Buscar
Mostrando ítems 11-20 de 50
Sensors based on thin-film coated cladding removed multimode optical fiber and single-mode multimode single-mode fiber: a comparative study
(Hindawi Publishing Corporation, 2015)
Artículo / Artikulua,
Two simple optical fibre structures that do not require the inscription of a grating, a cladding removed multimode optical fibre
(CRMOF) and a single-mode multimode single-mode structure (SMS), are compared in terms of ...
Optimization in nanocoated D-shaped optical fiber sensors
(Optical Society of America, 2017)
Artículo / Artikulua,
Nanocoated D-shaped optical fibers have been proven as effective sensors. Here,
we show that the full width at half minimum (FWHM) of lossy mode resonance can be
reduced by optimizing the nanocoating width, thickness and ...
Sensitivity enhancement experimental demonstration using a low cutoff wavelength SMS modified structure coated with a pH sensitive film
(Elsevier, 2018)
Artículo / Artikulua,
The multimode interference (MMI) effect in a single mode-multimode-single mode (SMS) can be used fordevelopment of wavelength shift detection based sensors. In this work, the focus is centered on obtainingwavelength shifts ...
Giant sensitivity of optical fiber sensors by means of lossy moderesonance
(Elsevier, 2016)
Artículo / Artikulua,
Here we show an optical refractometer with a giant sensitivity of 304,360 nm per refractive index unit(nm/RIU). This sensitivity corresponds to a resolution of 3.28 × 10−9RIU if a standard optical spectrumanalyzer with a ...
Resonances in coated long period fiber gratings and cladding removed multimode optical fibers: a comparative study
(Optical Society of America, 2010)
info:eu-repo/semantics/article,
Two optical fiber devices have been coated in parallel: a long
period fiber grating (LPFG) and a cladding-removed multimode optical
fiber (CRMOF). The progressive coating of the LPFG by means of the
layer-by-layer ...
Optimization of sensors based on multimode interference in single-mode–multimode– single-mode structure
(IEEE, 2013)
Artículo / Artikulua,
By coating a single-mode–multimode–single-mode
(SMS) structure with a complex refractive index thin-film the central
wavelength of the transmission and attenuation bands of the
optical spectrum can be shifted. By adequate ...
Tapered single-mode optical fiber pH sensor based on lossy mode resonances generated by a polymeric thin-film
(IEEE, 2012)
Artículo / Artikulua,
Lossy mode resonances can be generated with certain polymeric nanostructures, such as those obtained with a multilayered assembly of poly(allylamine hydrochloride) and poly (acrylic acid). This coating is adsorbed by the ...
Influence of waist length in lossy mode resonances generated with coated tapered single mode optical fibers
(IEEE, 2011)
Artículo / Artikulua,
In this work, the generation of electromagnetic resonances due to the deposition of a nanocoating on a tapered single-mode optical fiber is analyzed. The layer-by-layer technique is used to control the thickness of the ...
Fabrication of Bragg gratings on the end facet of standard optical fibers by sputtering the same material
(IEEE, 2016)
Artículo / Artikulua,
A sputtering process has been applied to deposit quarter-wavelength stacks on the end facet of cleaved optical fibers by using only one sputtering target. Standard multimode optical fibers were used as substrates to fabricate ...
Humidity sensor based on Bragg gratings developed on the end facet of an optical fiber by sputtering of one single material
(MDPI, 2017)
Artículo / Artikulua,
The refractive index of sputtered indium oxide nanocoatings has been altered just by changing the sputtering parameters, such as pressure. These induced changes have been exploited for the generation of a grating on the ...