Open Access
Technical and environmental characterization of hydraulic and alkaline binders
(Elsevier, 2018) Espuelas Zuazu, Sandra; Echeverria Lazcano, Angel María; Marcelino Sádaba, Sara; Prieto Cobo, Eduardo; Seco Meneses, Andrés; Proyectos e Ingeniería Rural; Landa Ingeniaritza eta Proiektuak; Gobierno de Navarra / Nafarroako Gobernua, 0011-1365-2017-000176
Portland cement is a widely used binder in construction and building applications because of its good properties. Despite its convenience as construction material, the social demands and policies trends are requesting a lower impact and more sustainable cement manufacturing industry. The most effective ways to reach this goal are the substitution of clinker by different wastes or by-products in the cement composition or the development of more sustainable binders like the alkali activated binders. This work analyzes from a technical and environmental point of view the substitution of a clinker based CEM I common cement for the construction mortars manufacturing. Four common cements with different ground granulated blastfurnace slags (GGBS) or fly ashes (FA) contents as well as fifteen alkali activated binders (AAB) combinations were considered. Fresh consistency, density, compressive strength (CS) tests and life cycle analysis were carried out to state the ability of these different hydraulic and alkaline activated binders for the CEM I substitution. The results obtained demonstrated the technical and environmental convenience of these binders for the construction mortars manufacturing.
Open Access
Sustainable unﬁred bricks manufacturing from construction and demolition wastes
(Elsevier, 2018) Seco Meneses, Andrés; Omer, Joshua; Marcelino Sádaba, Sara; Espuelas Zuazu, Sandra; Prieto Cobo, Eduardo; Proyectos e Ingeniería Rural; Landa Ingeniaritza eta Proiektuak
The management of construction and demolition wastes is a huge challenge for most Governments. Thegreatest component of such wastes is concrete and masonry fragments or remains. Among the most com-mon approaches to valorization of such w astes is to convert them to recycled aggregates, however thismay be hampered by low quality of some recycled aggregates compared to natural aggregates. This paperpresents the results of experimental investigation where concrete and ceramic remains were used to par-tially substitute clay soil in producing unﬁred bricks. The bricks were then tested for mechanical strength,water absorption freeze-thaw resistance. Additionally the environmental impact of the bricks wasassessed based on Life Cycle Analysis (LCA). It was established that concrete waste could be used to sub-stitute up to 50% of the clay whereas ceramic wastes could only substitute a maximum of 30% of the clay.Blended bricks made from clay and concrete waste mixes had a lower mechanical strength than thosemade from clay and ceramic waste. As regards water absorption, there was no marked differencebetween the two blends of brick however reduction in water resistance was slightly greater in bricks con-taining concrete waste that in those containing ceramic wastes. Also, tests showed that freeze-thawresistance was greater in bricks blended with concrete wastes than in those incorporating ceramicwastes. Life Cycle analyses demonstrated that it is the binder content in the mix that largely determinesthe environmental impact of the blended bricks. Lastly, it was demonstrated that the most desirable tech-nical and environmental credentials of brick material mixes resulted from using the binder combination:CL-90-S+GGBS 2/8.
Open Access
Sulfate soils stabilization with magnesium-based binders
(Elsevier, 2016) Seco Meneses, Andrés; Miqueléiz Jiménez, Luis; Prieto Cobo, Eduardo; Marcelino Sádaba, Sara; García, Beñat; Urmeneta, Pablo; Proyectos e Ingeniería Rural; Landa Ingeniaritza eta Proiektuak; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
Sulfate soils' stabilization is a very interesting subject with technical, economic and environmental implications. The difficulty of their stabilization is due to the fact that the usual stabilizer additives are based on calcium. In these soils, sulfate combines with the calcium from the additive and the aluminum from the clay, resulting in a highly hydrated expansive mineral named ettringite. This provokes the swelling of the treated material and even its destruction. This study analyzes the result of the substitution of the calciumbased additives by one alternative additive based on magnesium, an industrial byproduct named PC-8, in the stabilization of five different sulfate soils. From a mechanical point of view soils treated with PC-8 reached similar resistance values to the lime treated ones, of about 2–3 MPa for 4% dosage and 2–5 MPa for 8% dosage, being usually better with the PC-8 results than with the lime ones. When PC-8 was combined with GGBS the resistance values increased up to 11–13 MPa and the lime-GGBS reached the 6–7 MPa. The natural swelling of the soils treated with PC-8 decreased substantially and maintained constant even for immersion at long-term. In the case of the soils treated with lime, long-termswelling increased up to very high values even in the case of soilswithout natural swelling. XRD analysis of these samples demonstrated the existence of ettringite in 4 of the 5 soilswhen theywere treated with lime and there was not expansive minerals in the PC-8 treated soils, agreeing with the swelling observed behavior of the soils when treated with both additives.

Marcelino Sádaba, Sara

Email Address

person.page.identifierURI

Birth Date

Job Title

Last Name

First Name

person.page.departamento

person.page.instituteName

ORCID

person.page.observainves

person.page.upna

Name

Filters

Author

Subject

Date

Has files

Item Type

Type

Settings

Sort By

Results per page

Search Results