Buscar
Mostrando ítems 1-10 de 24
Development of a water flow and velocity optical fiber sensor for field testing
(Optica Publishing Group, 2022)
Contribución a congreso / Biltzarrerako ekarpena,
A water flow and velocity fiber optic sensor system was developed and tested. The sensing head was especially developed and ruggedized to measure velocities at different depths, in order to calculate the discharge in channels.
AI training for application to industrial robotics: trajectory generation for neural network tuning
(Springer, 2023)
Contribución a congreso / Biltzarrerako ekarpena,
In the present work robot trajectories are generated and kinematically simulated. Different data (joint coordinates, end effector position and orientation, images, etc.) are obtained in order to train a neural network ...
Techno-economic evaluation of the performance of an innovative rotary disk receiver concept in a CSP power plant
(AIP Publishing, 2022)
Contribución a congreso / Biltzarrerako ekarpena,
This study evaluates the thermal performance of an innovative discs receiver and models its effect in a CSP
plant. Energetic and economic results were compared with a foam receiver developed in the European project ...
Calculation of intercepted photosynthetically active radiation (IPAR) for traditional crops in Castilla y León, Spain
(Universidad Carlos III, 2022)
Contribución a congreso / Biltzarrerako ekarpena,
Agriculture is one of the most important economic activities in the Castilla y León region (Spain),
approximately one-third of the land area is destined for this use. The role of agriculture in rural areas
is essential ...
Estimation of the solar thermal power generation potential in Pamplona (northern Spain)
(Universidad Carlos III, 2022)
Contribución a congreso / Biltzarrerako ekarpena,
In this work, an analysis of the potential of the city of Pamplona to produce solar thermal
energy was carried out, according to the solar radiation received. As a result, for each
residential, industrial, or service ...
Monitoring the thermal potential of low-cost radiative cooling materials under static and dynamic conditions of exposure
(Morlacchi Editore University Press, 2023)
Contribución a congreso / Biltzarrerako ekarpena,
Reflecting the radiation of the sun while emitting thermal radiation to cold outer
space has proven to be an effective solution against urban overheating. The latter severely
impact the energy consumption of buildings, ...
Optimal strain gauge configurations for the estimation of mechanical loads in the main shaft of HAWT
(IOP Publishing, 2020)
info:eu-repo/semantics/conferenceObject,
In Structural Health Monitoring of wind turbines, measuring the mechanical loads is a key issue. The customary techniques for this task use a full-bridge strain gauge configuration to measure each of the six load components ...
Analysis of product shrinkage and waste in a potato bagging plant
(Dime University of Genoa, 2022)
Contribución a congreso / Biltzarrerako ekarpena,
Nowadays, an average of 2 kg of waste per person are generated in Spain. Furthermore, the household consumption is rising and, as a consequence, the waste production is also increasing. This trend presents a direct impact ...
Electrospinning technique as a powerful tool for the design of superhydrophobic surfaces
(IntechOpen, 2020)
Contribución a congreso / Biltzarrerako ekarpena,
The development of surface engineering techniques to tune-up the composition,
structure, and function of materials surfaces is a permanent challenge for the scientific
community. In this chapter, the electrospinning ...
Mechanical sensitivity analysis of strain gauge configurations in the main shaft of wind turbines
(IOP Publishing, 2022)
info:eu-repo/semantics/conferenceObject,
Wind turbines are reaching their remaining useful life, thus it is important to guarantee the well status of its components. A common way to check the status is to measure the loads on the Low Speed Shaft with strain gauges, ...