Open Access
Generation of lossy mode resonances by deposition of high-refractive-index coatings on uncladded multimode optical fibers
(IOP Publishing Ltd, 2010) Del Villar, Ignacio; Ruiz Zamarreño, Carlos; Sánchez Zábal, Pedro; Hernáez Sáenz de Zaitigui, Miguel; Fernández Valdivielso, Carlos; Arregui San Martín, Francisco Javier; Matías Maestro, Ignacio; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
A comparative study of lossy mode resonances generated by depositing two different materials is presented. The two materials selected are indium tin oxide (ITO) and indium oxide. The two materials present different dielectric dispersion, which leads to the generation of single-peak lossy mode resonances with the ITO coated optical fibers and dual-peak lossy mode resonances with the In2O3 coated optical fibers. The obvious advantage of a dual-peak based measurement in the sensors field is enhanced by a sensitivity increase observed in sensors based on In2O3 if compared with those based on ITO. These characteristics are analyzed both theoretically and experimentally.
Open Access
Single-mode-multimode-single-mode and lossy mode resonance-based devices: a comparative study for sensing applications
(Springer-Verlag, 2015) Matías Maestro, Ignacio; Arregui San Martín, Francisco Javier; Corres Sanz, Jesús María; Del Villar, Ignacio; Hernáez Sáenz de Zaitigui, Miguel; Socorro Leránoz, Abián Bentor; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Institute of Smart Cities - ISC
Open Access
Quantum dots coatings inside photonic crystal fibers for temperature sensing
(IEEE, 2008-12-16) Arigita Lasheras, Jesús; Larrión Zabaleta, Beatriz; Bravo Larrea, Javier; Hernáez Sáenz de Zaitigui, Miguel; Matías Maestro, Ignacio; Arregui San Martín, Francisco Javier; Ingeniería Eléctrica, Electrónica y de Comunicación; Ingeniaritza Elektrikoa, Elektronikoa eta Telekomunikazio Ingeniaritza; Gobierno de Navarra / Nafarroako Gobernua
Temperature sensors based on Quantum Dots (QDs) nanofilms deposited on the inner holes of a Photonic Crystal Fiber (PCF) was created using the layer by layer electrostatic self-assembly method. The structure is based on a PCF fiber segment spliced between two Standard Multimode Fibers (MMF) of different diameters. The sensors showed a linear variation of the intensity and wavelength emission for a temperature range from -20 ºC to 70 ºC.
Open Access
Optical fiber resonance-based pH sensors using gold nanoparticles into polymeric layer-by-layer coatings
(Springer-Verlag, 2016) Arregui San Martín, Francisco Javier; Matías Maestro, Ignacio; Socorro Leránoz, Abián Bentor; Hernáez Sáenz de Zaitigui, Miguel; Goicoechea Fernández, Javier; Rivero Fuente, Pedro J.; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Ingeniería Mecánica, Energética y de Materiales; Mekanika, Energetika eta Materialen Ingeniaritza
Open Access
SnO2 based optical fiber refractometers
(SPIE, 2012) Sánchez Zábal, Pedro; Ruiz Zamarreño, Carlos; Hernáez Sáenz de Zaitigui, Miguel; Del Villar, Ignacio; Matías Maestro, Ignacio; Arregui San Martín, Francisco Javier; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Gobierno de Navarra / Nafarroako Gobernua
In this work, the fabrication and characterization of refractometers based on lossy mode resonances (LMR) is presented. Tin dioxide (SnO2) films deposited on optical fibers are used as the LMR supporting coatings. These resonances shift to the red as a function of the external refractive index, enabling the fabrication of robust and highly reproducible wavelength-based optical fiber refractometers. The obtained SnO2-based refractometer shows an average sensitivity of 7198 nm/refractive index unit (RIU) in the range 1.333-1.420 RIU.
Open Access
Sensors based on thin-film coated cladding removed multimode optical fiber and single-mode multimode single-mode fiber: a comparative study
(Hindawi Publishing Corporation, 2015) Del Villar, Ignacio; Socorro Leránoz, Abián Bentor; Hernáez Sáenz de Zaitigui, Miguel; Corres Sanz, Jesús María; Ruiz Zamarreño, Carlos; Sánchez Zábal, Pedro; Arregui San Martín, Francisco Javier; Matías Maestro, Ignacio; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
Two simple optical fibre structures that do not require the inscription of a grating, a cladding removed multimode optical fibre (CRMOF) and a single-mode multimode single-mode structure (SMS), are compared in terms of their adequateness for sensing once they are coated with thin-films.The thin-film deposited (TiO2/PSS) permits increasing the sensitivity to surrounding medium refractive index. The results obtained can be extrapolated to other fields such as biological or chemical sensing just by replacing the thin-film by a specific material.
Open Access
Generation of surface plasmon resonance and lossy mode resonance by thermal treatment of ITO thin-films
(Elsevier, 2014) Del Villar, Ignacio; Ruiz Zamarreño, Carlos; Hernáez Sáenz de Zaitigui, Miguel; Sánchez Zábal, Pedro; Arregui San Martín, Francisco Javier; Matías Maestro, Ignacio; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
Silicon wafers coated with IndiumTinOxide (ITO) by application of sputtering technique have been characterized after different post-annealing techniques, showing that this last factor is critical for the quality of the thin-film and for the creation and tuning of both surface plasmon resonances and lossy mode resonances. By adequate selection of the ITO thin-film thickness both resonances can be tracked in the same spectrum, which can be used in sensor and optical communications fields.
Open Access
Optical fiber sensors based on indium tin oxide surface plasmon resonance supporting coatings
(SPIE, 2009-10-05) Ruiz Zamarreño, Carlos; Hernáez Sáenz de Zaitigui, Miguel; Matías Maestro, Ignacio; Arregui San Martín, Francisco Javier; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
In this work, surface plasmon resonance (SPR) based optical fiber sensors are revisited by using a transparent conductive coating, Indium Tin Oxide in our case, as the SPR supporting layer. The utilization of these coatings shifts the plasmon resonance band to the infra-red region and allows the tunability of the SPR wavelength by adjusting the film fabrication parameters. Here, we study the fabrication process of these novel devices and characterize their response to variations in the refractive index of the external medium opening the door to a wide range of applications.
Open Access
Resonances in coated long period fiber gratings and cladding removed multimode optical fibers: a comparative study
(Optical Society of America, 2010) Del Villar, Ignacio; Ruiz Zamarreño, Carlos; Hernáez Sáenz de Zaitigui, Miguel; Arregui San Martín, Francisco Javier; Matías Maestro, Ignacio; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa
Two optical fiber devices have been coated in parallel: a long period fiber grating (LPFG) and a cladding-removed multimode optical fiber (CRMOF). The progressive coating of the LPFG by means of the layer-by-layer electrostatic-self-assembly, permits to observe a resonance wavelength shift of the attenuation bands in the transmission spectrum. The cause of this wavelength shift is the reorganization of the cladding mode effective indices. The cause of this modal reorganization can be understood with the results observed in the CRMOF coated in parallel. A lossy-moderesonance (LMR) is generated in the same wavelength range of the LPFG attenuation bands analyzed. Moreover, the thickness range where the wavelength shift of the LPFG attenuation bands occurs coincides exactly with the thickness range where the LMR can be visualized in the transmission spectrum. These phenomena are analyzed theoretically and corroborated experimentally. The advantages and disadvantages of both optical fiber devices are explained.
Open Access
Optical sensors based on lossy-mode resonances
(Elsevier Science, 2017) Matías Maestro, Ignacio; Ascorbe Muruzabal, Joaquín; Acha Morrás, Nerea de; López Torres, Diego; Zubiate Orzanco, Pablo; Sánchez Zábal, Pedro; Urrutia Azcona, Aitor; Socorro Leránoz, Abián Bentor; Rivero Fuente, Pedro J.; Hernáez Sáenz de Zaitigui, Miguel; Elosúa Aguado, César; Goicoechea Fernández, Javier; Bariáin Aisa, Cándido; Corres Sanz, Jesús María; Ruiz Zamarreño, Carlos; Arregui San Martín, Francisco Javier; Del Villar, Ignacio; Ingeniería Eléctrica y Electrónica; Ingeniaritza Elektrikoa eta Elektronikoa; Institute of Smart Cities - ISC