Person:
López Martín, Antonio

Last Name

López Martín

First Name

Antonio

person.page.departamento

Ingeniería Eléctrica, Electrónica y de Comunicación

person.page.instituteName

ISC. Institute of Smart Cities

ORCID

0000-0001-7629-0305

person.page.upna

2254

Full item page

Search Results

Now showing 1 - 10 of 22

Open Access
Energy-efficient amplifiers based on quasi-floating gate techniques
(MDPI, 2021) López Martín, Antonio; Garde Luque, María Pilar; Algueta-Miguel, Jose M.; Beloso Legarra, Javier; González Carvajal, Ramón; Ramírez-Angulo, Jaime; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación
Energy efficiency is a key requirement in the design of amplifiers for modern wireless applications. The use of quasi-floating gate (QFG) transistors is a very convenient approach to achieve such energy efficiency. We illustrate different QFG circuit design techniques aimed to implement low-voltage energy-efficient class AB amplifiers. A new super class AB QFG amplifier is presented as a design example including some of the techniques described. The amplifier has been fabricated in a 130 nm CMOS test chip prototype. Measurement results confirm that low-voltage ultra low power amplifiers can be designed preserving at the same time excellent small-signal and large-signal performance.
Open Access
Super class AB RFC OTA using non-linear current mirrors
(Institution of Engineering and Technology, 2018) Garde Luque, María Pilar; López Martín, Antonio; Carvajal, Ramón G.; Galán, J.A.; Ramírez-Angulo, Jaime; Institute of Smart Cities - ISC
An alternative approach to the design of super class AB recycling folded cascode operational transconductance amplifiers is proposed. Instead of using local common-mode feedback for boosting dynamic currents, simple current mirrors with input transistors entering triode region for large currents are employed. Measurement results from a 0.5 μm CMOS test chip validate the proposal.
Open Access
±0.3v bulk-driven fully differential buffer with high figures of merit
(MDPI, 2022) Gangineni, Manaswini; Ramírez-Angulo, Jaime; Vázquez-Leal, Héctor; Huerta-Chua, Jesús; López Martín, Antonio; González Carvajal, Ramón; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación
A high performance bulk-driven rail-to-rail fully differential buffer operating from ±0.3V supplies in 180 nm CMOS technology is reported. It has a differential–difference input stage and common mode feedback circuits implemented with no-tail, high CMRR bulk-driven pseudo-differential cells. It operates in subthreshold, has infinite input impedance, low output impedance (1.4 kΩ), 86.77 dB DC open-loop gain, 172.91 kHz bandwidth and 0.684 µWstatic power dissipation with a 50-pF load capacitance. The buffer has power efficient class AB operation, a small signal figure of merit FOMss = 12.69 MHzpFµW-1, a large signal figure of merit FOMls = 34.89 (V/µs) pFµW-1, CMRR = 102 dB, PSRR+ = 109 dB, PSRR- = 100 dB, 1.1 µV/√Hz input noise spectral density, 0.3 mVrms input noise and 3.5 mV input DC offset voltage.
Open Access
±0.25 V Class-AB CMOS capacitance multiplier and precision rectifiers
(IEEE, 2019) Pourashraf, Shirin; Ramírez-Angulo, Jaime; Hinojo Montero, José María; González Carvajal, Ramón; López Martín, Antonio; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
Reduction of minimum supply requirements is a crucial aspect to decrease the power consumption in VLSI systems. A high performance capacitance multiplier able to operate with supplies as low as ±0.25 V is presented. It is based on adaptively biased class-AB current mirrors which provide high current efficiency. Measurement results of a factor 11 capacitance multiplier fabricated in 180 nm CMOS technology verify theoretical claims. Moreover, low-voltage precision rectifiers based on the same class-AB current mirrors are designed and fabricated in the same CMOS process. They generate output currents over 100 times larger than the quiescent current. Both proposed circuits have 300 nW static power dissipation when operating with ±0.25 V supplies.
Open Access
Enhanced single-stage folded cascode OTA suitable for large capacitive loads
(IEEE, 2018) López Martín, Antonio; Garde Luque, María Pilar; Algueta-Miguel, Jose M.; Cruz Blas, Carlos Aristóteles de la; Carvajal, Ramón G.; Ramírez-Angulo, Jaime; Institute of Smart Cities - ISC
An enhanced single-stage folded cascode operational transconductance amplifier able to drive large capacitive loads is presented. Circuits that adaptively bias the input differential pair and the current folding stage are employed, which provide class AB operation with dynamic current boosting and increased gainbandwidth (GBW) product. Measurement results of a test chip prototype fabricated in a 0.5-µm CMOS process show an increase in slew rate and GBW by a factor of 30 and 15, respectively, versus the class A version using the same supply voltage and bias currents. Overhead in other performance metrics is small.
Open Access
Gain-boosted super class AB OTAs based on nested local feedback
(IEEE, 2021) Beloso Legarra, Javier; Cruz Blas, Carlos Aristóteles de la; López Martín, Antonio; Ramírez-Angulo, Jaime; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica y Electrónica
A new approach to design super class AB operational transcon-ductance amplifiers (OTAs) with enhanced large-signal and small-signal performance is presented. It is based on employing two nested positive and negative feedback loops at the active load of an adaptively biased differential pair in weak inversion region. As a result, DC gain, gain-bandwidth product, settling time and noise are improved compared to conventional super class AB OTAs without extra circuit nodes or power consumption. Measurement results of a 180 nm CMOS test chip prototype show a current boosting factor higher than 5000 and a nearly ideal current efficiency. Due to the ultra-low quiescent currents and high driving capability, the circuit exhibits an excellent large-signal figure-of-merit (FOML) of 236 V-1. To illustrate the applicability of the proposed approach, a differential sample-and-hold (S/H) circuit was designed and fabricated on the same test chip. Measurement results of the S/H validate the advantages of the proposal.
Open Access
CMOS first-order all-pass filter with 2-Hz pole frequency
(IEEE, 2019) Paul, Anindita; Ramírez-Angulo, Jaime; López Martín, Antonio; González Carvajal, Ramón; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
A CMOS fully integrated all-pass filter with an extremely low pole frequency of 2 Hz is introduced in this paper. It has 0.08-dB passband ripple and 0.029-mm2 Si area. It has 0.38-mW power consumption in strong inversion with ±0.6-V power supplies. In subthreshold, it has 0.64-uW quiescent power and operates with ±200-mV dc supplies. Miller multiplication is used to obtain a large equivalent capacitor without excessive Si area. By varying the gain of the Miller amplifier, the pole frequency can be varied from 2 to 48 Hz. Experimental and simulation results of a test chip prototype in 130-nm CMOS technology validate the proposed circuit.
Open Access
Pseudo-three-stage Miller op-amp with enhanced small-signal and large-signal performance
(IEEE, 2019) Paul, Anindita; Ramírez-Angulo, Jaime; López Martín, Antonio; González Carvajal, Ramón; Rocha-Pérez, José Miguel; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación
A simple technique to implement highly power efficient class AB-AB Miller op-amps is presented in this paper. It uses a composite input stage with resistive local common mode feedback that provides class AB operation to the input stage and essentially enhances the op-amp's effective transconductance gain, the dc open-loop gain, the gain-bandwidth product, and slew rate with just moderate increase in power dissipation. The experimental results of op-amps in strong inversion and subthreshold fabricated in a 130-nm standard CMOS technology validate the proposed approach. The op-amp has 9 V·pF/μs·μW large-signal figure of merit (FOM) and 17 MHz · pF/μW small-signal FOM with 1.2-V supply voltage. In subthreshold, the op-amp has 10 V · pF/μs · μW large-signal FOM and 92 MHz · pF/μW small-signal FOM with 0.5-V supply voltage.
Open Access
On the optimal current followers for wide-swing current-efficient amplifiers
(IEEE, 2018) López Martín, Antonio; Garde Luque, María Pilar; Carvajal, Ramón G.; Ramírez-Angulo, Jaime; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
The design of various current followers for the implementation of OTAs with high slew rate and current efficiency is addressed. Two basic current follower topologies are compared, and modifications of both followers to improve these parameters are presented. As an application example, an enhanced recycling folded cascode OTA is proposed. Measurement results of the OTA fabricated in a 0.5 μm CMOS process show a 260% and 180% improvement in SR and GBW, respectively, for the same power consumption.
Open Access
Low-voltage 0.81mW, 1-32 CMOS VGA with 5% bandwidth variations and -38dB DC rejection
(IEEE, 2020) López Martín, Antonio; Rico-Aniles, Héctor Daniel; Ramírez-Angulo, Jaime; Rocha-Pérez, José Miguel; González Carvajal, Ramón; Institute of Smart Cities - ISC
A CMOS low-voltage amplifier with approximately constant bandwidth and DC rejection is introduced. The design is based on the cascade of a wide linear input range OTA, an op-amp and a servo-loop with extremely large time constants. It operates with +/-0:45V supplies and a power consumption of 0.81mW in 180nm technology. The bandwidth changes only from 9.08MHz to 9.54MHz over a gain range from 1 to 32, it has a 9.8Hz low cutoff frequency and a DC attenuation of 38dBs. DC floating voltage sources are used to keep the gates of all differential pairs at a constant value close to a supply rail in order to operate the amplifier circuit with minimum supply voltage. The proposed circuit has small and large signal figures of merit FOMSS=5380 (MHz*pF/mW) and FOMLS=0:0085((V/ns)*pF/mA) for a nominal gain A=32.