Person:
Fuentes Ordóñez, Edwin Gustavo

Profile Picture

Email Address

person.page.identifierURI

https://academica-e.unavarra.es/handle/2454/49043

Birth Date

Research Projects

Organizational Units

Job Title

Last Name

Fuentes Ordóñez

First Name

Edwin Gustavo

person.page.departamento

Ciencias

person.page.instituteName

ORCID

0000-0001-5365-1059

person.page.upna

811563

Name

Filters

2019 - 20202
Reset filters

Settings

Subject: High-value-added products ×

Search Results

Now showing 1 - 2 of 2
  • Thumbnail Image
    PublicationOpen Access
    Efficient recovery of aluminum from saline slag wastes
    (Elsevier, 2019) Yoldi Sangüesa, María; Fuentes Ordóñez, Edwin Gustavo; Korili, Sophia A.; Gil Bravo, Antonio; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Ciencias; Gobierno de Navarra / Nafarroako Gobernua, PI017 CORRAL
    This work presents the procedure to improve the aluminum extracted from a hazardous waste from the recycling of aluminum, aluminum that could be used in the production of value-added materials, as well as with the generation of non-hazardous waste. The aluminum waste was treated under reflux and stirring with NaOH aqueous solutions taking into account two concentrations (1 and 2 mol/dm3), various times of extraction (1, 2 and 4 h) and 4th consecutive steps of extraction in order to obtain solutions with Al3+. The activation of the waste by milling is also analyzed. After extraction, the solution is filtered to separate an aqueous solution that contain the extracted Al3+ and a residual waste. A maximum of 7.54 g/dm3 of aluminum was extracted in the first step, for a total accumulated of 9.59 g/dm3 of aluminum. The extracted aluminum can be used to synthesize added-value products applied as adsorbents and catalysts. Finally, the residual waste generated was characterized by N2 adsorption at −196 °C, X-ray diffraction, X-ray fluorescence, energy-dispersive X-ray and scanning electron microscopy in order to apply it as in future works adsorbent or catalyst.
  • Thumbnail Image
    PublicationOpen Access
    Zeolite synthesis from aluminum saline slag waste
    (Elsevier, 2020) Yoldi Sangüesa, María; Fuentes Ordóñez, Edwin Gustavo; Korili, Sophia A.; Gil Bravo, Antonio; Zientziak; Institute for Advanced Materials and Mathematics - INAMAT2; Ciencias; Gobierno de Navarra / Nafarroako Gobernua
    This work describes the synthetic procedures developed to obtain zeolite X (NaX), zeolite A (LTA) and sodalite (SOD) using aluminum saline slag waste (AlSSW) as aluminum source in a two-step hydrothermal method involving alkaline extraction of Al, with separation of the residual waste, and hydrothermal treatment at low temperatures and long reaction times. Use of the mother liquor obtained after filtration and separation of the zeolite is also analyzed in the alkaline extraction of Al. The synthetic parameters that determine the type of zeolite, purity, crystallinity, specific surface area, pore size and pore volume include the Si/Al molar ratio, pH, nucleation temperature and time, and crystallization temperature and time. These critical parameters were studied and determined to synthesize NaX, LTA and SOD as individual phases. The materials obtained were characterized by X-ray diffraction, scanning electron microscopy and N2 adsorption/desorption measurements at −196 °C. The characteristics of the best zeolites obtained are similar to those of IZA references and the specific surface areas are in the range of commercial ones: NaX ranges from 450 to 500 m2/g and LTA from 250 to 300 m2/g. The results show that it is possible to synthesize zeolites from AlSSW, thus allowing these materials to be applied as promising adsorbents and catalysts.