Open Access
Multifunctional heterogeneous catalysts: Tetrakis (pentafluorophenyl)porphinato]iron(III) immobilized on amine-functionalized Diatomaceous Earth for catalytic and adsorption applications
(Elsevier, 2023) Do Prado, Marcus Vinicius; González, Beatriz; Vicente, Miguel Ángel; Trujillano, Raquel; Nassar, Eduardo José; Gil Bravo, Antonio; Santamaría Arana, Leticia; Korili, Sophia A.; Marçal, Liziane; Faria, Emerson H. de; Ciuffi, Katia J.; Ciencias; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
The use of Diatomaceous Earth (DE) as a promising support of a synthetic metalloporphyrin is reported, trying to heterogenize metalloporphyrin catalysts to mimicking enzyme site isolation and improving reaction selectivity. New multifunctional hybrid materials consisting of DE amino–functionalized with aminopropyltriethoxysilane (DE–APTES), followed by grafting with [meso–tetrakis(pentafluorophenyl)porphinato]iron(III) (DE–APTES–FeTFPP), were prepared and fully characterized. FeTFPP was grafted into DE–APTES via the amine groups (band at 1570 cm–1 ). The brown color of the materials indicated that FeTFPP was immobilized in the matrix; a Soret band characteristic of ironporphyrin located in a confined space, was found at 416 nm. Leaching studies confirmed that the ironporphyrin was entrapped and not just adsorbed on the silica surface. DE was composed of typical quartz and cristobalite crystalline phases and amorphous silica. The intensity of its characteristic reflection at 22◦ (2θ) decreased in the presence of FeTFPP, evidencing that the ironporphyrin influenced the organization of the material. Catalytic tests using DE–APTES–FeTFPP in cyclooctene epoxidation to cyclooctene oxide (56 % yield, with complete selectivity for the epoxide) and cyclohexane oxidation (4 % yield of oxidized products, with ketone/alcohol selectivity ~ 3:1), evidenced the versatility of the catalyst and the multifunctionality of the resulting hybrid materials and the ability of DE as a promising natural support for ironporphyrin catalysts. Finally, the capacity of the materials as CO2 adsorbents was evaluated in the temperature range 100–200 ◦C. DE–APTES showed a maximum adsorption capacity of 1.26 mmol/g at 100 ◦C, 18 times higher than the value found under the same conditions for the non–functionalized support.
Open Access
Synthesis strategies of alumina from aluminum saline slags
(Elsevier, 2023) Grande López, Lucía; Vicente, Miguel Ángel; Korili, Sophia A.; Gil Bravo, Antonio; Ciencias; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
Aluminum saline slags is a waste of the metallurgical industry that presents serious environmental problems since it needs very extensive areas for its disposal, the toxicity it causes in the atmosphere and groundwater, in addition to high transportation costs. The valorization of this residue by the synthesis of alumina, a compound widely used in the chemical industry, generates a high impact and great interest. In this work, the strategies for synthesizing alumina from aluminum saline slags are reviewed in a context of growing demand for this metal and environmental crisis. The first sections present the aluminum production processes, both from natural bauxite (primary process) and from the recycling of materials with a high aluminum content (secondary process); paying attention to the waste generated and what environmental problems they produce. The main investigations that have allowed to address the recovery of the waste generated are described below, focusing on the processes of recovery/extraction of the aluminum present in its composition. The aluminum in these residues can be found as a metal or forming other compounds such as simple or mixed oxides. Chemical processes are the most relevant, especially those that deal with the acid and alkaline extraction of the metal. The most important section of the work reports on the methods of synthesis of Al2O3, highlighting the methods of precipitation, sol-gel, hydrothermal synthesis, and combustion, among others. The work ends with a summary and conclusions section.
Open Access
Optimal carbofuran degradation via CWPO in NOM-doped water by a framework Cu-doped aluminate perovskite catalyst derived from aluminum saline slags
(Elsevier, 2024-09-19) Muñoz Alvear, Helir Joseph; Galeano, Luis Alejandro; Vicente, Miguel Ángel; Korili, Sophia A.; Gil Bravo, Antonio; Institute for Advanced Materials and Mathematics - INAMAT2; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
This study is the first to propose the synthesis of LayAl1–xCuxO3–δ perovskite catalysts using Al recovered from acid leaching of saline slags. The effect of parameters such as the La/Al molar ratio was explored during the synthetic process. A suite of characterization techniques¿including XRF, XRD, N2 adsorption, H2-TPR, FTIR, TGA-DTA, TEM, SEM, EDX, and XPS¿confirmed the successful synthesis of high-purity (up to 90 %) perovskites with La and O vacancies, and a high concentration of Cu(I) active sites dispersed within the perovskite lattice. The best catalyst was used to optimize the degradation of carbofuran (CBF) in water doped with synthetic dissolved natural organic matter (NOM) using the Fenton-like catalytic wet peroxide oxidation (CWPO) approach. The effects of catalyst concentration, H2O2 dose, and pH on catalytic performance were investigated. Degradation, mineralization (COD removal), and H2O2 consumption were maximized, while Cu leaching was minimized using a statistical desirability function for multiple responses. Optimal conditions were found to be a catalyst concentration (mg Cu/mg H2O2) of 0.234 (2.0 g L-1), an H2O2 dose of 73.3 % (0.73 times the stoichiometric dose for full COD mineralization), and a remarkable circumneutral pH of 6.2. Under these conditions, degradation reached 94.1 %, and COD mineralization was 51 % under room temperature. Notably, the perovskite catalyst exhibited remarkable stability during reuse in up to three cycles, as demonstrated by the low Cu leaching (<1.30 mg L-1).
Open Access
Multifunctional nanocomposites based on kaolinite/titania/iron applied to hydrogen peroxide production and bisphenol-A removal
(Elsevier, 2024-11-06) Do Prado, Marcus Vinicius; Lima, Vinicius; Oliveira, Larissa; Nassar, Eduardo José; Marçal, Liziane; Faria, Emerson H. de; Vicente, Miguel Ángel; Trujillano, Raquel; Santamaría Arana, Leticia; Gil Bravo, Antonio; Korili, Sophia A.; Ciuffi, Katia J.; Ciencias; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
The rising global demand for hydrogen peroxide, recognized for its eco-friendly properties, underscores the need for greener synthesis methods. Traditional production processes pose environmental risks, while direct synthesis faces challenges like water formation, explosion hazards, and stability issues, limiting industrial application. On the other hand, Bisphenol A (BPA), an endocrine disruptor widely used in plastics, presents significant environmental and health concerns due to its potential leaching into food and water. The present work introduces efficient and selective photocatalysts aimed at sustainable hydrogen peroxide synthesis and BPA degradation. Both processes were enhanced by the synergistic properties of Fe2O3–TiO2 nanoparticles dispersed within a kaolinite matrix. The Fe2O3-TiO2 photocatalysts, characterized by photoluminescence spectroscopy and X-ray diffraction, showed reduced emission upon iron incorporation and anatase presence on the kaolinite surface. The photocatalytic activity was evaluated through hydroxylation of terephthalic acid, revealing a 127 umol/L min hydroxylation rate for the KaFeTi400 sample. BPA degradation studies indicated optimal performance in acidic conditions, achieving 96 % removal in 2 h and 98 % in 4 h, with the addition of H2O2 enhancing efficiency. Further, the photocatalyst facilitated benzyl alcohol oxidation to benzaldehyde, demonstrating a H2O2 production rate of 120 umol. These findings highlight the multifunctional capabilities and environmental benefits of the photocatalyst, underscoring its potential for sustainable hydrogen peroxide synthesis and broader applications in environmental remediation. The catalysts address the pressing challenges associated with hydrogen peroxide synthesis and pollutant removal, particularly in the context of sustainability and environmental impact.
Open Access
Synthesis of MOF@aluminum saline slag-based composites for CO2 capture at moderate temperatures
(Elsevier, 2025-09-01) Muñoz Alvear, Helir Joseph; Vicente, Miguel Ángel; Korili, Sophia A.; Gil Bravo, Antonio; Ciencias; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa; Gobierno de Navarra / Nafarroako Gobernua
Combining metal–organic framework (MOF) materials and aluminum-containing saline slag residues opens a promising research avenue. This approach reduces the environmental impact of aluminum production by integrating industrial waste in the development of advanced materials that adhere to circular economy principles. It also addresses some inherent stability issues observed in pure MOFs. This study is the first to propose the use of this industrial by-product as a cost-effective and environmentally friendly modulator for controlling the phase transition between MIL-96(Al) and MIL-110(Al). For the first time, novel MOFs composites (MOF@RW1*-n; n = 25, 50, 75% waste) and saline slag waste (RW1*)—a by-product of initial aluminum extraction in an acidic medium—were synthesized in situ by preparing the MOF on RW1* via hydrothermal treatment and subsequently tested as CO2 adsorbents at up to 225 ◦C and 80 kPa. The optimized RW1* content in the composite proved critical in determining the formation of specific crystalline structures (MIL-96(Al) or MIL-110(Al)), ultimately yielding hybrid materials with enhanced textural properties and thermal stability.