Open Access
Quasi-distributed vibration sensing using OFDR and weak reflectors
(Optical Society of America, 2019) Zhu, Mengshi; Leandro González, Daniel; López-Amo Sáinz, Manuel; Murayama, Hideaki; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación
The authors proposed a quasi-distributed vibration sensing technique using in-line weak reflectors and optical frequency domain reflectometry (OFDR). As a result, they achieved an 8 kHz measurable vibration frequency with a 15-20 cm spatial resolution employing a low repetition rate (similar to 8 Hz). Moreover, a measurable frequency of 30 kHz was achieved for a 1.5 m spatial resolution. The ability of the system to determine the frequency and amplitude of several sections vibrating simultaneously is evaluated for different configurations. Because of the simple arrangement, high detectable frequency, and high sensitivity, this approach is expected to be especially well suited for mechanical vibration sensing applications, particularly in medium-sized structures.
Open Access
High sensitive micro-displacement intensity fiber sensor by using a multiwavelength erbium doped fiber ring laser based on optical add-drop multiplexers
(SPIE, 2014-06-02) Pérez Herrera, Rosa Ana; Leandro González, Daniel; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
In this work, a wavelength division multiplexed fiber ring laser, based on optical add-drop multiplexers to interconnect intensity sensors has been experimentally demonstrated. Three different laser lines were obtained simultaneously all with an optical signal to noise ratio higher than 30dB. This proposed configuration is based on commercial devices and is adapted to the ITU channels normative. By using this configuration each sensor was associated with a different wavelength directly offered by each OADM and a reference wavelength was also included in order to distinguish between power variations induced by the transducer or to detect a fiber failure. This sensor system has been experimentally verified by using microbending sensors obtaining experimental slope sensitivity as good as -0.327dB/µm.
Open Access
Simultaneous measurement of strain and temperature using a single emission line
(IEEE / OSA, 2015) Leandro González, Daniel; Ams, Martin; López-Amo Sáinz, Manuel; Sun, Tong; Grattan, Kenneth T. V.; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
In this work, we present and demonstrate a novel sensor system for simultaneous measurement of strain and temperature through a unique combination of a long period grating (LPG) and a fiber laser based on a fiber Bragg grating (FBG). In order to achieve this, a new erbium doped fiber laser (EDFL) structure is created, showing an optical signal-to-noise ratio (OSNR) of 55 dB and a peak power measured on the OSA between -5 and 0 dBm. The strain and the temperature information can be obtained by using a unique emission line through monitoring both the fiber laser wavelength shift and the change of the power level, both of which showing a clear linear behavior.
Open Access
Narrow-linewidth multi-wavelength random distributed feedback laser
(IEEE / OSA, 2015) Leandro González, Daniel; Rota Rodrigo, Sergio; Ardanaz, Diego; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
In this work, narrow-band emission lines are generated by means of two random distributed feedback fiber laser schemes. Spectral line-widths as narrow as 3.2 pm have been measured, which significantly improves previous reported results. The laser is analyzed with the aim of obtaining a spectral line-width as narrow as possible. Additionally a variation of this setup for multi-wavelength operation is also validated. Both schemes present a simple topology that use a combination of phase-shifted fiber Bragg gratings and regular fiber Bragg gratings as filtering elements.
Open Access
Real-time FFT analysis for interferometric sensors multiplexing
(IEEE / OSA, 2015) Leandro González, Daniel; Bravo Acha, Mikel; Ortigosa Cayetano, Amaia; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
In this paper, a theoretical and experimental study of two interferometric sensor multiplexing schemes has been carried out by means of the fast Fourier transform (FFT) analysis. This work addresses one of the main drawbacks of photonic crystal fiber (PCF) sensors, that is, its multiplexing capability. Using a commercial optical interrogator combined with a simple FFT measurement technique, the simultaneous real-time monitoring of several PCF sensors is achieved. A theoretical analysis has been performed where simulations matched with the experimental results. For the experimental verification, highly birefringent (HiBi) fiber sections that operated as sensing elements were multiplexed and tested in two configurations. Due to the FFT analysis, both multiplexing schemes can be properly interrogated by monitoring the FFT phase change at the characteristic spatial-frequency of each sensor. For this purpose a commercial interrogator and a custom Matlab program were used for computing the FFT and for monitoring the FFT phase change in real-time (1 Hz).
Open Access
High-resolution transversal load sensor using a random distributed feedback fiber laser
(SPIE, 2016) Miguel Soto, Verónica de; Leandro González, Daniel; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
In this work, a new application of random distributed feedback lasers to fiber optic sensing has been presented. The particular properties of these lasers, such as the lack of longitudinal modes and high stability, have been exploited to monitor transversal load using a phase-shifted fiber Bragg grating (PS-FBG), obtaining a resolution of 1g and a sensitivity of 3.95GHz/Kg. Due to the PS-FBG birefringence and the load-interrelated transmission lines generated by the PS-FBG along the orthogonal polarization directions, the beating of the two emission lines generated in the laser can be monitored in the electrical domain. As a result, transversal load applied on the sensor can be measured.
Open Access
Interferometric vs wavelength selective optical fiber sensors for cryogenic temperature measurements
(SPIE, 2017) Miguel Soto, Verónica de; Leandro González, Daniel; López Aldaba, Aitor; Beato López, Juan Jesús; Pérez de Landazábal Berganzo, José Ignacio; Auguste, Jean-Louis; Jamier, Raphael; Roy, Philippe; López-Amo Sáinz, Manuel; Ingeniaritza Elektrikoa eta Elektronikoa; Fisika; Institute for Advanced Materials and Mathematics - INAMAT2; Ingeniería Eléctrica y Electrónica; Física
In this work, a preliminary study of the behavior of two different interferometric fiber optic sensors and two different wavelength selective fiber optic sensors is performed. A photonic cristal fiber Fabry-Pérot interferometer, a Sagnac interferometer, a commercial fiber Bragg grating (FBG) and a π-phase shifted fiber Bragg grating interrogated in a random distributed feedback fiber laser are analyzed. A comparison of their sensitivities and resolutions is carried out to analyze their performance as sensors for cryogenic temperatures, taking into account their advantages and drawbacks.
Open Access
Ultra-long (290 km) remote interrogation sensor network based on a random distributed feedback fiber laser
(Optical Society of America, 2018) Miguel Soto, Verónica de; Leandro González, Daniel; López-Amo Sáinz, Manuel; Ingeniaritza Elektrikoa eta Elektronikoa; Institute of Smart Cities - ISC; Ingeniería Eléctrica y Electrónica; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
In this work, an interferometric sensor has been interrogated 290 km away from the monitoring station, reaching the longest distance in fiber optic sensing up to date. This has been attained by employing a double-pumped random distributed feedback fiber laser as the light source for a fiber optic low-coherence interferometry scheme. Additionally, the capability of the system to achieve coherence multiplexing for ultra-long range measurements (up to 270 km) has been proved, without presenting crosstalk between the sensors. The use of coherence multiplexing together with a random distributed feedback fiber laser addresses two of the main limitations of long-range sensing setups: their limited multiplexing capability and the need to reach the maximum monitoring distance.
Open Access
L-band multiwavelength single-longitudinal mode fiber laser for sensing applications
(IEEE / OSA, 2012) Pérez Herrera, Rosa Ana; Ullán Nieto, Ángel; Leandro González, Daniel; Fernández Vallejo, Montserrat; Quintela, M. A.; Loayssa Lara, Alayn; López Higuera, José Miguel; López-Amo Sáinz, Manuel; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
In this work, a novel single-longitudinal-mode (SLM) four-wavelength laser configuration for sensing applications in the L-band is proposed and experimentally demonstrated. The sensor system presented here is based on ring resonators, and employs fiber Bragg gratings to select the operation wavelengths. The stable SLM operation is guaranteed when all the lasing channels present similar output powers. It is also experimentally demonstrated that when a SLMbehavior is achieved, lower output power fluctuations are obtained. Characterization of the lasing structure for temperature sensing is also shown.
Open Access
Optical fiber sensors for asphalt structures monitoring
(Optica Publishing Group, 2016) Bravo Acha, Mikel; Rota Rodrigo, Sergio; Leandro González, Daniel; Loayssa Lara, Alayn; Urricelqui Polvorinos, Javier; Bravo Acha, A.; Bravo Navas, M.; Mitxelena, J. R.; Martínez Mazo, J. J.; López-Amo Sáinz, Manuel; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
A novel optical fiber installation method was explored for asphalt monitoring. Glassfiber polymer encapsulated SMF was installed in the intermediate and surface layers in order to study the strain sensitivity with a distributed strain interrogator.