Open Access
Zn-Ti-Al layered double hydroxides synthesized from aluminum saline slag wastes as efficient drug adsorbents
(Elsevier, 2020) Santamaría Arana, Leticia; López Aizpún, María; García Padial, Marcos; Vicente, Miguel Ángel; Korili, Sophia A.; Gil Bravo, Antonio; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Ciencias; Gobierno de Navarra / Nafarroako Gobernua, PI017-PI039 CORRAL; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
This work reports the synthesis of Zinc-Titanium-Aluminum (ZnTiAl) layered double hydroxides (LDH) with various proportions of Al[sbnd]Ti and a Zn/(Al[sbnd]Ti) molar ratio of 3:1 by the co-precipitation method. Two series, made with commercial aluminum (Al) and aluminum extracted from saline slags (Al*), have been considered. Structural characterization and comparison of the two series has been made using powder X-ray diffraction (PXRD), Nitrogen physisorption at 77 K, Scanning electron microscopy (SEM), X-ray photoelectron spectroscopy (XPS) and Thermogravimetry measurements. The adsorption capacity of diclofenac and salicylic acid, as examples of emergent pollutants, by the different LDH on batch and fixed-bed column experiments has been analyzed. The effect of various parameters, such as the pH, the initial concentration of pollutant, the mass of adsorbent and the contact time, on the sorption behavior were studied and compared. The contact time to attain equilibrium for maximum adsorption was found to be between 100 and 400 min. The kinetic and equilibrium results were correlated to several adsorption and isotherm equation models. The synthesized materials were more effective in removing diclofenac than salicylic acid, being Zn6Al*2 the hydrotalcite that showed the highest adsorption capacity. The results showed a new application of a material obtained from the valorization of an industrial waste such as aluminum saline slags.
Open Access
Effect of the surface properties of Me2+/Al layered double hydroxides synthesized from aluminum saline slag wastes on the adsorption removal of drugs
(Elsevier, 2020) Santamaría Arana, Leticia; Devred, F.; Gaigneaux, E. M.; Korili, Sophia A.; Gil Bravo, Antonio; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Ciencias; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa; Gobierno de Navarra / Nafarroako Gobernua, PI017-PI039 CORRAL
This work presents the synthesis of Me2+ (Co, Mg, Ni and Zn)/Al layered double hydroxides (LDH) with a 3:1 M ratio by the co-precipitation method. Structural characterization and comparison of the series has been achieved using powder X-ray diffraction (PXRD), scanning electron microscopy (SEM), nitrogen physisorption at 77 K, thermogravimetry measurements (TGA), temperature-programmed reduction (TPR), X-ray photoelectron spectroscopy (XPS), ammonia temperature-programmed desorption (NH3-TPD) and point of zero charge (pHpzc). Batch experiments were performed to analyze the adsorption capacity of the different LDH on diclofenac and salicylic acid, as example of emergent pollutants. The pH, mass of adsorbent, contact time and concentration of pollutant were the parameters used to compare the adsorption performance of the synthesized materials. Samples showed different behavior and the equilibrium was reached at different times, Mg6Al2 and Zn6Al2 showed lower equilibrium times but had higher adsorption capacity. Various adsorption and isotherm equation models were employed to study both the kinetic and equilibrium results and, in general, the removal of diclofenac was greater than that of salicylic acid. 1-Butanol conversion was also used as a means of acidity and basicity characterization and the results were compared with the adsorption performance of the samples in order to explain the results found. A relationship between the amount of pollutants adsorbed and the butenes formed in the dehydrogenation reaction of 1-butanol was found.
Open Access
Saline slag waste as an aluminum source for the synthesis of Zn–Al–Fe–Ti layered double-hydroxides as catalysts for the photodegradation of emerging contaminants
(Elsevier, 2020) Santamaría Arana, Leticia; Vicente, Miguel Ángel; Korili, Sophia A.; Gil Bravo, Antonio; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Ciencias; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa; Gobierno de Navarra / Nafarroako Gobernua, PI017-PI039 CORRAL
In this work, aluminum extracted from saline slag waste is valorized to create a layered double-hydroxide series containing zinc and various proportions of aluminum/titanium. Materials were synthesized by the co-precipitation method with an Me2+/Me3+ molar ratio of 3:1 and tested for the removal of diclofenac and salicylic acid from water under UV radiation. The incorporation of 5 wt% iron by wet impregnation is evaluated. In addition, another series of zinc, aluminum/iron materials with and without 5 wt% impregnated titanium are tested as catalysts for comparison. Structural characterization and comparison of the two series was performed by powder X-ray diffraction (PXRD), nitrogen adsorption at 77 K, scanning electron microscopy (SEM), X-ray photoelectron spectroscopy (XPS) and temperature-programmed reduction (TPR) measurements. The uncalcinated samples had a typical hydrotalcite structure with a high crystallinity; the presence of ZnO, ZnFe2O4 or Fe3O4 was found after calcination. The specific surface areas of the dried samples ranged from 78 to 199 m2/g, being highest for Zn6Al0.5Ti1.5. Overall, the results showed that the ZnAlTi series were more effective catalysts than ZnAlFe for photodegradation of the emerging contaminants diclofenac and salicylic acid, under UV light at 298 K, considering two concentrations of the organic molecules (5 and 50 μmol/dm3).
Embargo
Effect of the preparation method and metal content on the synthesis of metal modified titanium oxide used for the removal of salicylic acid under UV light
(Taylor & Francis, 2018) Santamaría Arana, Leticia; Vicente, Miguel Ángel; Korili, Sophia A.; Gil Bravo, Antonio; Institute for Advanced Materials and Mathematics - INAMAT2
Titanium dioxide modified with Ag and Fe was synthesized using two preparation methods, characterized and applied to the photocatalytic degradation of salicylic acid in aqueous solution. The modified TiO2 samples were prepared by the sol–gel and wet impregnation methods starting from titanium(IV) isopropoxide and using AgNO3 and Fe(NO3)3·9H2O as precursors of the modifiers, with their content varying between 0 and 5 wt.%. Catalysts characterization was based on powder X-ray diffraction (PXRD), nitrogen physisorption at 77 K, temperature programmed reduction (H2-TPR), chemisorption of NH3 at 343 K and X-ray photoelectron spectroscopy (XPS). The photocatalytic degradation of salicylic acid by modified TiO2 was investigated under ultraviolet irradiation at 298 K considering various concentrations of the catalyst, between 100 and 1000 mgcatalyst/dm3, and of the organic molecule, between 0 and 15 mg/dm3. The catalysts most active in the degradation of salicylic acid were those having the highest Fe content. © 2018, © 2018 Informa UK Limited, trading as Taylor & Francis Group.

Korili, Sophia A.

Email Address

person.page.identifierURI

Birth Date

Job Title

Last Name

First Name

person.page.departamento

person.page.instituteName

ORCID

person.page.observainves

person.page.upna

Name

Filters

Author

Subject

Date

Has files

Item Type

Type

Settings

Sort By

Results per page

Search Results