Buscar
Mostrando ítems 11-20 de 30
Optical fiber vacuum sensor based on modal interferometer and PDMS coating
(IEEE, 2019)
info:eu-repo/semantics/conferenceObject,
This work studies the behavior of polydimethylsiloxane (PDMS) as a transducer for optical vacuum pressure measurements. The optical structure chosen for this device is a modal interferometer achieved by splicing a coreless ...
Optimization in nanocoated D-shaped optical fiber sensors
(Optical Society of America, 2017)
Artículo / Artikulua,
Nanocoated D-shaped optical fibers have been proven as effective sensors. Here,
we show that the full width at half minimum (FWHM) of lossy mode resonance can be
reduced by optimizing the nanocoating width, thickness and ...
Giant sensitivity of optical fiber sensors by means of lossy moderesonance
(Elsevier, 2016)
Artículo / Artikulua,
Here we show an optical refractometer with a giant sensitivity of 304,360 nm per refractive index unit(nm/RIU). This sensitivity corresponds to a resolution of 3.28 × 10−9RIU if a standard optical spectrumanalyzer with a ...
Luminescence-based optical sensors fabricated by means of the layer-by-layer nano-assembly technique
(MDPI, 2017)
Artículo / Artikulua,
Luminescence-based sensing applications range from agriculture to biology, including
medicine and environmental care, which indicates the importance of this technique as a detection tool.
Luminescent optical sensors are ...
Humidity sensor based on silver nanopartlcles embedded in a polymeric coating
(Sciendo, 2012)
Artículo / Artikulua,
In this work, it is presented a novel optical fiber humidity sensor based on silver nanoparticle-loaded polymeric coatings built onto an optical fiber core. The polymeric film was fabricated using the Layer-by-Layer assembly ...
High sensitive and selective C-reactive protein detection by means of lossy mode resonance based optical fiber devices
(Elsevier, 2017)
Artículo / Artikulua,
This work presents the development of high sensitive, selective, fast and reusable C-reactive protein (CRP) aptasensors. This novel approach takes advantage of the utilization of high sensitive
refractometers based on ...
Tunable optical fiber pH sensors based on TE and TM Lossy Mode Resonances (LMRs)
(Elsevier, 2016)
Artículo / Artikulua,
In this paper, a high sensitivity optical fiber pH sensor based on lossy mode resonance (LMR) generated
with transversal electric (TE) and transversal magnetic (TM) polarized light is presented. Poly(allylamine
hydrochloride) ...
Fiber-based early diagnosis of venous thromboembolic disease by label-free D-dimer detection
(Elsevier, 2019)
info:eu-repo/semantics/article,
D-dimer is a useful diagnostic biomarker for deep vein thrombosis or pulmonary embolism, collectively referred to as venous thromboembolism (VTE). The ability to detect in real-time the amount of D-dimer with a fast and ...
Fabrication of Bragg gratings on the end facet of standard optical fibers by sputtering the same material
(IEEE, 2016)
Artículo / Artikulua,
A sputtering process has been applied to deposit quarter-wavelength stacks on the end facet of cleaved optical fibers by using only one sputtering target. Standard multimode optical fibers were used as substrates to fabricate ...
High sensitivity humidity sensor based on cladding-etched optical fiber and lossy mode resonances
(Elsevier, 2016)
Artículo / Artikulua,
In this work a high sensitivity optical fiber humidity sensor (OFHS) is presented. The configuration chosen for this purpose is a cladding-etched single mode optical fiber (CE-SMF) coated with a thin film of tin oxide ...