Routing with classical corrugated waveguide low-pass filters with embedded bends
Fecha
2018Autor
Versión
Acceso abierto / Sarbide irekia
Tipo
Artículo / Artikulua
Versión
Versión publicada / Argitaratu den bertsioa
Identificador del proyecto
Impacto
|
10.2528/PIERL18022204
Resumen
A very simple design method to embed routing capabilities in classical corrugated filters
is presented in this paper. The method is based on the calculation of the heights and lengths of the
so-called filters design building blocks, by means of a consecutive and separate extraction of their local
reflection coefficients along the device. The proposed technique is proved with a 17th-order Zolot ...
[++]
A very simple design method to embed routing capabilities in classical corrugated filters
is presented in this paper. The method is based on the calculation of the heights and lengths of the
so-called filters design building blocks, by means of a consecutive and separate extraction of their local
reflection coefficients along the device. The proposed technique is proved with a 17th-order Zolotarev filter
whose topology is bent twice so that the input and output ports are in the same plane while
preserving the in-line filters behaviour. This new filter allows the possibility of eliminating subsequent
bending structures, reducing the insertion loss, weight, and PIM. [--]
Materias
Rectangular waveguide,
Low-pass filter,
Routing
Editor
EMW Publishing
Publicado en
Progress in Electromagnetics Research Letters, Vol. 75, pp. 1–6, 2018
Departamento
Universidad Pública de Navarra. Departamento de Ingeniería Eléctrica y Electrónica /
Nafarroako Unibertsitate Publikoa. Ingeniaritza Elektrikoa eta Elektronikoa Saila
Versión del editor
Entidades Financiadoras
This work was supported by MINECO (Spain) (grant TEC2014-55735-C3-R, TEC2014-51902-C2-2-R,
and TEC2017-85529-C3-2-R).