Open Access
Ultra-low detection limit lossy mode resonance-based fibre-optic biosensor
(Optica Publishing Group, 2018) Chiavaioli, Francesco; Zubiate Orzanco, Pablo; Del Villar, Ignacio; Ruiz Zamarreño, Carlos; Giannetti, Ambra; Tombelli, Sara; Trono, Cosimo; Matías Maestro, Ignacio; Arregui San Martín, Francisco Javier; Baldini, Francesco; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza; Institute of Smart Cities - ISC
We report on ultra-low detection limit lossy mode resonance-based fibre-optic biosensor coated with nm-thick tin dioxide film, which allows measuring fibre-surrounding medium changes with very high sensitivity for label-free and real-time biomolecular interaction analysis
Open Access
D-shape optical fiber pH sensor based on lossy mode resonances (LMRs)
(IEEE, 2016-01-07) Zubiate Orzanco, Pablo; Ruiz Zamarreño, Carlos; Del Villar, Ignacio; Matías Maestro, Ignacio; Arregui San Martín, Francisco Javier; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza
The fabrication and characterization of an optical fiber pH sensor based on Lossy Mode Resonances (LMRs) is presented. PAH/PAA polymeric thin-films fabricated onto side-polished D-shaped optical fibers are used as LMR supporting coatings. The thickness of PAH/PAA coatings can be modified as a function of the external medium pH. As a consequence of this variation, the effective refractive index of the structure will change, producing a shift of the LMR. The fabricated sensor has been used to measure pH from 4.0 to 5.0. This pH sensor showed a sensitivity of 101.3 nm per pH unit, which means a resolution of ~6×10-4 pH units by using a conventional communications Optical Spectrum Analyzer (OSA), which is an improvement over commercial pH sensors.
Open Access
Improving the width of lossy mode resonances (LMRs) in double-clad fibers
(IEEE, 2023) Imas González, José Javier; Del Villar, Ignacio; Zubiate Orzanco, Pablo; Ruiz Zamarreño, Carlos; Matías Maestro, Ignacio; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
In this work, the characteristics of lossy mode resonances (LMRs) in double-clad fibers where the refractive index (RI) of the second cladding is lower than that of the first cladding are analyzed both numerically and experimentally. In the first place, the LMRs spectra obtained with a 75 nm TiO 2 thin film are simulated, and it is observed that a thicker second cladding improves the width of the resonances, making them narrower. Then, two experimental cases (no second cladding, and second cladding with thickness of 1.13 μm) are assessed, showing a good agreement with the previous simulations. Finally, an experimental refractometric study is carried out in liquids (surrounding medium refractive index in the 1.34 - 1.40 range) for both fibers, calculating the full width at 1 dB (FW 1dB ), the sensitivity, and the figure of merit (FOM). The FW 1dB is better for the LMR obtained on the fiber with second cladding while the sensitivity is slightly greater for the fiber without second cladding. In the case of the FOM, it is higher for the double-clad fiber as the narrowing of the resonances outweighs the lower sensitivity. These results show that the performance of LMR-based optical fiber sensors can be improved by employing double-clad fibers.
Open Access
Generation of lossy mode resonances (LMR) using perovskite nanofilms
(Chinese Academy of Sciences, 2024) Armas, Dayron; Matías Maestro, Ignacio; López-González, M. Carmen; Ruiz Zamarreño, Carlos; Zubiate Orzanco, Pablo; Del Villar, Ignacio; Romero, Beatriz; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
The results presented here show for the first time the experimental demonstration of the fabrication of lossy mode resonance (LMR) devices based on perovskite coatings deposited on planar waveguides. Perovskite thin films have been obtained by means of the spin coating technique and their presence was confirmed by ellipsometry, scanning electron microscopy, and X-ray diffraction testing. The LMRs can be generated in a wide wavelength range and the experimental results agree with the theoretical simulations. Overall, this study highlights the potential of perovskite thin films for the development of novel LMR-based devices that can be used for environmental monitoring, industrial sensing, and gas detection, among other applications.
Open Access
Optimization in nanocoated D-shaped optical fiber sensors
(Optical Society of America, 2017) Del Villar, Ignacio; Zubiate Orzanco, Pablo; Ruiz Zamarreño, Carlos; Arregui San Martín, Francisco Javier; Matías Maestro, Ignacio; Ingeniaritza Elektrikoa eta Elektronikoa; Institute of Smart Cities - ISC; Ingeniería Eléctrica y Electrónica; Gobierno de Navarra / Nafarroako Gobernua
Nanocoated D-shaped optical fibers have been proven as effective sensors. Here, we show that the full width at half minimum (FWHM) of lossy mode resonance can be reduced by optimizing the nanocoating width, thickness and refractive index. As a counterpart, several resonances are observed in the optical spectrum for specific conditions. These resonances are caused by multiple modes guided in the nanocoating. By optimizing the width of the coating and the imaginary part of its refractive index, it is possible to isolate one of these resonances, which allows one to reduce the full width at half minimum of the device and, hence, to increase the figure of merit. Moreover, it is even possible to avoid the need of a polarizer by designing a device where the resonance bands for TE and TM polarization are centered at the same wavelength. This is interesting for the development of optical filters and sensors with a high figure of merit.