Buscar
Mostrando ítems 21-30 de 83
Influence of waist length in lossy mode resonances generated with coated tapered single mode optical fibers
(IEEE, 2011)
Artículo / Artikulua,
In this work, the generation of electromagnetic resonances due to the deposition of a nanocoating on a tapered single-mode optical fiber is analyzed. The layer-by-layer technique is used to control the thickness of the ...
Fiber-optic immunosensor based on lossy mode resonances induced by indium tin oxide thin-films
(IEEE, 2017)
Contribución a congreso / Biltzarrerako ekarpena,
A novel immunosensor based on lossy mode resonances (LMRs) induced in optical fibers is developed in this contribution. Indium tin oxide (ITO) is sputtered on the optical substrate to generate an LMR in the transmission ...
SnO2 based optical fiber refractometers
(SPIE, 2012)
Contribución a congreso / Biltzarrerako ekarpena,
In this work, the fabrication and characterization of refractometers based on lossy mode resonances (LMR) is presented. Tin dioxide (SnO2) films deposited on optical fibers are used as the LMR supporting coatings. These ...
Sensitivity enhancement by diameter reduction in low cutoff wavelength single-mode multimode singlemode (SMS) fiber sensors
(IEEE, 2017)
Contribución a congreso / Biltzarrerako ekarpena,
Two different low cutoff wavelength single-mode fibers were used in single-mode multimode single-mode (SMS) configuration with the aim of designing sensors operating at short wavelengths, where optical sources and spectrometers ...
Optical fiber refractometers based on indium tin oxide coatings with response in the visible spectral region
(Elsevier, 2011)
Contribución a congreso / Biltzarrerako ekarpena,
This work presents the fabrication of optical fiber refractometers based on indium tin oxide (ITO) coatings with
response in the visible spectral region. ITO thin-films have been sputtered by employing a rotating mechanism ...
Study and optimization of self-assembled polymeric multilayer structures with neutral red for pH sensing applications
(Hindawi / Wiley, 2008)
info:eu-repo/semantics/article,
The characterization of nanostructured thin films is critical in the design and fabrication of optical sensors. Particularly, this work is a detailed study of the properties of layer-by-layer electrostatic self-assembled ...
Photonic crystal fiber temperature sensor based on quantum dot nanocoatings
(Hindawi / Wiley, 2009)
info:eu-repo/semantics/article,
Quantum dot nanocoatings have been deposited by means of the Layer-by-Layer technique on the inner holes of Photonic Crystal Fibers (PCFs) for the fabrication of temperature sensors. The optical properties of these sensors ...
Micro and nanostructured materials for the development of optical fibre sensors
(MDPI, 2017)
info:eu-repo/semantics/article,
The measurement of chemical and biomedical parameters can take advantage of the features
exclusively offered by optical fibre: passive nature, electromagnetic immunity and chemical stability
are some of the most relevant ...
An optimized method based on digitalized Lissajous curve to determine lifetime of luminescent materials on optical fiber sensors
(Hindawi, 2016)
Artículo / Artikulua,
A method is proposed to determine lifetime of luminescent emissions based on the phase shift measurement employing the digitalized Lissajous representation: this diagram has been typically used with analogical algorithms, ...
Fiber-based label-free D-dimer detection for early diagnosis of venous thromboembolism
(SPIE, 2020)
info:eu-repo/semantics/conferenceObject,
D-dimer is a useful diagnostic biomarker for deep vein thrombosis or pulmonary embolism, collectively referred to as venous thromboembolism (VTE). The ability to detect in real-time the amount of D-dimer with a fast and ...