Person: Espuelas Zuazu, Sandra
Loading...
Email Address
person.page.identifierURI
Birth Date
Research Projects
Organizational Units
Job Title
Last Name
Espuelas Zuazu
First Name
Sandra
person.page.departamento
Ingeniería
person.page.instituteName
ORCID
0000-0003-1223-515X
person.page.upna
811351
Name
2 results
Search Results
Now showing 1 - 2 of 2
Publication Open Access Sustainable unfired bricks manufacturing from construction and demolition wastes(Elsevier, 2018) Seco Meneses, Andrés; Omer, Joshua; Marcelino Sádaba, Sara; Espuelas Zuazu, Sandra; Prieto Cobo, Eduardo; Proyectos e Ingeniería Rural; Landa Ingeniaritza eta ProiektuakThe management of construction and demolition wastes is a huge challenge for most Governments. Thegreatest component of such wastes is concrete and masonry fragments or remains. Among the most com-mon approaches to valorization of such w astes is to convert them to recycled aggregates, however thismay be hampered by low quality of some recycled aggregates compared to natural aggregates. This paperpresents the results of experimental investigation where concrete and ceramic remains were used to par-tially substitute clay soil in producing unfired bricks. The bricks were then tested for mechanical strength,water absorption freeze-thaw resistance. Additionally the environmental impact of the bricks wasassessed based on Life Cycle Analysis (LCA). It was established that concrete waste could be used to sub-stitute up to 50% of the clay whereas ceramic wastes could only substitute a maximum of 30% of the clay.Blended bricks made from clay and concrete waste mixes had a lower mechanical strength than thosemade from clay and ceramic waste. As regards water absorption, there was no marked differencebetween the two blends of brick however reduction in water resistance was slightly greater in bricks con-taining concrete waste that in those containing ceramic wastes. Also, tests showed that freeze-thawresistance was greater in bricks blended with concrete wastes than in those incorporating ceramicwastes. Life Cycle analyses demonstrated that it is the binder content in the mix that largely determinesthe environmental impact of the blended bricks. Lastly, it was demonstrated that the most desirable tech-nical and environmental credentials of brick material mixes resulted from using the binder combination:CL-90-S+GGBS 2/8.Publication Open Access Magnesium oxide as alternative binder for unfired clay bricks manufacturing(Elsevier, 2017) Espuelas Zuazu, Sandra; Omer, Joshua; Marcelino Sádaba, Sara; Echeverria Lazcano, Angel María; Seco Meneses, Andrés; Proyectos e Ingeniería Rural; Landa Ingeniaritza eta Proiektuak; Universidad Pública de Navarra / Nafarroako Unibertsitate PublikoaReplacement of fired bricks by unfired ones could be an effective way to reduce the building industryenvironmental footprint: Their manufacture not only requires less energy and natural resources but alsogenerates less waste. Bricks are based on the use of an additive cementitious material in the form of a binder,usually lime or cement. Such additives have a great environmental impact owing to the high energy consumptionand CO2during in their manufacturing process. In this article experiments are carried out in order to investigatethe applicability of a MgO rich industry by-product as a binder for the production of unfired clay bricks. Fromthe experiments, the MgO was observed to show ability to enhance the mechanical properties of a clay brick inmuch the same way as lime does. Water absorption tests on bricks revealed the superiority of MgO over lime inenhancing the durability properties of unfired bricks. The laboratory results demonstrate the high potential ofMgO based additives as alternative binders to the calcium based ones. Consequently, this offers opportunity forreducing the environmental impact associated with the use of fired clay bricks. In addition, it could allow aneffective way for the valorization of MgO containing industry by-products that currently discarded to landfills