Listar por autor UPNA "Urtasun Erburu, Andoni"
Mostrando ítems 21-31 de 31
-
Modeling and control of stand-alone AC microgrids: centralized and distributed storage, energy management and distributed photovoltaic and wind generation
El aumento de la penetración de energías renovables en la red eléctrica es necesario para el desarrollo de un sistema sostenible. Para hacerlo posible técnicamente, se ha planteado el uso de microrredes, definidas como ... -
Modeling of small wind turbines based on PMSG with diode bridge for sensorless maximum power tracking
The Permanent Magnet Synchronous Generator (PMSG) with diode bridge is frequently used in small Wind Energy Conversion Systems (WECS). This configuration is robust and cheap, and therefore suitable for small WECS. In order ... -
Modeling the inherent damping of high-power inverters
In order to decide whether passive or active damping is required in a three-phase inverter, a previous step is to assess the intrinsic damping of the system. However, few works focus on modeling this damping for DC/AC ... -
On the stability of advanced power electronic converters: the Generalized Bode Criterion
A key factor in the design of power electronic converters is the development of control systems and, in particular, the determination of their stability. Due to ease of application, the Bode criteria are currently the most ... -
Parameter-independent battery control based on series and parallel impedance emulation
Appropriate voltage control is essential in order to extend the useful life of a battery. However, when universal chargers are used, the design of this control becomes more complicated, given the fact that the battery ... -
Parameter-independent control for battery chargers based on virtual impedance emulation
An effective battery voltage regulation is fundamental to extend battery lifetime and to avoid overvoltage. However, the design of this regulation is complicated due to the wide battery impedance range, which, when dealing ... -
Power angle-frequency droop control to enhance transient stability of grid-forming inverters under voltage dips
Due to the replacement of synchronous generators, grid operators are currently demanding to control grid-connected inverters in grid–forming mode to make them participate in the maintenance of the grid. To carry this ... -
Robust multisampled capacitor voltage active damping for grid-connected power converters
The derivative feedback of the capacitor voltage is one of the most extended active damping strategies, used to eliminate stability problems in grid-connected power converters with an LCL filter. This strategy is equivalent ... -
Single feedback regulation of the AC voltage for high-power inverters under stand-alone operation
Energy-storage inverters under stand-alone operation must control the output voltage. However, existing methods for instantaneous voltage regulation are not suitable for high-power inverters due to their limited sampling ... -
Small wind turbines sensorless MPPT: robustness analysis and lossless approach
The configuration Permanent Magnet Synchronous Generator (PMSG) with diode bridge is frequently used in small Wind Energy Conversion Systems (WESC) thanks to its reliability and low cost. In order to perform a sensorless ... -
State-of-charge-based droop control for stand-alone AC supply systems with distributed energy storage
The droop method is an advantageous technique for stand-alone AC supply systems, allowing for power sharing among various inverters with no need for communication cables. However, in stand-alone systems with multiple ...