Del Villar, Ignacio

Loading...
Profile Picture

Email Address

Birth Date

Job Title

Last Name

Del Villar

First Name

Ignacio

person.page.departamento

Ingeniería Eléctrica, Electrónica y de Comunicación

person.page.instituteName

ISC. Institute of Smart Cities

person.page.observainves

person.page.upna

Name

Search Results

Now showing 1 - 10 of 144
  • PublicationOpen Access
    Lossy mode resonance sensors based on lateral light incidence in nanocoated planar waveguides
    (Nature Research, 2019) Fuentes Lorenzo, Omar; Del Villar, Ignacio; Corres Sanz, Jesús María; Matías Maestro, Ignacio; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren; Institute of Smart Cities - ISC; Ingeniería Eléctrica, Electrónica y de Comunicación; Gobierno de Navarra / Nafarroako Gobernua, 2018/PC021-022
    The deposition of an indium oxide (In2O3) thin film on conventional planar waveguides (a coverslip and a glass slide) allows generating lossy mode resonances (LMR) by lateral incidence of light on the waveguide and by registering the optical spectrum in a spectrometer. This novel sensing system becomes an alternative to optical fibre, the substrate where LMR-based sensors have been developed so far, since it is easier to handle and more robust. An additional advantage is that cost effective waveguides, such as slides or coverslips, can be used in a platform that resembles surface plasmon resonance-based sensors in the Kretschmann configuration but without the need for a coupling prism and with the advantage of being able to generate TE and TM LMR resonances with metallic oxide or polymer thin films. The results are corroborated with simulations, which provide in-depth understanding of the phenomena involved in the sensing system. As a proof-of-concept for the optical platform, two refractometers were developed, one with low sensitivity and for a wide range of refractive indices, and the other with higher sensitivity but for a narrower refractive index range. The sensors presented here open up the path for the development of LMR-based chemical sensors, environmental sensors, biosensors, or even the generation of other optical phenomena with the deposition of multilayer structures, gratings or nanostructures, which is much easier in a planar waveguide than in an optical fibre.
  • PublicationOpen Access
    Enhancement of lossy mode resonance sensing properties by the introduction of an intermediate low-refractive-index layer
    (Optica, 2023) Armas, Dayron; Kwietniewski, Norbert; Matías Maestro, Ignacio; Burnat, Dariusz; Smietana, Mateusz; Del Villar, Ignacio; Institute of Smart Cities - ISC; Universidad Pública de Navarra / Nafarroako Unibertsitate Publikoa
    Devices based on the lossy mode resonance (LMR) effect have found numerous sensing applications. Herein, the enhancement of the sensing properties by the introduction of an intermediate layer between the substrate and the LMR-supporting film is discussed. Experimental results for a silicon oxide (SiO2) layer of tuned thickness between a glass slide substrate and a thin film of titanium oxide (TiO2) prove the possibility of significantly increasing the LMR depth and the figure of merit (FoM) for refractive index sensing applications, which is supported by a numerical analysis using the plane wave method for a one-dimensional multilayer waveguide. The application of the intermediate layer allows the introduction of a new, to the best of our knowledge, degree of freedom into the design of LMR-based sensors, resulting in improved performance for demanding fields such as chemical sensing or biosensing.
  • PublicationOpen Access
    Analysis of one-dimensional photonic band gap structures with a liquid crystal defect towards development of fiber-optic tunable wavelength filters
    (Optical Society of America, 2003) Del Villar, Ignacio; Matías Maestro, Ignacio; Arregui San Martín, Francisco Javier; Claus, Richard O.; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Gobierno de Navarra / Nafarroako Gobernua
    A theoretical analysis of a fiber optical photonic band gap based tunable wavelength filter is presented. The design presented here is based on the quarter wave reflector with a liquid crystal defect layer in the middle of the structure. The filter generated by the structure is shifted in wavelength as the voltage applied to the structure is modified. Some critical parameters are analyzed: the effect of the consideration of fiber as the first layer and not the input medium in the shape of the filter, the number of layers of the structure, and the thickness of the defect layer. This last parameter determines the width of the wavelength sweep of the filter, but is limited by the creation of more defects. Some rules of practical implementation of this device are also given.
  • PublicationOpen Access
    Long period fiber gratings with overlay of variable refractive index
    (IEEE, 2005) Del Villar, Ignacio; Matías Maestro, Ignacio; Arregui San Martín, Francisco Javier; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Gobierno de Navarra / Nafarroako Gobernua
    A theoretical analysis is presented of a long-period fiber grating (LPFG) with an overlay of variable refractive index. The highest sensitivity of the resonance wavelengths to variations in the refractive index of the overlay can be optimized. There are two key points for a good design: the selection of an overlay refractive index close to that of the cladding of the LPFG and the overlay thickness. The problem is analyzed with a numerical method based on coupled-mode theory.
  • PublicationOpen Access
    Optical fiber immunosensors optimized with cladding etching and ITO nanodeposition
    (IEEE, 2018) Cardona-Maya, Yamile; Del Villar, Ignacio; Socorro Leránoz, Abián Bentor; Corres Sanz, Jesús María; Botero-Cadavid, Juan F.; Institute of Smart Cities - ISC; Gobierno de Navarra / Nafarroako Gobernua
    Etched optical fiber immunosensors, with and without ITO nanodeposition, have been developed. The performance of these immunosensors has been assessed implementing an immunoassay. The sensitivity of the mmnunosensor increased by a factor of 4 with the ITO nanocoating, whereas the limit of the detection in both types of devices was 0.2 mg/L of antigens in solution.
  • PublicationOpen Access
    Sensors based on thin-film coated cladding removed multimode optical fiber and single-mode multimode single-mode fiber: a comparative study
    (Hindawi Publishing Corporation, 2015) Del Villar, Ignacio; Socorro Leránoz, Abián Bentor; Hernáez Sáenz de Zaitigui, Miguel; Corres Sanz, Jesús María; Ruiz Zamarreño, Carlos; Sánchez Zábal, Pedro; Arregui San Martín, Francisco Javier; Matías Maestro, Ignacio; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
    Two simple optical fibre structures that do not require the inscription of a grating, a cladding removed multimode optical fibre (CRMOF) and a single-mode multimode single-mode structure (SMS), are compared in terms of their adequateness for sensing once they are coated with thin-films.The thin-film deposited (TiO2/PSS) permits increasing the sensitivity to surrounding medium refractive index. The results obtained can be extrapolated to other fields such as biological or chemical sensing just by replacing the thin-film by a specific material.
  • PublicationOpen Access
    SnO2 based optical fiber refractometers
    (SPIE, 2012) Sánchez Zábal, Pedro; Ruiz Zamarreño, Carlos; Hernáez Sáenz de Zaitigui, Miguel; Del Villar, Ignacio; Matías Maestro, Ignacio; Arregui San Martín, Francisco Javier; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Gobierno de Navarra / Nafarroako Gobernua
    In this work, the fabrication and characterization of refractometers based on lossy mode resonances (LMR) is presented. Tin dioxide (SnO2) films deposited on optical fibers are used as the LMR supporting coatings. These resonances shift to the red as a function of the external refractive index, enabling the fabrication of robust and highly reproducible wavelength-based optical fiber refractometers. The obtained SnO2-based refractometer shows an average sensitivity of 7198 nm/refractive index unit (RIU) in the range 1.333-1.420 RIU.
  • PublicationOpen Access
    Side-polished photonic crystal fiber sensor with ultra-high figure of merit based on Bloch-like surface wave resonance
    (Elsevier, 2024) González-Valencia, Esteban; Reyes-Vera, Erick; Del Villar, Ignacio; Torres, Pedro; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza; Institute of Smart Cities - ISC
    A Bloch surface wave (BSW) resonance configuration is introduced for biosensing with an ultra-high figure of merit (FOM). The BSW excitation is realized through the evanescent field of the core-guided fundamental mode of a side-polished photonic crystal fiber (PCF). By taking advantage of the air hole periodic microstructure of the PCF cladding, the BSW platform can be achieved with only a single high refractive index dielectric layer on its flat surface. The dielectric layer deposited on the polished surface of the PCF modifies the local effective refractive index, allowing direct manipulation of the BSWs, whereby the resonance wavelength of the surface wave can be adjusted by choosing the material and thickness of this layer. Here, we numerically investigate Bloch-like surface wave (BLSW) resonance conditions around telecom wavelengths for silicon, titanium dioxide, copper monoxide, and aluminum oxide termination layers. The BLSW excitation platform materials have low loss, which results in higher surface field enhancements and narrower resonances, which are advantageous properties for the sensors. The obtained results open new avenues for the application of optical surface waves in biosensing with high FOM. Furthermore, these results show a much higher figure of merit (FOM) than traditional approaches, allowing for increased sensitivity and accuracy.
  • PublicationOpen Access
    Lossy mode resonance generation with indium tin oxide coated optical fibers for sensing applications
    (IEEE, 2010) Del Villar, Ignacio; Ruiz Zamarreño, Carlos; Hernáez Sáenz de Zaitigui, Miguel; Arregui San Martín, Francisco Javier; Matías Maestro, Ignacio; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
    Surface plasmon resonances and lossy mode resonances can be generated with Indium Tin Oxide (ITO) coated optical fibers. Both phenomena are analyzed and compared. Lossy mode resonances present important advantages: they do not require a specific polarization of light, it is possible to generate multiple attenuation bands in the transmission spectrum, and the sensitivity of the device to external parameters can be tuned. The key parameter is the thickness of the ITO coating. The work is supported with both theoretical and experimental results. The main purposes are sensing and generation of multiple-wavelength filters.
  • PublicationOpen Access
    Generation of lossy mode resonances (LMR) using perovskite nanofilms
    (Chinese Academy of Sciences, 2024) Armas, Dayron; Matías Maestro, Ignacio; López-González, M. Carmen; Ruiz Zamarreño, Carlos; Zubiate Orzanco, Pablo; Del Villar, Ignacio; Romero, Beatriz; Ingeniería Eléctrica, Electrónica y de Comunicación; Institute of Smart Cities - ISC; Ingeniaritza Elektrikoa, Elektronikoaren eta Telekomunikazio Ingeniaritzaren
    The results presented here show for the first time the experimental demonstration of the fabrication of lossy mode resonance (LMR) devices based on perovskite coatings deposited on planar waveguides. Perovskite thin films have been obtained by means of the spin coating technique and their presence was confirmed by ellipsometry, scanning electron microscopy, and X-ray diffraction testing. The LMRs can be generated in a wide wavelength range and the experimental results agree with the theoretical simulations. Overall, this study highlights the potential of perovskite thin films for the development of novel LMR-based devices that can be used for environmental monitoring, industrial sensing, and gas detection, among other applications.