Open Access
Highly selective CO formation via CO2 hydrogenation over novel ceria-based high-entropy oxides (HEOs)
(Elsevier, 2025-03-01) Cortázar, María; Lafuente Adiego, Marta; Navarro Puyuelo, Andrea; García, Xènia; Llorca Piqué, Jordi; Reyero Zaragoza, Inés; Bimbela Serrano, Fernando; Gandía Pascual, Luis; Ciencias; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
In the present study, new ceria-based high-entropy oxides (HEOs) were investigated as CO2 hydrogenation catalysts. The nominal composition was (Ce0.5Ni0.1Co0.1Cu0.1Zn0.1Mg0.1)Ox and the synthesis was accomplished through the citrate complexing sol-gel method. Characterization techniques utilized including ICP-AES, in situ XRD and in situ XPS, SEM-EDS, HR-TEM and HAADF-STEM, Raman spectroscopy, H2-TPR, CO2-TPD and N2 physical adsorption. The physicochemical characterization and the catalytic results revealed that the conditions of the thermal treatments at which the oxides were subjected critically determined the catalytic performance, especially the CO2 hydrogenation products selectivities. Calcination in air and/or reduction in hydrogen conducted at temperatures below 500 °C led to active but poorly selective catalysts that produced both methane and CO with significant yields. This was mainly attributed to the presence of metallic Cu, Ni and Co on the catalysts that appeared to be supported on ceria doped with the rest of the formulation elements. In contrast, thermal treatments at 750 °C favored the formation of a rocksalt entropy-stabilized (NiCoCuZnMg)Ox HEO supported on ceria that has stood out for showing an excellent selectivity towards the reverse water¿gas shift (RWGS) reaction. This catalyst led to CO selectivities of almost 100 % over a very wide range of reaction temperatures (300-700 °C). Long-term stability tests (100 h) showed only a slight decrease in CO2 conversion, while CO selectivity remained stable at nearly 100 % at 400 °C. XRD characterization of the used catalysts evidenced that, whereas the basic catalyst structure remained, some metallic copper exsolved during reduction and reaction period. These results are relevant and very promising, opening a door to the development of new catalysts for the valorization of CO2 through the RWGS reaction, thus expanding the low-temperature limit at which this process can be carried out selectively.
Embargo
How bimetallic CoMo carbides and nitrides improve CO oxidation
(Elsevier, 2023) Villasana, Yanet; García Macedo, Jorge A.; Navarro Puyuelo, Andrea; Reyero Zaragoza, Inés; Lara, Hugo; Bimbela Serrano, Fernando; Gandía Pascual, Luis; Brito, Joaquin L.; Méndez, Franklin J.; Institute for Advanced Materials and Mathematics - INAMAT2
CO elimination is an important step for the proper management of gaseous effluents from various processes, thus avoiding adverse impacts on the environment and human health. In this study, different bimetallic Al2O3-supported CoMo catalysts have been developed, characterized, and tested in the CO oxidation reaction, based on their respective oxides, carbides, and nitrides phases. The parent CoMo-oxide catalyst (CoMo) was prepared by impregnation and then transformed to its carburized (CoMoC) and nitrided (CoMoN) forms using temperatureprogrammed reaction methods under controlled atmospheres of CH4/H2 and NH3, respectively. The catalytic results demonstrate that the CoMoC catalyst exhibits higher activity compared to its CoMoN counterpart, and both are more active than the parent CoMo catalyst. Furthermore, the reduction temperature and space velocity were key process factors, which notably influenced activity and kinetic parameters, while the increase of reduction time does not seem to improve catalytic behavior. These results were associated with a better metal dispersion, and relatively higher reduction grade and metallic surface area on the carbides and nitrides, opening the possibility that new adsorption sites may be created. The catalytic results compare favorably with other nonnoble metal catalysts, such as Cr-, Cu-, Fe-, and Ni-based samples, and highlight the potential of using carbides and nitrides as alternative formulations to enhance the performance of CO oxidation.
Open Access
Remarkable performance of supported Rh catalysts in the dry and combined reforming of biogas at high space velocities
(Elsevier, 2024) Navarro Puyuelo, Andrea; Atienza Martínez, María; Reyero Zaragoza, Inés; Bimbela Serrano, Fernando; Gandía Pascual, Luis; Ciencias; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
Dry and combined (with O2) reforming of synthetic biogas were studied at 700 °C using 0.5 % Rh catalysts prepared by impregnation on different supports: γ-Al2O3, SiO2, TiO2, ZrO2 and CeO2. Gas hourly space velocity (GHSV) was varied between 150 and 700 N L CH4/(gcat·h), and two O2/CH4 molar ratios of 0 and 0.12 were studied. Rh/Al2O3 catalysts (prepared using two different commercial supports here denoted as Sph and AA) presented the highest biogas conversion and syngas yields under both dry and combined reforming conditions. Catalytic activities were as follows: Rh/AA ≈ Rh/Sph > Rh/SiO2 > Rh/ZrO2 ≈ Rh/CeO2 > Rh/TiO2. The effect of catalysts’ calcination pre-treatment at relatively low (200 °C) and high temperatures (750 °C) was also studied. Calcination at high temperatures had a detrimental effect on both dry and combined reforming activities. However, a positive effect on the reforming activities and syngas yields was observed when the catalysts were calcined at 200 °C, especially under biogas combined reforming conditions: higher CH4 conversions and syngas yields could be achieved, as well as increasing CO2 conversions, though at the expense of lower H2/CO molar ratios.
Open Access
CO2 methanation over nickel catalysts: support effects investigated through specific activity and operando IR spectroscopy measurement
(MDPI, 2023) González Rangulan, Vigni Virginia; Reyero Zaragoza, Inés; Bimbela Serrano, Fernando; Romero Sarria, Francisca; Daturi, Marco:; Gandía Pascual, Luis; Ciencias; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
Renewed interest in CO2 methanation is due to its role within the framework of the Power-to-Methane processes. While the use of nickel-based catalysts for CO2 methanation is well stablished, the support is being subjected to thorough research due to its complex effects. The objective of this work was the study of the influence of the support with a series of catalysts supported on alumina, ceria, ceria–zirconia, and titania. Catalysts’ performance has been kinetically and spectroscopically evaluated over a wide range of temperatures (150–500 °C). The main results have shown remarkable differences among the catalysts as concerns Ni dispersion, metallic precursor reducibility, basic properties, and catalytic activity. Operando infrared spectroscopy measurements have evidenced the presence of almost the same type of adsorbed species during the course of the reaction, but with different relative intensities. The results indicate that using as support of Ni a reducible metal oxide that is capable of developing the basicity associated with medium-strength basic sites and a suitable balance between metallic sites and centers linked to the support leads to high CO2 methanation activity. In addition, the results obtained by operando FTIR spectroscopy suggest that CO2 methanation follows the formate pathway over the catalysts under consideration.
Open Access
Acid-catalyzed etherification of glycerol with tert-butanol: reaction monitoring through a complete identification of the produced alkyl ethers
(MDPI, 2023) Cornejo Ibergallartu, Alfonso; Reyero Zaragoza, Inés; Campo Aranguren, Idoia; Arzamendi Manterola, Gurutze; Gandía Pascual, Luis; Ciencias; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2
Higher tert-Butyl glycerol ethers (tBGEs) are interesting glycerol derivatives that can be produced from tert-butyl alcohol (TBA) and glycerol using an acid catalyst. Glycerol tert-butylation is a complex reaction that leads to the formation of five tBGEs (two monoethers, two diethers, and one triether). In order to gain insight into the reaction progress, the present work reports on the monitoring of glycerol etherification with TBA and p-toluensulfonic acid (PTSA) as homogeneous catalysts. Two analytical techniques were used: gas chromatography (GC), which constitutes the benchmark method, and( 1)H nuclear magnetic resonance (H-1 NMR), whose use for this purpose has not been reported to date. A method for the quantitative analysis of tBGEs and glycerol based on H-1 NMR is presented that greatly reduced the analysis time and relative error compared with GC-based methods. The combined use of both techniques allowed for a complete quantitative and qualitative description of the glycerol tert-butylation progress. The set of experimental results collected showed the influence of the catalyst concentration and TBA/glycerol ratio on the etherification reaction and evidenced the intrinsic difficulties of this process to achieve high selectivities and yields to the triether.
Open Access
Comparative study of supported Ni and Co catalysts prepared using the All-in-One method in the hydrogenation of CO2: effects of using (Poly)Vinyl Alcohol (PVA) as an additive
(MDPI, 2024) Navarrete Rodríguez, Luisa Fernanda; Atienza Martínez, María; Reyero Zaragoza, Inés; Urroz Unzueta, José Carlos; Amorrortu, Oihana; Sanz Iturralde, Oihane; Montes, Mario; Garcés, Siby I.; Bimbela Serrano, Fernando; Gandía Pascual, Luis; Institute for Advanced Materials and Mathematics - INAMAT2; Ingeniería; Ingeniaritza
Two series of Ni and Co catalysts supported onto La-Al2O3 were prepared and the CO2 hydrogenation reactions investigated. The catalytic performance was evaluated in terms of the evolution with the reaction temperature of the CO2 conversion and product (CH4 and CO) yields, as well as specific activities (TOF) and apparent activation energies. CH4 was the favored product over both metals while the TOF for CH4 formation was about three times higher for Ni than Co at 240–265 °C. Metallic particle size effects were found, with the TOF for CH4 formation decreasing over both Ni and Co as the mean metallic size decreased. In contrast, the TOF for CO formation tended to increase at a decreasing particle size for the catalysts with the smallest Ni particle sizes. The apparent activation energies for Ni and Co were very similar and significantly decreased to values of 73–79 kJ/mol when the metallic dispersion increased. The catalysts were prepared using the all-in-one method, resulting in (poly)vinyl alcohol (PVA) being a key additive that allowed us to enhance the dispersion of Ni and Co to give very effective catalysts. This comparative study joins the few existing ones in the literature in which catalysts based on these metals operated under strictly the same reaction conditions.