Ultra-low frequency multidirectional harvester for wind turbines
Fecha
2023Autor
Versión
Acceso abierto / Sarbide irekia
Tipo
Artículo / Artikulua
Versión
Versión publicada / Argitaratu den bertsioa
Identificador del proyecto
Impacto
|
10.1016/j.apenergy.2023.120715
Resumen
In this paper we propose, and demonstrate through a prototype, a completely novel device able to harvest mechanical energy from the multidirectional vibrations in a wind turbine, and convert it into electrical, to power autonomous sensors. The application is very challenging since vibrations are of ultra-low frequency, well below 1 Hz, with accelerations of tenths of cm/s2 (0.01 g), and the devic ...
[++]
In this paper we propose, and demonstrate through a prototype, a completely novel device able to harvest mechanical energy from the multidirectional vibrations in a wind turbine, and convert it into electrical, to power autonomous sensors. The application is very challenging since vibrations are of ultra-low frequency, well below 1 Hz, with accelerations of tenths of cm/s2 (0.01 g), and the device must capture energy from the movement in any direction. According to our experiments, the device is capable to generate average powers around the milliwatt in the operation conditions of a wind turbine, which are enough for some very-low power sensor nodes, or at least to considerably extend the life-time of batteries. The device is based on the principle of moving (inertial) masses comprised of magnets in Hallbach arrays interacting with coils, and can work for movements on any direction of a plane. To the best of our knowledge, this is the first device specifically proposed for wind turbines and one of the few that work in such low frequencies, and capture energy from movements on any direction on a plane. Only three harvesters proposed in the literature, intended for distinct applications, can work at such low frequencies, and our device exhibits a better efficiency. Though comparisons with harvesters working in different contexts and, even using different conversion principles, is not completely fair, we make in this paper a comparison to the closest ones, resorting to two different figures of merit. [--]
Materias
Energy harvesting,
Vibration-to-electrical energy conversion,
Electromagnetic transduction,
Ultra-low frequency,
Autonomous sensors,
Wind turbines
Editor
Elsevier
Publicado en
Applied Energy 334 (2023) 120715
Departamento
Universidad Pública de Navarra. Departamento de Ingeniería /
Nafarroako Unibertsitate Publikoa. Ingeniaritza Saila /
Universidad Pública de Navarra. Departamento de Ingeniería Eléctrica, Electrónica y de Comunicación /
Nafarroako Unibertsitate Publikoa. Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza Saila /
Universidad Pública de Navarra/Nafarroako Unibertsitate Publikoa. Institute of Smart Cities - ISC
Versión del editor
Entidades Financiadoras
This work has been supported by the Spanish Research Agency under grant AEI/FEDER, PID2019-107258RB-C32, and also by the Government of Navarre (Dpt. of Economic and Business Development) under grant 0011-1365-2021-000199. The open access of this paper has been funded by the Universidad Publica de Navarra.