Open Access
Synthesis strategies of alumina from aluminum saline slags
(Elsevier, 2023) Grande López, Lucía; Vicente, Miguel Ángel; Korili, Sophia A.; Gil Bravo, Antonio; Ciencias; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
Aluminum saline slags is a waste of the metallurgical industry that presents serious environmental problems since it needs very extensive areas for its disposal, the toxicity it causes in the atmosphere and groundwater, in addition to high transportation costs. The valorization of this residue by the synthesis of alumina, a compound widely used in the chemical industry, generates a high impact and great interest. In this work, the strategies for synthesizing alumina from aluminum saline slags are reviewed in a context of growing demand for this metal and environmental crisis. The first sections present the aluminum production processes, both from natural bauxite (primary process) and from the recycling of materials with a high aluminum content (secondary process); paying attention to the waste generated and what environmental problems they produce. The main investigations that have allowed to address the recovery of the waste generated are described below, focusing on the processes of recovery/extraction of the aluminum present in its composition. The aluminum in these residues can be found as a metal or forming other compounds such as simple or mixed oxides. Chemical processes are the most relevant, especially those that deal with the acid and alkaline extraction of the metal. The most important section of the work reports on the methods of synthesis of Al2O3, highlighting the methods of precipitation, sol-gel, hydrothermal synthesis, and combustion, among others. The work ends with a summary and conclusions section.
Open Access
M(II)-Al-Fe layered double hydroxides synthesized from aluminum saline slag wastes and catalytic performance on cyclooctene oxidation
(Elsevier, 2022) Santamaría Arana, Leticia; Oliveira-Garcia, L.; Faria, Emerson H. de; Ciuffi, Katia J.; Vicente, Miguel Ángel; Korili, Sophia A.; Gil Bravo, Antonio; Institute for Advanced Materials and Mathematics - INAMAT2; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
Aluminum was extracted from saline slags via an alkaline method and employed in the synthesis of Layered Double Hydroxides (LDH) with various M2+ cations (Co, Mg, Ni and Zn), while Al and Fe were the M3+ cations, using the co-precipitation method and a M2+/M3+ 2:1 ratio. The structural characterization of the samples was performed with powder X-ray diffraction (PXRD), scanning electron microscopy (SEM), nitrogen physisorption at 77 K, thermogravimetric analysis (TGA), temperature-programmed reduction (TPR) and X-ray photoelectron spectroscopy (XPS). Their catalytic performance was tested for the oxidation of olefins (cyclooctene) and their biomimetic potential was analyzed. Results show a great selectivity towards epoxides with no other products obtained. Reaction yields followed the descending order Co4AlFe, Zn4AlFe, Ni4AlFe, and Mg4AlFe, the sample with cobalt as M2+ converting up to 85% of cyclooctene.
Open Access
Saline slag waste as an aluminum source for the synthesis of Zn–Al–Fe–Ti layered double-hydroxides as catalysts for the photodegradation of emerging contaminants
(Elsevier, 2020) Santamaría Arana, Leticia; Vicente, Miguel Ángel; Korili, Sophia A.; Gil Bravo, Antonio; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Ciencias; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa; Gobierno de Navarra / Nafarroako Gobernua, PI017-PI039 CORRAL
In this work, aluminum extracted from saline slag waste is valorized to create a layered double-hydroxide series containing zinc and various proportions of aluminum/titanium. Materials were synthesized by the co-precipitation method with an Me2+/Me3+ molar ratio of 3:1 and tested for the removal of diclofenac and salicylic acid from water under UV radiation. The incorporation of 5 wt% iron by wet impregnation is evaluated. In addition, another series of zinc, aluminum/iron materials with and without 5 wt% impregnated titanium are tested as catalysts for comparison. Structural characterization and comparison of the two series was performed by powder X-ray diffraction (PXRD), nitrogen adsorption at 77 K, scanning electron microscopy (SEM), X-ray photoelectron spectroscopy (XPS) and temperature-programmed reduction (TPR) measurements. The uncalcinated samples had a typical hydrotalcite structure with a high crystallinity; the presence of ZnO, ZnFe2O4 or Fe3O4 was found after calcination. The specific surface areas of the dried samples ranged from 78 to 199 m2/g, being highest for Zn6Al0.5Ti1.5. Overall, the results showed that the ZnAlTi series were more effective catalysts than ZnAlFe for photodegradation of the emerging contaminants diclofenac and salicylic acid, under UV light at 298 K, considering two concentrations of the organic molecules (5 and 50 μmol/dm3).

Korili, Sophia A.

Email Address

person.page.identifierURI

Birth Date

Job Title

Last Name

First Name

person.page.departamento

person.page.instituteName

ORCID

person.page.observainves

person.page.upna

Name

Filters

Author

Subject

Date

Has files

Item Type

Type

Settings

Sort By

Results per page

Search Results