Open Access
Design methodology for the frequency shift method of islanding prevention and analysis of its detection capability
(Wiley, 2005) Sanchis Gúrpide, Pablo; Marroyo Palomo, Luis; Coloma, Javier; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
Islanding protection is one of the most important sources of discrepancy in gridconnected photovoltaic systems. Even when islanding is not very likely to happen, regulations demand the photovoltaic inverters to implement effective protection methods. Due to its several advantages, the frequency shift method of islanding prevention, commonly known as Sandia Frequency Shift, is one of the most important active methods. This method implements a positive feedback of the frequency that tends to move it outside the trip limits in case of islanding. The method shows a very high detection capability, which depends on both the values of the method parameters and the characteristics of the load that remains in the same power section after islanding. This paper develops a mathematical analysis of the Sandia Frequency Shift method and proposes a new methodology to design its parameters as a trade-off between the detection capability, which is evaluated as a function of the load characteristics, and the distortion that the method could introduce in the grid as a consequence of transitory frequency disturbances. The ability of this methodology to design the method parameters and achieve the highest detection capability is satisfactorily proved by means of both simulation and experimental results on a commercial photovoltaic inverter that implements the method once its parameters have been designed with the proposed methodology.
Open Access
Adaptive voltage control of the DC/DC boost stage in PV converters with small input capacitor
(IEEE, 2013) Urtasun Erburu, Andoni; Sanchis Gúrpide, Pablo; Marroyo Palomo, Luis; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
In the case of photovoltaic (PV) systems, an adequate PV voltage regulation is fundamental in order to both maximize and limit the power. For this purpose, a large input capacitor has traditionally been used. However, when reducing that capacitor size, the nonlinearities of the PV array make the performance of the voltage regulation become highly dependent on the operating point. This paper analyzes the nonlinear characteristics of the PV generator and clearly states their effect on the control of the DC/DC boost stage of commercial converters by means of a linearization around the operating point. Then, it proposes an adaptive control, which enables the use of a small input capacitor preserving at the same time the performance of the original system with a large capacitor. Experimental results are carried out for a commercial converter with a 40 μF input capacitor, and a 4 kW PV array. The results corroborate the theoretical analysis; they evidence the problems of the traditional control, and they validate the proposed control with such a small capacitor.
Open Access
Enhancement of the voltage control response in three-phase photovoltaic inverters with small dc capacitors
(IEEE, 2023) Urtasun Erburu, Andoni; Sanchis Gúrpide, Pablo; Marroyo Palomo, Luis; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
In the case of photovoltaic (PV) inverters, an adequate dc voltage regulation is fundamental to maximize or limit the power injected into the grid. However, the traditional control requires a large dc capacitance to ensure stability in the whole operating range while the existing alternatives, despite achieving a stable control with a small capacitance, become too slow in the open-circuit area. This paper proposes two control methods to improve this performance. Firstly, a new voltage control with virtual impedance emulation is presented, showing that the response becomes faster in all operating points. Secondly, the control with impedance emulation is combined with a feed-forward compensation, further improving the dynamic response. Both methods are very simple to implement and their superior performance when using a small dc capacitance is verified by means of simulation results.
Open Access
Electronic controlled device for the analysis and design of photovoltaic systems
(IEEE, 2005) Sanchis Gúrpide, Pablo; López Taberna, Jesús; Ursúa Rubio, Alfredo; Marroyo Palomo, Luis; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
The characterization and design of photovoltaic systems is a difficult issue due to the variable operation atmospheric conditions. With this aim, simulators and measurement equipments have been proposed. However, most of them do not deal with real atmospheric conditions. This letter proposes an electronic device that first measures the real evolution of the I-V characteristic curves of photovoltaic modules and generators, and then physically emulates in real time these curves to test photovoltaic inverters. The device consists of a dc-dc converter, a microcontroller and a data storage unit. The two operation modes (emulation and measurement) are digitally driven by the microcontroller. The converter current is controlled by means of a variable-hysteresis control loop, whose reference is provided by the microcontroller. In addition, a digital voltage control loop is designed to find out the complete characteristic curves of the photovoltaic generators. A 15-kW prototype is designed and built that can measure three times per second the characteristic curves of up to seven generators and then emulate their electrical behavior to test photovoltaic inverters. With the proposed device, the optimal configuration and performance of photovoltaic modules and generators, as well as the operation of photovoltaic inverters can be thoroughly analyzed under real atmospheric conditions.
Open Access
DC capacitance reduction in photovoltaic inverters based on PV voltage feed-forward compensation
(IEEE, 2021) Urtasun Erburu, Andoni; Sanchis Gúrpide, Pablo; Marroyo Palomo, Luis; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación
In the case of photovoltaic (PV) inverters, an adequate input voltage regulation is fundamental to maximize or limit the power. When employing the traditional control, the input capacitance requires to be oversized in order to reduce the influence of the PV generator and achieve a stable control in the whole operating point. This paper proposes a voltage control method which permits reducing the capacitance by a factor of 5, thereby reducing the system cost. The control includes a feed-forward compensation of the PV voltage, making it possible to achieve a fast and stable control with a simple implementation. The proposed method is verified by simulation, showing the problems of the traditional control and the superior performance of the proposed control.