Open Access
Progress in the removal of pharmaceutical compounds from aqueous solution using layered double hydroxides as adsorbents: a review
(Elsevier, 2020) Santamaría Aquilué, Rafael; Vicente, Miguel Ángel; Korili, Sophia A.; Gil Bravo, Antonio; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Ciencias; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
Emerging contaminants and, among them, pharmaceutical compounds, have a significant impact on water ecosystems. Layered Double Hydroxides (LDH), being easy to synthesize and cheap materials, have recently gained attention as adsorbents in aqueous solutions. This work describes the latest research performed in the adsorption capacity of LDH towards both antibiotics and Non-Steroidal Anti-Inflammatory Drugs (NSAID) describing and analyzing the synthesis conditions (Me2+:Me3+ molar ratio, calcination temperature, choice of metals for the memory effect), kinetics and isotherm models used, use of support (more practical in a 3D over a 2D form), temperature effect and several techniques for the recovery of the adsorbents. LDH exhibited great performance and potential as clean adsorbents for these emerging contaminants.
Open Access
Optimizing the removal of nitrate by adsorption onto activated carbon using response surface methodology based on the central composite design
(Taylor & Francis, 2020) Taoufik, Nawal; Elmchaouri, Abdellah; Korili, Sophia A.; Gil Bravo, Antonio; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Ciencias
This study sheds light on the adsorption process for the removal of nitrate ions from synthetic aqueous solutions. This contaminant pose a potential risk to the environment and can cause health effects including cancers and methemoglobinemia in infants. When the adsorption process is carried out, the effect by the several operating parameters such as initial nitrate concentration, pH, mass of activated carbon, and contact time becomes apparent. The essential process variables are optimized using response surface methodology (RSM) based on the central composite design (CCD) experiments. For this purpose 31 experimental results are required to determine the optimum conditions. The optimum conditions for the removal of nitrates is found to be: initial nitrate concentration = 15 mg/L; initial pH 4.0; mass of activated carbon = 25 mg, and contact time = 70 min. At these optimized conditions, the maximum removal of nitrates is found to be 96.59%.
Open Access
Progress in the synthesis and applications of hexaaluminate-based catalysts
(Taylor & Francis, 2020) Torrez Herrera, Jonathan Josué; Korili, Sophia A.; Gil Bravo, Antonio; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Ciencias; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
The development of materials that can exhibit thermal resistance at very high temperatures, thus allowing them to be applied as catalysts and thermal insulators, amongst other possible uses, is a research subject of great interest. This is the case for hexaaluminates, a class of hexagonal aluminate compounds with a unique structure that are stable at very high temperatures up to 1600°C and exhibit exceptional resistance to sintering and thermal shock, thus making them attractive catalysts for high-temperature applications. In this review, the structure of hexaaluminates is presented first. The most recent advances in synthetic methods (sol-gel, reverse microemulsion, hydrothermal synthesis, carbon-templating, solution combustion synthesis, and freeze-drying methods) are discussed subsequently, with the aim of maximizing textural properties and including in their structure metals known to be active in catalytic applications, such as combustion of CH4, partial oxidation, and dry reforming of CH4 to produce synthetic gas, and the decomposition of N2O. Finally, other applications, such as their function as a thermal barrier, are also addressed.
Open Access
Effect of the surface properties of Me2+/Al layered double hydroxides synthesized from aluminum saline slag wastes on the adsorption removal of drugs
(Elsevier, 2020) Santamaría Arana, Leticia; Devred, F.; Gaigneaux, E. M.; Korili, Sophia A.; Gil Bravo, Antonio; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Ciencias; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa; Gobierno de Navarra / Nafarroako Gobernua, PI017-PI039 CORRAL
This work presents the synthesis of Me2+ (Co, Mg, Ni and Zn)/Al layered double hydroxides (LDH) with a 3:1 M ratio by the co-precipitation method. Structural characterization and comparison of the series has been achieved using powder X-ray diffraction (PXRD), scanning electron microscopy (SEM), nitrogen physisorption at 77 K, thermogravimetry measurements (TGA), temperature-programmed reduction (TPR), X-ray photoelectron spectroscopy (XPS), ammonia temperature-programmed desorption (NH3-TPD) and point of zero charge (pHpzc). Batch experiments were performed to analyze the adsorption capacity of the different LDH on diclofenac and salicylic acid, as example of emergent pollutants. The pH, mass of adsorbent, contact time and concentration of pollutant were the parameters used to compare the adsorption performance of the synthesized materials. Samples showed different behavior and the equilibrium was reached at different times, Mg6Al2 and Zn6Al2 showed lower equilibrium times but had higher adsorption capacity. Various adsorption and isotherm equation models were employed to study both the kinetic and equilibrium results and, in general, the removal of diclofenac was greater than that of salicylic acid. 1-Butanol conversion was also used as a means of acidity and basicity characterization and the results were compared with the adsorption performance of the samples in order to explain the results found. A relationship between the amount of pollutants adsorbed and the butenes formed in the dehydrogenation reaction of 1-butanol was found.
Open Access
Saline slag waste as an aluminum source for the synthesis of Zn–Al–Fe–Ti layered double-hydroxides as catalysts for the photodegradation of emerging contaminants
(Elsevier, 2020) Santamaría Arana, Leticia; Vicente, Miguel Ángel; Korili, Sophia A.; Gil Bravo, Antonio; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Ciencias; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa; Gobierno de Navarra / Nafarroako Gobernua, PI017-PI039 CORRAL
In this work, aluminum extracted from saline slag waste is valorized to create a layered double-hydroxide series containing zinc and various proportions of aluminum/titanium. Materials were synthesized by the co-precipitation method with an Me2+/Me3+ molar ratio of 3:1 and tested for the removal of diclofenac and salicylic acid from water under UV radiation. The incorporation of 5 wt% iron by wet impregnation is evaluated. In addition, another series of zinc, aluminum/iron materials with and without 5 wt% impregnated titanium are tested as catalysts for comparison. Structural characterization and comparison of the two series was performed by powder X-ray diffraction (PXRD), nitrogen adsorption at 77 K, scanning electron microscopy (SEM), X-ray photoelectron spectroscopy (XPS) and temperature-programmed reduction (TPR) measurements. The uncalcinated samples had a typical hydrotalcite structure with a high crystallinity; the presence of ZnO, ZnFe2O4 or Fe3O4 was found after calcination. The specific surface areas of the dried samples ranged from 78 to 199 m2/g, being highest for Zn6Al0.5Ti1.5. Overall, the results showed that the ZnAlTi series were more effective catalysts than ZnAlFe for photodegradation of the emerging contaminants diclofenac and salicylic acid, under UV light at 298 K, considering two concentrations of the organic molecules (5 and 50 μmol/dm3).
Open Access
Inorganic–organic hybrids based on sepiolite as efficient adsorbents of caffeine and glyphosate pollutants
(Elsevier, 2020) Baldan Junior, Hugo; Silva Grazziano, Eliane da; Saltarelli, Michelle; Crispim, Denise; Nassar, Eduardo José; Trujillano, Raquel; Rives, Vicente; Vicente, Miguel Ángel; Gil Bravo, Antonio; Korili, Sophia A.; Faria, Emerson H. de; Ciuffi, Katia J.; Institute for Advanced Materials and Mathematics - INAMAT2
Sepiolite clay mineral was functionalized with (3-chloropropyl)triethoxysilane (ClPTES) or 3-[tri(ethoxy/methoxy)silyl] propylurea (TEMSPU) alkoxides and tested as adsorbent for herbicide glyphosate and also of caffeine, two pollutants with very different chemical composition. The materials obtained were characterized by X-ray diffractometry, infrared spectroscopy, thermal analysis, scanning electron microscopy and nitrogen adsorption at −196 °C, and submitted to toxicity and desorption tests. Silane functional groups blocked sepiolite active positions, and adsorption occurred within the zeolitic channels and on the surface of the functionalized solids. Caffeine and glyphosate effectively interacted with urea groups from grafted alkoxide, which could lower the mobility of the adsorbed contaminants. Glyphosate adsorbed on functionalized sepiolite derivatives showed low toxicity.
Open Access
Zn-Ti-Al layered double hydroxides synthesized from aluminum saline slag wastes as efficient drug adsorbents
(Elsevier, 2020) Santamaría Arana, Leticia; López Aizpún, María; García Padial, Marcos; Vicente, Miguel Ángel; Korili, Sophia A.; Gil Bravo, Antonio; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Ciencias; Gobierno de Navarra / Nafarroako Gobernua, PI017-PI039 CORRAL; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
This work reports the synthesis of Zinc-Titanium-Aluminum (ZnTiAl) layered double hydroxides (LDH) with various proportions of Al[sbnd]Ti and a Zn/(Al[sbnd]Ti) molar ratio of 3:1 by the co-precipitation method. Two series, made with commercial aluminum (Al) and aluminum extracted from saline slags (Al*), have been considered. Structural characterization and comparison of the two series has been made using powder X-ray diffraction (PXRD), Nitrogen physisorption at 77 K, Scanning electron microscopy (SEM), X-ray photoelectron spectroscopy (XPS) and Thermogravimetry measurements. The adsorption capacity of diclofenac and salicylic acid, as examples of emergent pollutants, by the different LDH on batch and fixed-bed column experiments has been analyzed. The effect of various parameters, such as the pH, the initial concentration of pollutant, the mass of adsorbent and the contact time, on the sorption behavior were studied and compared. The contact time to attain equilibrium for maximum adsorption was found to be between 100 and 400 min. The kinetic and equilibrium results were correlated to several adsorption and isotherm equation models. The synthesized materials were more effective in removing diclofenac than salicylic acid, being Zn6Al*2 the hydrotalcite that showed the highest adsorption capacity. The results showed a new application of a material obtained from the valorization of an industrial waste such as aluminum saline slags.
Open Access
Zeolite synthesis from aluminum saline slag waste
(Elsevier, 2020) Yoldi Sangüesa, María; Fuentes Ordóñez, Edwin Gustavo; Korili, Sophia A.; Gil Bravo, Antonio; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Ciencias; Gobierno de Navarra / Nafarroako Gobernua
This work describes the synthetic procedures developed to obtain zeolite X (NaX), zeolite A (LTA) and sodalite (SOD) using aluminum saline slag waste (AlSSW) as aluminum source in a two-step hydrothermal method involving alkaline extraction of Al, with separation of the residual waste, and hydrothermal treatment at low temperatures and long reaction times. Use of the mother liquor obtained after filtration and separation of the zeolite is also analyzed in the alkaline extraction of Al. The synthetic parameters that determine the type of zeolite, purity, crystallinity, specific surface area, pore size and pore volume include the Si/Al molar ratio, pH, nucleation temperature and time, and crystallization temperature and time. These critical parameters were studied and determined to synthesize NaX, LTA and SOD as individual phases. The materials obtained were characterized by X-ray diffraction, scanning electron microscopy and N2 adsorption/desorption measurements at −196 °C. The characteristics of the best zeolites obtained are similar to those of IZA references and the specific surface areas are in the range of commercial ones: NaX ranges from 450 to 500 m2/g and LTA from 250 to 300 m2/g. The results show that it is possible to synthesize zeolites from AlSSW, thus allowing these materials to be applied as promising adsorbents and catalysts.