Open Access
Microdrilled tapers to enhance optical fiber lasers for sensing
(Nature Research, 2021) Pérez Herrera, Rosa Ana; Bravo Acha, Mikel; Roldán Varona, Pablo; Leandro González, Daniel; Rodríguez Cobo, Luis; López Higuera, José Miguel; López-Amo Sáinz, Manuel; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
In this work, an experimental analysis of the performance of different types of quasi-randomly distributed reflectors inscribed into a single-mode fiber as a sensing mirror is presented. These artificially-controlled backscattering fiber reflectors are used in short linear cavity fiber lasers. In particular, laser emission and sensor application features are analyzed when employing optical tapered fibers, micro-drilled optical fibers and 50 μm-waist or 100 μm-waist micro-drilled tapered fibers (MDTF). Single-wavelength laser with an output power level of about 8.2 dBm and an optical signal-to-noise ratio of 45 dB were measured when employing a 50 μm-waist micro-drilled tapered optical fiber. The achieved temperature sensitivities were similar to those of FBGs; however, the strain sensitivity improved more than one order of magnitude in comparison with FBG sensors, attaining slope sensitivities as good as 18.1 pm/με when using a 50 μm-waist MDTF as distributed reflector.
Open Access
WDM and TDM interrogation by sequentially pulsing direct modulated DFBs
(Optica, 2020) Pérez González, Asier; Bravo Acha, Mikel; Leandro González, Daniel; Pérez Herrera, Rosa Ana; López-Amo Sáinz, Manuel; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC
A new versatile and cost-effective interrogation system by pulsing direct modulated (DM) DFB laser diodes is proposed. 1 pm wavelength resolution and 600 m sensor spacing is demonstrated by sequentially pulsing a DM DFB.
Open Access
Real-time FFT analysis for interferometric sensors multiplexing
(IEEE / OSA, 2015) Leandro González, Daniel; Bravo Acha, Mikel; Ortigosa Cayetano, Amaia; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
In this paper, a theoretical and experimental study of two interferometric sensor multiplexing schemes has been carried out by means of the fast Fourier transform (FFT) analysis. This work addresses one of the main drawbacks of photonic crystal fiber (PCF) sensors, that is, its multiplexing capability. Using a commercial optical interrogator combined with a simple FFT measurement technique, the simultaneous real-time monitoring of several PCF sensors is achieved. A theoretical analysis has been performed where simulations matched with the experimental results. For the experimental verification, highly birefringent (HiBi) fiber sections that operated as sensing elements were multiplexed and tested in two configurations. Due to the FFT analysis, both multiplexing schemes can be properly interrogated by monitoring the FFT phase change at the characteristic spatial-frequency of each sensor. For this purpose a commercial interrogator and a custom Matlab program were used for computing the FFT and for monitoring the FFT phase change in real-time (1 Hz).
Open Access
Medida de torsión en seguidores solares con sensores de fibra óptica
(SEDOPTICA, 2021) Leandro González, Daniel; Bravo Acha, Mikel; López-Amo Sáinz, Manuel; Loayssa Lara, Alayn; Júdez Colorado, Aitor; Mariñelarena Ollacarizqueta, Jon; Falcone Lanas, Francisco; Jiménez Romero, Sergio; Moriana García, Iñaki; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación; Gobierno de Navarra / Nafarroako Gobernua WINDSOLAR (0011-1365-2017-000122)
En este trabajo se ha monitorizado la torsión sufrida por una estructura de seguidores solares empleando sensores de fibra óptica. Estas medidas de campo se han obtenido con una red de sensores formada por 45 redes de difracción de Bragg en una huerta solar activa. Estos resultados, correlados con la velocidad y dirección del viento permitirían aumentar la eficiencia de los seguidores y ayudar a entender y prevenir efectos negativos relacionados con inestabilidades aeroelásticas.
Open Access
Multicore fiber sensors for strain measurement towards traffic monitoring
(SPIE, 2023) Sánchez González, Arturo; Pradas Martínez, Javier; Corera Orzanco, Íñigo; Bravo Acha, Mikel; Leandro González, Daniel; Dauliat, Romain; Jamier, Raphael; Roy, Philippe; Pérez Herrera, Rosa Ana; López-Amo Sáinz, Manuel; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa, PJUPNA06-2022
In this work, two new interferometric sensors based on multicore optical fibers for the measurement of strain with the ultimate goal of traffic monitoring are presented. The operating principle of each sensor relied on the monitoring of the phase shift difference accumulated between the supermodes of the structure of the multicore segment in a full round trip. The strain characterization for both sensors resulted in a linear response, with sensitivities of -4.073·10-3 rad/με and - 4.389·10-3 rad/με for the aligned and V-shaped cases respectively, and one-hour instabilities below 4.6·10-3 rad with a 95% confidence level. These results suggest its feasibility in applications requiring high sensitivities over very wide strain ranges, such as heavy-vehicle traffic monitoring. To corroborate the hypothesis, both sensors were integrated into the pavement and their response to the traffic was analyzed.
Open Access
Micro-drilled optical fiber for enhanced laser strain sensors
(SPIE, 2019) Pérez Herrera, Rosa Ana; Bravo Acha, Mikel; Roldán Varona, Pablo; Leandro González, Daniel; Rodríguez Cobo, Luis; López Higuera, José Miguel; López-Amo Sáinz, Manuel; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación
In this work, we present an experimental measurement of temperature and strain sensitivities of a micro-drilled optical fiber (MDOF). The MDOF consisted of a quasi-randomly distributed reflector along a single mode fiber (SMF). A fiber cavity laser based on MDOF was experimentally studied, attaining a single-wavelength laser emission centered at 1568.6nm. The output power level obtained from this single-laser oscillation when pumped at 140mW was around - 9.6dBm, and an optical signal to noise ratio (OSNR) of around 45dB was measured. Although temperature sensitivities of fiber Bragg gratings used as sensors are similar to our MDOF, strain sensitivity is enhanced around one order of magnitude when the MDOF was used.
Open Access
Random fiber lasers: application to fiber optic sensors networks
(IEEE, 2017) López-Amo Sáinz, Manuel; Leandro González, Daniel; Miguel Soto, Verónica de; Bravo Acha, Mikel; Fernández Vallejo, Montserrat; Pérez Herrera, Rosa Ana; Ingeniaritza Elektrikoa eta Elektronikoa; Institute of Smart Cities - ISC; Ingeniería Eléctrica y Electrónica
Recently, random mirrors have been proposed as a method to create fiber laser cavities. This kind of cavity is based on cooperative Rayleigh scattering, which is generated along a fiber due to the material inhomogeneities presented in that fiber. In this work, basics of Random fiber lasers and different demonstrated lasing sensors systems for interrogating arrays of optical fiber sensors are shown. These systems use different kinds of amplification and cavities schemes and can interrogate optical fiber sensors located up to 225 km away.
Open Access
In-field torsion measurements on solar trackers using fiber optic sensors
(Optica, 2020) Leandro González, Daniel; Bravo Acha, Mikel; Júdez Colorado, Aitor; Mariñelarena Ollacarizqueta, Jon; Falcone Lanas, Francisco; Loayssa Lara, Alayn; López-Amo Sáinz, Manuel; Jiménez, S.; Achaerandio, Álvaro; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Gobierno de Navarra / Nafarroako Gobernua
In-field torsion measurements on solar trackers using fiber Bragg gratings are presented. 45 FBG sensors have been deployed in an operational solar energy plant to study the mechanical response of the structure to wind.
Open Access
Optical fiber sensors for asphalt structures monitoring
(Optica Publishing Group, 2016) Bravo Acha, Mikel; Rota Rodrigo, Sergio; Leandro González, Daniel; Loayssa Lara, Alayn; Urricelqui Polvorinos, Javier; Bravo Acha, A.; Bravo Navas, M.; Mitxelena, J. R.; Martínez Mazo, J. J.; López-Amo Sáinz, Manuel; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
A novel optical fiber installation method was explored for asphalt monitoring. Glassfiber polymer encapsulated SMF was installed in the intermediate and surface layers in order to study the strain sensitivity with a distributed strain interrogator.
Open Access
Traffic monitoring based on FBG sensor arrays in asphalt structures
(Optica, 2020) Bravo Acha, Mikel; Leandro González, Daniel; Bravo Acha, A.; Bravo Navas, M.; Mitxelena, J. R.; Martínez Mazo, J. J.; Camarero, E.; López-Amo Sáinz, Manuel; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
We evaluate the capabilities of optical fiber sensors to measure traffic flow, speed, weight estimation and pavement degradation. The proper operation of the system has been proved 3.5 years after the installation in a metropolitan road.