Urtasun Erburu, Andoni
Loading...
Email Address
person.page.identifierURI
Birth Date
Job Title
Last Name
Urtasun Erburu
First Name
Andoni
person.page.departamento
Ingeniería Eléctrica, Electrónica y de Comunicación
person.page.instituteName
ISC. Institute of Smart Cities
ORCID
person.page.observainves
person.page.upna
Name
- Publications
- item.page.relationships.isAdvisorOfPublication
- item.page.relationships.isAdvisorTFEOfPublication
- item.page.relationships.isAuthorMDOfPublication
4 results
Search Results
Now showing 1 - 4 of 4
Publication Open Access Dynamic analysis of the conductance-frequency droop control during current limitation(IEEE, 2024-08-30) Urtasun Erburu, Andoni; Erdocia Zabala, Ioseba; Marroyo Palomo, Luis; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa, PJUPNA2024-11695In inverter-based stand-alone microgrids, the P-f and O-V droop methods are frequently used to keep control of the microgrid voltage. However, in the presence of overloads or short-circuits, in which the inverter must perform a current- limiting strategy, the P-f droop becomes prone to transient instability. In order to remain stable under any possible overload or fault, the conductance-frequency $({G-f})$ droop is a promising alternative, however no analysis about its dynamic response has been carried out so far. This paper proposes a small-signal model of the system during current limitation, proving that the ${G-f}$ droop is also superior to the existing droop methods in terms of rapidity. Simulation results validate the theoretical analysis.Publication Open Access High-dynamics P-E and Q-f control of PV inverters for strong and weak grids(IEEE, 2023-08-31) Urtasun Salinas, Ibai; Urtasun Erburu, Andoni; Marroyo Palomo, Luis; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza; Institute of Smart Cities - ISCThe increase of power electronic-based generators is causing the replacement of synchronous generators, which poses new challenges to electrical grid stability. In particular, when grid-following inverters are connected to weak grids, stability problems related to the PLL used for synchronization arise. To address this issue, grid-forming controls are widely proposed. However, the conventional implementations, such as droop control or virtual synchronous generator, lead to slow power controls, which are not suitable for photovoltaic systems with no storage. Thus, to improve the control dynamics, this paper proposes a new P-E and Q-f control. This control uses the reactive power for grid synchronization, avoiding the use of a PLL, and is valid for both inductive and resistive lines. Furthermore, thanks to the controller design developed in the paper, the control remains rapid and stable for very weak grids. Simulation results validates the control design and shows that the proposed control is much faster than the droop control for all types of grids.Publication Open Access Analysis of the active inertia power provided by grid-forming strategies during a RoCoF(IEEE, 2024-08-30) Urtasun Salinas, Ibai; Urtasun Erburu, Andoni; Bautista Portillo, Guillermo Antonio; Marroyo Palomo, Luis; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza; Institute of Smart Cities - ISC; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa, PJUPNA2024-11695Power electronic-based generators are becoming increasingly prevalent in the electrical grid, necessitating their support in disturbances previously handled only by synchronous generators. One of the tests proposed by regulations is to evaluate the response of grid-forming inverters to a Rate of Change of Frequency (RoCoF). However, there is no detailed analysis of the effect of control parameters on the active inertia power. This article presents the temporal response equation of an inverter subject to a RoCoF and introduces the concept of equivalent inertia showing that it also depends on the damping factor. Thanks to this analysis and the flexibility of inverters, the parameter design of existing grid-forming strategies is proposed to achieve the desired active inertia power and system damping ratio. Theoretical analysis and control strategies have been validated by simulation.Publication Open Access Conductance-frequency droop control to ensure transient stability of inverter-based stand-alone microgrids(Elsevier, 2023) Erdocia Zabala, Ioseba; Urtasun Erburu, Andoni; Marroyo Palomo, Luis; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Universidad Pública de Navarra / Nafarroako Unibertsitate PublikoaCurrently, inverter-based stand-alone microgrids are gaining interest due to the advantages of obtaining energy from renewable sources. To manage the operation, these microgrids include storage systems connected in par- allel to the PCC through electronic inverters that are controlled as voltage sources in order to support the fre- quency and voltage at the PCC. For the purpose of ensuring P and Q sharing among inverters and also the synchronization stability of the microgrid, droop control is widely used, achieving a satisfactory performance in normal operation. Nevertheless, in the presence of overloads or short-circuits, the inverters must limit the current for self-protection, thereby modifying the performance of the system that then becomes prone to suffer transient stability problems. In this paper, first the performance of the inverter-based stand-alone microgrids with the conventional P-f and Iact-f droops is analyzed, obtaining the stability boundaries during current limitation. In order to always ensure the synchronization stability of the system, this paper then proposes the G-f droop that consists in employing the equivalent conductance seen by each inverter for its frequency droop control. Furthermore, as this variable always correctly represents the inverter power angle, the system dynamics are not affected by the operating conditions. The theoretical results have been validated by means of simulation and Hardware-In-the-Loop results, showing the superior performance of the proposed G-f droop