Open Access
Measurement of paracetamol concentration using a fiber laser system
(IEEE, 2023) Soares, Liliana; Pérez Herrera, Rosa Ana; Novais, Susana; Ferreira, António; Frazão, Orlando; Silva, Susana; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
A linear fiber laser system for measurements of paracetamol concentration is experimentally demonstrated. The cavity is based on a fiber loop mirror and an FBG centered at 1567.8 nm. The sensing head corresponds to a refractometric sensor, whose which principle of operation is based on Fresnel reflection in the fiber tip (FBG side). The system works at detected variations of paracetamol concentrations with a sensitivity of [8.74± 0.34)× 10-5] µW/(g/kg) and a resolution of 2.77 g/kg. The results prove that the fiber laser system could be an asset for processing industries, specifically for non-invasive and real-time measurements of concentration.
Open Access
Optimizing graphene oxide saturable absorbers for short pulse generation in fiber lasers: characterization and aging assessment
(SPIE, 2024-06-20) Monteiro, Catarina S.; Pérez Herrera, Rosa Ana; Silva, Nuno A.; Silva, Susana; Frazão, Orlando; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza; Institute of Smart Cities - ISC
The generation of short pulses in fiber lasers using saturable absorbers made of graphene oxide (GO), focusing on film thickness, was studied and optimized. The saturable absorber comprised a GO thin film deposited onto a single-mode fiber using the spray coating technique. Water-dispersed GO with a concentration of 4 mg/mL, characterized by a high proportion of monolayer flakes, was employed. This thin film was integrated into a cavity ring laser featuring an erbium-doped fiber amplifier (EDFA), resulting in a fiber laser emitting at a central emission wavelength of approximately 1564 nm and having a total cavity length of approximately 120 m. By controlling intracavity polarization, short-pulsed light was generated through mode-locking, Q switching, or a combination of both regimes. This work presents a comprehensive characterization of the cavity ring laser operating under the mode-locking regime. It encompasses an analysis of the spectral behavior, focusing on the evolution of the Kelly¿s sidebands with increasing pump power, as well as an assessment of its temporal stability. Moreover, the effects of the aging of the saturable absorber material were studied after a time period of 6 months after the fabrication. It was observed that the general characteristics of spectral signal of the laser were maintained, with long-term stability.
Open Access
Láseres de fibra óptica basados en reflectores clásicos, estrechados y microperforados
(SEDOPTICA, 2021) Sánchez González, Arturo; Pérez Herrera, Rosa Ana; Roldán Varona, Pablo; Rodríguez Cobo, Luis; López Higuera, José Miguel; López-Amo Sáinz, Manuel; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa, PJUPNA1928
En este trabajo se presenta un estudio comparativo entre distintos láseres de fibra óptica altamente dopada con erbio, con cavidades lineales conformadas tanto por reflectores puntuales clásicos como reflectores distribuidos. El estudio analiza experimentalmente las principales prestaciones de cada configuración, destacando las mejoras en estabilidad de emisión y estrechamiento de línea alcanzadas con fibras estrechadas microperforadas.
Open Access
Short pulse generation in erbium-doped fiber lasers using graphene oxide as a saturable absorber
(Science and Technology Publications, Lda., 2023) Monteiro, Catarina S.; Pérez Herrera, Rosa Ana; Silva, Susana; Frazão, Orlando; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza; Institute of Smart Cities - ISC
The use of graphene oxide (GO) as a saturable absorber for short pulses generation in an Erbium-doped fiber laser was studied and demonstrated. The saturable absorber consisted of a thin GO film, with a high concentration of monolayer GO flakes, spray-coated on the end face of a ferrule-connected fiber. By including the saturable absorber in the laser cavity and controlling the intra-cavity polarization, the generation of short-pulsed light was achieved under mode-locking and Q-switching operations. Under mode-locking operation, it was observed a pulse train with a fundamental repetition rate of 1.48 MHz, with a working wavelength centered at 1564.4 nm. In the Q-switch operation, a pulse train with a 12.7 kHz repetition rate and a 14.3 µs pulse duration was attained for a 230-mA pump current. Further investigation showed a linear dependence of the repetition rate with the pump power, attaining frequencies between 12.7 and 14.4 kHz.
Open Access
Influence of saturable absorbers on fiber ring laser sensors
(SPIE, 2017) Rodríguez Cobo, Luis; Quintela, M. A.; Ruiz Lombera, Rubén; Pérez Herrera, Rosa Ana; López-Amo Sáinz, Manuel; López Higuera, José Miguel; Ingeniaritza Elektrikoa eta Elektronikoa; Institute of Smart Cities - ISC; Ingeniería Eléctrica y Electrónica
In this work, a fiber ring laser sensor has been employed to analyze the influence of passive Er-doped fiber acting as saturable absorber. Lasing modes of fiber ring lasers can be reduced by properly locating a saturable absorber that narrows the spectral width of the FBG that selects the lasing wavelength. Employing commercial Er-doped fiber, different configurations have been evaluated, reaching the SLM regime on a ring cavity of several meters. Thus, the achieved strain response of the whole sensor behaves at its mirror FBG, exhibiting linear response to strain.