Listar Artículos de revista ISC - ISC aldizkari artikuluak por tema "Optical fiber sensors"
Mostrando ítems 1-11 de 11
-
All-PM fiber loop mirror interferometer analysis and simultaneous measurement of temperature and mechanical vibration
In this work, a new all-polarization maintaining (PM) fiber loop mirror interferometer is proposed and validated as temperature and mechanical vibration sensor. The scheme employs the arms of a PM coupler as communication ... -
Fabrication of long period gratings by periodically removing the coating of cladding-etched single mode optical fiber towards optical fiber sensor development
Here, we present a novel method to fabricate long period gratings using standard single mode optical fibers (SMF). These optical devices were fabricated in a three-step process, which consisted of etching the SMF, then ... -
Gamma radiation-induced effects over an optical fiber laser: towards new sensing applications
In the present work, the effect of gamma radiation on the performance of different types of erbium-doped fibers (EDFs) when they are used in a fiber ring cavity (FRC) configuration is studied. Several pieces of commercial ... -
Gas detection using LMR-based optical fiber sensors
This work presents a first approach to the utilization of Lossy Mode Resonance (LMR) based optical fiber sensors for gas detection. The optical sensor is based on a SnO2 thin-film fabricated onto the core of cladding ... -
Liquid level sensor based on dynamic Fabry–Perot interferometers in processed capillary fiber
In this work, a novel optical fiber sensor capable of measuring both the liquid level and its refractive index is designed, manufactured and demonstrated through simulations and experimentally. For this, a silica capillary ... -
Monitoring of water freeze-thaw cycle by means of an etched single-mode - multimode - single-mode fiber-optic refractometer
As an alternative to the different technologies that permit the detection of in-situ ice formation on different surfaces, this contribution proposes the design of an etched single-mode – multimode – single-mode (E-SMS) ... -
Multiparameter sensor based on a multiinterferometric serial configuration for temperature and strain measurements
In this work, a multi-parameter point sensor based on the combination of Fabry-Perot (FP) and the anti-resonant (AR) reflecting guidance in cascade configuration is proposed and experimentally demonstrated. This structure, ... -
Nanofabrication of phase-shifted Bragg gratings on the end facet of multimode fiber towards development of optical filters and sensors
This work describes the process of nanofabrication of phase-shifted Bragg gratings on the end facet of a multimode optical fiber with a pulsed DC sputtering system based on a single target. Several structures have been ... -
Simultaneous measurement of humidity and temperature based on a partially coated optical fiber long period grating
A humidity and temperature optical fiber sensor based on a long-period grating (LPG), which can provide simultaneous response to both magnitudes, is proposed and demonstrated via experiments. Previously, the LPG was fully ... -
Spatial-frequency multiplexing of high-sensitivity liquid level sensors based on multimode interference micro-fibers
This paper shows a new fiber optic sensor multiplexed system for liquid level sensing. Biconical fibertapers converging at a 40 mm-long micro-fiber are used as transducers. The tapers are designed to providethe propagation ... -
Trends in the design of intensity-based optical fiber biosensors (2010–2020)
There exists an increasing interest in monitoring low concentrations of biochemical species, as they allow the early-stage detection of illnesses or the monitoring of the environment quality. Thus, both companies and ...