Person: López Martín, Antonio
Loading...
Email Address
person.page.identifierURI
Birth Date
Research Projects
Organizational Units
Job Title
Last Name
López Martín
First Name
Antonio
person.page.departamento
Ingeniería Eléctrica, Electrónica y de Comunicación
person.page.instituteName
ISC. Institute of Smart Cities
ORCID
0000-0001-7629-0305
person.page.upna
2254
Name
5 results
Search Results
Now showing 1 - 5 of 5
Publication Open Access Wide-swing class AB regulated cascode current mirror(IEEE, 2020) Garde Luque, María Pilar; López Martín, Antonio; Cruz Blas, Carlos Aristóteles de la; Carvajal, Ramón G.; Ramírez-Angulo, Jaime; Institute of Smart Cities - ISCA micropower regulated cascode CMOS current mirror is presented, combining floating gate and quasi floating gate MOS transistors to achieve both wide swing and class AB operation, respectively. Measurement results for a 0.5 μm CMOS test chip prototype are included, showing that the current mirror can provide a THD at 100 kHz of -44 dB for a supply voltage of ±0.75 V and input current amplitudes 20 times larger than the bias current.Publication Open Access A family of alternating current amplifiers for ultra-low frequency operation(Wiley, 2021) Martincorena Arraiza, Maite; Carlosena García, Alfonso; Cruz Blas, Carlos Aristóteles de la; Beloso Legarra, Javier; López Martín, Antonio; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación; Universidad Pública de Navarra / Nafarroako Unibertsitate PublikoaA family of capacitively coupled alternating current (AC) amplifiers featuring ultra-low (below 1 Hz) corner frequency is presented. This is achieved by using high-gain devices which actively boost feedback resistance and thus reduce corner frequency. This procedure is often termed, though with a different purpose, as 'bootstrapping'. The proposed architectures are very general and admit several possible practical implementations. To demonstrate their usefulness, the circuits are implemented with two operational amplifiers (OA), but other active devices such as operational transconductance amplifiers (OTAs) can be alternatively used. All circuits have been theoretically analyzed, extensively simulated and measured, exhibiting high-pass cutoff frequencies as low as 30 mHz.Publication Open Access Gain-boosted super class AB OTAs based on nested local feedback(IEEE, 2021) Beloso Legarra, Javier; Cruz Blas, Carlos Aristóteles de la; López Martín, Antonio; Ramírez-Angulo, Jaime; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica y ElectrónicaA new approach to design super class AB operational transcon-ductance amplifiers (OTAs) with enhanced large-signal and small-signal performance is presented. It is based on employing two nested positive and negative feedback loops at the active load of an adaptively biased differential pair in weak inversion region. As a result, DC gain, gain-bandwidth product, settling time and noise are improved compared to conventional super class AB OTAs without extra circuit nodes or power consumption. Measurement results of a 180 nm CMOS test chip prototype show a current boosting factor higher than 5000 and a nearly ideal current efficiency. Due to the ultra-low quiescent currents and high driving capability, the circuit exhibits an excellent large-signal figure-of-merit (FOML) of 236 V-1. To illustrate the applicability of the proposed approach, a differential sample-and-hold (S/H) circuit was designed and fabricated on the same test chip. Measurement results of the S/H validate the advantages of the proposal.Publication Open Access A 1.2-V current-mode RMS-to-DC converter based on a novel two-quadrant electronically simulated MOS translinear loop(IEEE, 2020) Martincorena Arraiza, Maite; Cruz Blas, Carlos Aristóteles de la; Algueta-Miguel, Jose M.; López Martín, Antonio; Institute of Smart Cities - ISCA novel current-mode CMOS RMS-to-DC converter using translinear techniques is introduced. It is based on a squarer/divider cell that is implemented using an electronically simulated loop with a novel biasing scheme that allows its operation in two quadrants. The cell is designed using a differential input current and a small signal first order filter to implement the voltage averaging, leading to a compact solution that can be used with low voltage supplies. The converter has been fabricated in a standard 130-nm CMOS process, and measurement results are provided to demonstrate the feasibility of the system.Publication Open Access AC amplifiers with ultra-low corner frequency by using bootstrapping(Institution of Engineering and Technology, 2021) Martincorena Arraiza, Maite; Carlosena García, Alfonso; Cruz Blas, Carlos Aristóteles de la; López Martín, Antonio; Ingeniería Eléctrica y Electrónica; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio IngeniaritzarenA novel architecture for an AC (i.e. high-pass) amplifier is proposed allowing a drastic reduction of the cutoff frequency to the sub-Hertz range. It builds upon the classic AC configuration with a high gain amplifier and a parallel RC circuit in the feedback loop, by increasing the feedback resistance through bootstrapping. Resistance multiplying factors higher than four orders of magnitude are easily achievable. The basic principle can be applied to several practical implementations, though in this letter it is demonstrate with measurement results of an op-amp based discrete implementation.