Open Access
Láser random de fibra óptica asistido por reflectores de fibra con retrodispersión controlada artificialmente
(SEDOPTICA, 2021) Pérez Herrera, Rosa Ana; Roldán Varona, Pablo; Galarza Galarza, Marko; Sañudo-Lasagabaster Ibáñez, Silvia; Rodríguez Cobo, Luis; López Higuera, José Miguel; López-Amo Sáinz, Manuel; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa, PJUPNA1928
Este trabajo presenta un láser de fibra tipo random (LFR) en cavidad semi-abierta, mediante amplificación híbrida Raman-Erbio y asistida por reflectores de fibra con retrodispersión controlada artificialmente (RFRCA). Como medio activo se ha empleado una combinación de 2,4 km de fibra compensadora de dispersión con dos tramos de fibra altamente dopada con erbio de 5 m cada uno. Se ha obtenido una única línea de emisión láser centrada a en 1553.8 nm y con una relación señal a ruido óptica de 47 dB cuando en la estructura se inyectaba una potencia de bombeo de 37.5 dBm. Además, se ha medido la estabilidad en términos de potencia de salida de este láser durante 3 horas, obteniendo una inestabilidad tan baja como 0,08 dB con un nivel de confianza del 100%.
Open Access
Long-range hybrid network with point and distributed Brillouin sensors using Raman amplification
(Optical Society of America, 2010) Zornoza Indart, Ander; Pérez Herrera, Rosa Ana; Elosúa Aguado, César; Díaz Lucas, Silvia; Bariáin Aisa, Cándido; Loayssa Lara, Alayn; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
We propose a novel concept for hybrid networks that combine point and distributed Brillouin sensors in a cost-effective architecture that also deploys remote distributed Raman amplification to extend the sensing range. A 46-km proof-of-concept network is experimentally demonstrated integrating point vibration sensors based on fiber Bragg gratings and tapers with distributed temperature sensing along the network bus. In this network the use of Raman amplification to compensate branching and fiber losses provides a temperature resolution of 0.7°C and 13 m. Moreover, it was possible to obtain good optical signal to noise ratio in the measurements from the four point vibration sensors that were remotely multiplexed in the network. These low-cost intensity sensors are able to measure vibrations in the 0.1 to 50 Hz frequency range, which are important in the monitoring of large infrastructures such as pipelines.
Open Access
Diseño y caracterización de reflectores incoherentes de retrodispersión de fibra microperforada para láseres random de fibra óptica
(SEDOPTICA, 2021) Galarza Galarza, Marko; Sañudo-Lasagabaster Ibáñez, Silvia; Pérez Herrera, Rosa Ana; Roldán Varona, Pablo; Rodríguez Cobo, Luis; López Higuera, José Miguel; López-Amo Sáinz, Manuel; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa, PJUPNA 1928
Los láseres random de fibra óptica presentan una serie de características que los hacen idóneos para una gran variedad de aplicaciones industriales. La elevada longitud de fibra necesaria en la cavidad debido a sus bajos índices de dispersión Rayleigh, se reduce utilizando fibras de baja área efectiva (compensadoras de dispersión), o generando artificialmente elementos muy dispersivos. En este trabajo presentamos el diseño de reflectores aleatorios de tan solo varios milímetros, generados mediante microperforación del núcleo con un láser de femtosegundo y su utilización en la cavidad de una estructura láser.
Open Access
Robust fiber-optic sensor networks
(Springer, 2012) Pérez Herrera, Rosa Ana; Fernández Vallejo, Montserrat; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
The ability to operate despite failure will become increasingly important as the use of optical sensor networks grows, and the amount of sensing information to be handled by a sensor network is increasing, especially for safety and security applications. In this review, the four categories of protection to allow service to be reestablished after a failure (dedicated/shared and line/path) are thoroughly discussed. This paper also presents an overview of the most representative robust fiber-optic sensor systems, discussing their schemes, pros and cons.
Open Access
Wavelength-switchable L-band fiber laser assisted by random reflectors
(EDP Open, 2023) Pérez Herrera, Rosa Ana; Roldán Varona, Pablo; Sánchez González, Arturo; Rodríguez Cobo, Luis; López Higuera, José Miguel; López-Amo Sáinz, Manuel; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
A wavelength-switchable L-band erbium-doped fiber laser (EDFL) assisted by an artificially controlled backscattering (ACB) fiber reflector is here presented. This random reflector was inscribed by femtosecond (fs) laser direct writing on the axial axis of a multimode fiber with 50 lm core and 125 lm cladding with a length of 17 mm. This microstructure was placed inside a surgical syringe to be positioned in the center of a high-precision rotation mount to accurately control its angle of rotation. Only by rotating this mount, three different output spectra were obtained: a single wavelength lasing centered at 1574.75 nm, a dual wavelength lasing centered at 1574.75 nm and 1575.75 nm, and a single wavelength lasing centered at 1575.5 nm. All of them showed an optical signal-to-noise ratio (OSNR) of around 60 dB when pumped at 300 mW
Open Access
Resilient amplified double ring optical networks to multiplex optical fibre sensors
(IEEE / OSA, 2009) Fernández Vallejo, Montserrat; Pérez Herrera, Rosa Ana; Elosúa Aguado, César; Díaz Lucas, Silvia; Urquhart, Paul; Bariáin Aisa, Cándido; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
We report the experimental demonstration of two configurations of an amplified optical fibre double ring network for the multiplexing of sensors. The networks are designed to be inherently resilient to fibre failures because they enable simultaneous interrogation of all the optical fibre sensors using both rings. The first design demonstrates the feasibility of the so called 'dedicated protection' and the second one 'shared protection' for fibre optic intensity sensors. Raman amplification is used to overcome the losses of the couplers used in the rings, providing power transparency. The first network uses Raman amplification in both constituent rings but in the second one Raman pumping is activated only when a fibre failure occurs. We demonstrate how the topology allows the received powers from the sensors to be equalized.
Open Access
46-km-long Raman amplified hybrid double-bus network with point and distributed Brillouin sensors
(IEEE, 2012) Fernández Vallejo, Montserrat; Olier Aguado, David; Zornoza Indart, Ander; Pérez Herrera, Rosa Ana; Díaz Lucas, Silvia; Elosúa Aguado, César; Bariáin Aisa, Cándido; Loayssa Lara, Alayn; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
We experimentally demonstrate a 46-km hybrid network that combine point and distributed Brillouin sensors. The proposed sensor network multiplexes low-cost intensity point sensors based on fiber-optic tapers, which are able to measure vibrations in the 0.01 to 50 Hz frequency range. The sensor network with a double-bus is a low noise configuration, which offers a higher optical signal to noise ratio and dynamic range than a single-bus. Thus, the number of sensors to be multiplexed could increase or we could reach further distances. The system also deploys remote distributed Raman amplification to extend the sensing range.
Open Access
Simultaneous measurement of strain and temperature based on clover microstructured fiber loop mirror
(Elsevier, 2015) Pérez Herrera, Rosa Ana; André, R. M.; Silva, S. F.; Becker, M.; Schuster, K.; Kobelke, J.; López-Amo Sáinz, Manuel; Santos, José Luís; Frazão, Orlando; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
In this work, two all-fiber loop mirrors using a clover microstructured fiber for the simultaneous measurement of temperature and strain are presented. The sensing heads are formed by a short piece of clover microstructured fiber with 35 mm and 89 mm length respectively. The geometry of the fiber allowed observing different interferences created by the microstructured fiber core section. Different sensitivities to temperature and strain were obtained and, using a matrix method, it is possible to discriminate both physical parameters. Resolutions of ±2ºC and ±11 μ for the first structure and ±2.3ºC and ±18 μ for the second one, for temperature and strain, respectively, were attained.
Open Access
Multiplexing optical fiber Fabry-Perot interferometers based on air-microcavities
(SPIE, 2019) Pérez Herrera, Rosa Ana; Novais, Susana; Bravo Acha, Mikel; Leandro González, Daniel; Silva, Susana; Frazão, Orlando; López-Amo Sáinz, Manuel; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación
In this work we demonstrate the multiplexing capability of new optical fiber Fabry-Perot interferometers based on airmicrocavities using a commercial FBG interrogator. Three optimized air-microcavity interferometer sensors have been multiplexed in a single network and have been monitored using the commercial FBGs interrogator in combination with FFT calculations. Results show a sensitivity of 2.18 π rad/mε and a crosstalk-free operation.
Open Access
Study of in-line capillary fiber sensor for uniaxial transverse deformation
(IEEE, 2024-08-06) Sánchez González, Arturo; Leandro González, Daniel; Dauliat, Romain; Jamier, Raphael; Roy, Philippe; Pérez Herrera, Rosa Ana; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza; Institute of Smart Cities - ISC; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa, PJUPNA06-2022
This research explores the impact of cyclic uniaxial transverse deformation on an in-line hollow-core fiber etalon. The structure consists of a 6 mm long section of capillary fiber spliced between two standard single-mode fibers. The optical response of the structure is theoretically analyzed in spectral and transformed domains, evidencing Fabry-Perot and antiresonant interferometric mechanisms. A validation of the theoretical behavior is carried out both through simulation and experimentation. The performance of the structure for uniaxial transverse deformation is subsequently evaluated by tracking the phase of the main component in the transformed domain. The relevance of measuring in the time domain is discussed, demonstrating improved accuracy over wavelength shift and inverse spatial domain methods. Several sensors with different internal diameters underwent cycles of transverse deformation, revealing robust linear trends in every case. On average, the structure demonstrated elastic behavior under deformations up to 42 μm, with a mean sensitivity of 0.174 rad/μm, and mechanical breakage taking place at 58 μm. The results confirmed the suitability of the sensor to withstand uniaxial micro-displacements or pressures, with smaller inner diameter capillary fibers showing the best performance.