Mostrar el registro sencillo del ítem
Tunable optical fiber pH sensors based on TE and TM Lossy Mode Resonances (LMRs)
| dc.creator | Zubiate Orzanco, Pablo | es_ES |
| dc.creator | Ruiz Zamarreño, Carlos | es_ES |
| dc.creator | Del Villar, Ignacio | es_ES |
| dc.creator | Matías Maestro, Ignacio | es_ES |
| dc.creator | Arregui San Martín, Francisco Javier | es_ES |
| dc.date.accessioned | 2024-01-15T07:27:07Z | |
| dc.date.available | 2024-01-15T07:27:07Z | |
| dc.date.issued | 2016 | |
| dc.identifier.citation | Zubiate P., Zamarreño C.R., Del Villar I., Matias I.R., Arregui F.J. (2016) Tunable optical fiber pH sensors based on TE and TM Lossy Mode Resonances (LMRs). Sensors and Actuators, B: Chemical, 231, 484-490. https://doi.org/10.1016/j.snb.2016.03.024. | en |
| dc.identifier.issn | 0925-4005 | |
| dc.identifier.uri | https://hdl.handle.net/2454/47034 | |
| dc.description.abstract | In this paper, a high sensitivity optical fiber pH sensor based on lossy mode resonance (LMR) generated with transversal electric (TE) and transversal magnetic (TM) polarized light is presented. Poly(allylamine hydrochloride) (PAH)/poly(acrylic acid) (PAA) polymeric thin-films fabricated onto side-polished Dshaped optical fibers are used as pH-sensitive as well as LMR supporting coatings. The adequate selection of the pH-sensitive coating fabrication parameters enables to obtain devices working at different pH regions. Two devices have been obtained in order to measure pH from 4.0 to 5.0 and from 7.0 to 8.0 respectively. Obtained optical fiber pH sensors based on TE and TM LMRs showed a maximum sensitivity of 69 nm/pH, which means a resolution of ∼0.0008 pH units by using a conventional communications Optical Spectrum Analyzer (OSA) with 0.06 nm resolution. | en |
| dc.description.sponsorship | This work was supported by the Spanish Economy and Competitiveness Ministry-Feder TEC2013-43679-R and Fundación CAN2015-70221 Research Grants | en |
| dc.format.mimetype | application/pdf | en |
| dc.language.iso | eng | en |
| dc.publisher | Elsevier | en |
| dc.relation.ispartof | Sensors and Actuators B 231 (2016) 484-490 | en |
| dc.rights | © 2016 Elsevier B.V. This manuscript version is made available under the CC-BY-NC-ND 4.0. | en |
| dc.rights.uri | http://creativecommons.org/licenses/by-nc-nd/4.0/ | |
| dc.subject | Optical fiber | en |
| dc.subject | Lossy mode resonance | en |
| dc.subject | D-shaped | en |
| dc.subject | Layer-by-layer nano-assembly | en |
| dc.subject | Sensors | en |
| dc.subject | pH | en |
| dc.title | Tunable optical fiber pH sensors based on TE and TM Lossy Mode Resonances (LMRs) | en |
| dc.type | Artículo / Artikulua | es |
| dc.type | info:eu-repo/semantics/article | en |
| dc.date.updated | 2024-01-15T07:15:35Z | |
| dc.contributor.department | Institute of Smart Cities - ISC | en |
| dc.contributor.department | Ingeniería Eléctrica y Electrónica | es_ES |
| dc.contributor.department | Ingeniaritza Elektrikoa eta Elektronikoa | eu |
| dc.rights.accessRights | Acceso abierto / Sarbide irekia | es |
| dc.rights.accessRights | info:eu-repo/semantics/openAccess | en |
| dc.identifier.doi | 10.1016/j.snb.2016.03.024 | |
| dc.relation.projectID | info:eu-repo/grantAgreement/MINECO//TEC2013-43679-R/ES/ | en |
| dc.relation.publisherversion | https://doi.org/10.1016/j.snb.2016.03.024 | |
| dc.type.version | Versión aceptada / Onetsi den bertsioa | es |
| dc.type.version | info:eu-repo/semantics/acceptedVersion | en |
Ficheros en el ítem
Este ítem aparece en la(s) siguiente(s) colección(ones)
La licencia del ítem se describe como © 2016 Elsevier B.V. This manuscript version is made available under the CC-BY-NC-ND 4.0.
