of sensor. The system is designed so that in the future it will be capable of measuring the level of immiscible liquids, that is, liquids that form stratified layers. It can be useful to determine the presence of impurities in tanks.
Open Access
Hybrid Raman‑erbium random fiber laser with a half open cavity assisted by artificially controlled backscattering fiber refectors
(Springer Nature, 2021) Pérez Herrera, Rosa Ana; Roldán Varona, Pablo; Galarza Galarza, Marko; Sañudo-Lasagabaster Ibáñez, Silvia; Rodríguez Cobo, Luis; López Higuera, José Miguel; López-Amo Sáinz, Manuel; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa, PJUPNA1928
A hybrid Raman-erbium random fber laser with a half-open cavity assisted by chirped artifcially controlled backscattering fber refectors is presented. A combination of a 2.4 km-long dispersion compensating fber with two highly erbium-doped fber pieces of 5 m length were used as gain media. A single random laser emission line centered at 1553.8 nm with an optical signal to noise ratio of 47 dB were obtained when pumped at 37.5 dBm. A full width at half maximum of 1 nm and a 100% confdence level output power instability as low as 0.08 dB were measured. The utilization of the new laser cavity as a temperature and strain sensor is also experimentally studied.
Open Access
Innovative approaches for organizing an inclusive optics and photonics conference in virtual format
(MDPI, 2023) Heras, Alba de las; Gómez Varela, Ana Isabel; Tomás, María-Baralida; Pérez Herrera, Rosa Ana; Sánchez, Luis Alberto; Gallazzi, Francesca; Santamaría, Beatriz; García Lechuga, Mario; Vinas María; Delgado Pinar, Martina; González Fernández, Verónica; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
The COVID pandemic is forcing the renewal of scientific conferences, offering opportunities to introduce technological and inclusive developments. Our analysis focuses on the implementation of inclusive practices for female and early-career researchers in a virtual scientific conference. This organization approach was applied in the XIII Spanish Optical Meeting (RNO2021), which was also characterized by avatars interacting in an online metaverse. The effectiveness of inclusive policies and novel technological tools was evaluated using the participation data and a post-conference survey. Our study reveals the high impact of inclusive actions and a strong interest in the scientific community to explore conference advances.
Open Access
Diseño y caracterización de reflectores incoherentes de retrodispersión de fibra microperforada para láseres random de fibra óptica
(SEDOPTICA, 2021) Galarza Galarza, Marko; Sañudo-Lasagabaster Ibáñez, Silvia; Pérez Herrera, Rosa Ana; Roldán Varona, Pablo; Rodríguez Cobo, Luis; López Higuera, José Miguel; López-Amo Sáinz, Manuel; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa, PJUPNA 1928
Los láseres random de fibra óptica presentan una serie de características que los hacen idóneos para una gran variedad de aplicaciones industriales. La elevada longitud de fibra necesaria en la cavidad debido a sus bajos índices de dispersión Rayleigh, se reduce utilizando fibras de baja área efectiva (compensadoras de dispersión), o generando artificialmente elementos muy dispersivos. En este trabajo presentamos el diseño de reflectores aleatorios de tan solo varios milímetros, generados mediante microperforación del núcleo con un láser de femtosegundo y su utilización en la cavidad de una estructura láser.
Open Access
Ring cavity erbium-doped fiber for refractive index measurements
(MDPI, 2022) Pérez Herrera, Rosa Ana; Soares, Liliana; Silva, Susana; Frazão, Orlando; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
In this study, an interrogation system based on an erbium-doped fiber ring cavity for refractive index measurements is presented and experimentally demonstrated. This cavity ring includes a 1 × 3 coupler wherein one of the fiber output ports is used to increase the optical power of the system by means of an FBG used as a reflector. The other two output ports are used as a refractive index sensing head and reference port, respectively. An experimental demonstration of this proposed sensor system for the measurement of a distinct refractive index is presented.
Open Access
Multicore fiber sensors for strain measurement towards traffic monitoring
(SPIE, 2023) Sánchez González, Arturo; Pradas Martínez, Javier; Corera Orzanco, Íñigo; Bravo Acha, Mikel; Leandro González, Daniel; Dauliat, Romain; Jamier, Raphael; Roy, Philippe; Pérez Herrera, Rosa Ana; López-Amo Sáinz, Manuel; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa, PJUPNA06-2022
In this work, two new interferometric sensors based on multicore optical fibers for the measurement of strain with the ultimate goal of traffic monitoring are presented. The operating principle of each sensor relied on the monitoring of the phase shift difference accumulated between the supermodes of the structure of the multicore segment in a full round trip. The strain characterization for both sensors resulted in a linear response, with sensitivities of -4.073·10-3 rad/με and - 4.389·10-3 rad/με for the aligned and V-shaped cases respectively, and one-hour instabilities below 4.6·10-3 rad with a 95% confidence level. These results suggest its feasibility in applications requiring high sensitivities over very wide strain ranges, such as heavy-vehicle traffic monitoring. To corroborate the hypothesis, both sensors were integrated into the pavement and their response to the traffic was analyzed.
Open Access
Cavidad láser de fibra óptica multibanda basada en reflectores pseudoaleatorios cuasidistribuidos
(Sociedad Española de Óptica, 2021) Sánchez González, Arturo; Pérez Herrera, Rosa Ana; Roldán Varona, Pablo; Rodríguez Cobo, Luis; López Higuera, José Miguel; López-Amo Sáinz, Manuel; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa, PJUPNA 1928
En este trabajo se presenta un análisis experimental de las prestaciones alcanzadas por una cavidad láser en línea asistida por un reflector de fibra con retrodispersión controlada artificialmente (RFRCA). Dicho reflector ha sido concebido para permitir oscilación en un único modo longitudinal (SLM) en bandas C y L, presentando inestabilidades en potencia de emisión inferiores a 0.1 dB y relaciones de señal óptica a ruido (OSNR) superiores a 44 dB.